Question is ⇒ T-flip-flop is commonly used as, Options are ⇒ (A) a delay switch, (B) a digital counter only, (C) a digital counter and frequency divider, (D) any of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ T-flip-flop is commonly used as, Options are ⇒ (A) a delay switch, (B) a digital counter only, (C) a digital counter and frequency divider, (D) any of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	T-flip-flop is commonly used as
A.	a delay switch [Wrong Answer]
B.	a digital counter only [Wrong Answer]
C.	a digital counter and frequency divider [Correct Answer]
D.	any of the above [Wrong Answer]
View Answer 3 -6 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

Assertion (A): A composite video signal has synchronising pulses.

Reason (R): It is necessary to synchronise the scanning process in the transmitter and receiver.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Greatest mobility can be expected in case of
holes
protons
electrons
negative ions

⇒ The circuit shown in the figure is best described
bridge rectifier
ring modulator
frequency discriminator
voltage doubler

⇒ If Laplace transform of f(t) is F(s), then £ f(t - a) u (t - a)= 0
e^as F(s)
e^-as F(s)
- e^as F(s)
- e ^-as F(s)

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ A receiver having an RF amplifier and an IF of 450 kHz, has Q of the coils 65 and an incoming frequency of 1200 kHz. The image rejection of the receiver is
5870
3655
236
13.3

⇒

Match the following:

	List I (BJT amplifier)		List II (Characteristics)
A.	CE	1.	good voltage gain, good current gain
B.	CC	2.	voltage gain less than 1, high current gain
C.	CB	3.	current gain less than 1, voltage gain high

A-1, B-2, C-3
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ The characteristic equation of a feedback control system is given by s³ + 5s² + (K + 6)s + K
(- 3, 0)
(- 2, 0)
(- 1, 0)
(2, 0)

⇒ Coupling and bypass filters can be a source of
low-frequency parasitics
high-frequency parasitics
carrier frequency parasitics
none of the above

⇒ The signumm function written as [sgn(t)] is defined as
sgn(t) = - 1 for t < 0, = 0 for t = 0 and = 1 for t > 0
sgn(t) = 1 for t < 0, = 0 for t = 0 and = - 1 for t > 0
sgn(t) = 0 for t < 0, = 1 for t = 0 and = 0 for t > 0
sgn(t) = 0 for t < 0, = 1 for t³ 0

⇒ For a transistor the normal collector voltage is 12 V. If actually it is found to be + 28 V, the trouble could be
R_L is open
R_E is open
C_E is shorted
C_E is open

⇒ In any two port network, input impedance is independent of load impedance.
TRUE
FALSE

⇒ TTL XOR gate is very suitable as LCO driver.
TRUE
FALSE

⇒ Which of the following statement is false?
The gate of DMOSFET may be biased positively, zero or negatively
N-channel enhancement-only MOSFET conducts only when its gate is highly positive
JFET has lower input impedance than MOSFET
The bipolar base is forward biased, JFET gate must also be forward biased

⇒ In terms of ABCD parameters, the image parameter Z₁₁ is equal to
AC/BD
BD/AC
AB/CD
AD/BC

⇒ Direct and reflected sound waves may interfere with each other.
TRUE
FALSE