Question is ⇒ The function shown in the given Figure can be writte, Options are ⇒ (A) sum of two sinusoidal functions, (B) sum of two sinusoidal functions one originating at t = 0 and the other at t = 1, (C) difference of two sinusoidal functions one originating at t = 0 and the other at t = 1, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The function shown in the given Figure can be writte, Options are ⇒ (A) sum of two sinusoidal functions, (B) sum of two sinusoidal functions one originating at t = 0 and the other at t = 1, (C) difference of two sinusoidal functions one originating at t = 0 and the other at t = 1, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The function shown in the given Figure can be writte
A.	sum of two sinusoidal functions [Wrong Answer]
B.	sum of two sinusoidal functions one originating at t = 0 and the other at t = 1 [Wrong Answer]
C.	difference of two sinusoidal functions one originating at t = 0 and the other at t = 1 [Wrong Answer]
D.	none of the above [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In direct addressing mode of 8085
All instructions are 3 bytes long
All instructions are 3 bytes long except IN instruction which is 2 bytes long
All instructions are 3 bytes long except IN and OUT instructions which are 2 bytes long
All instructions are 2 bytes long

⇒ In the graphical analysis of CE amplifier circuit, the intersection of base current and dc load line is called
saturation point
cut off point
Q point
operating point

⇒ Consider the following statements about ultrasonic flow meters:

The measurement in insensitive to viscosity, pressure and temperature variations.
It has bidirectional measuring capability and can be used for any pipe size.
It has a relatively lower cost.
It has good accuracy, fast response and wide frequency range.

Which of the above statements is/are correct?
1 only
1 and 2 only
1, 2 and 4
3 and 4 only

⇒ For an amplifier the power gain in decibels will be equal to voltage gain in decibels only when
R₀ = 0
R₀ = R_i = 90
R₀ = R_i
R_i = 0

⇒ When a lead acid battery is fully charged the colours of its positive and negative plates are
grey and dark brown
dark grey and brown
grey and brown
dark brown and grey

⇒ Which of the following is best excited from a waveguide?
Discone
Helical
Biconical
Horn

⇒

Assertion (A): If integral control action is included in the controller the offset can be eliminated.

Reason (R): Integral control action may lead to oscillatory response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The integral of unit step function is a ramp of slope unity.
TRUE
FALSE

⇒ In high frequency region, an amplifier behaves like a
band pass filter
low pass filter
high pass filter
any of the above

⇒ In 8086
the registers SI and DI are used for string operation
the registers CS and DS are used for string operation
the registers SS and ES are used for string operation
the registers SI and SP are used for string operation

⇒ In a FM signal, the modulation index increases, then the power
increases
decreases
remains constant
none of the above

⇒ In figure, the short circuit current through terminal AB wil
0.125
1.5 A
0.0833333333333333
0.0416666666666667

⇒ The combination of registers in 8085 is B-C, D-E, H-L only.
TRUE
FALSE

⇒ Multiphase choppers are used in
low power circuits
high power circuit
both low and high power circuits
medium power circuits

⇒ Which one of the following gain equations is correct for a MOSFET common-source amplif
A_V = g_m/(1 - R_D)
A_V = g_m/R_D
A_V = g_m/(1 + R_D)
A_V = R_D/g_m

⇒ Consider the following statements about constants in 8085

The assembler treats 64 H as hexadecimal constant.
The assembler treats 154 as binary constant.
The assembler treats 540 as octal constant.
The assembler treats 138 as decimal constant.

Which of the above are correct?
1, 2 and 3 only
1, 3 and 4 only
1 and 3 only
2 and 4 only

⇒ Consider the following statements regarding an antenna:

It is a transducer
Its performance is essentially frequency sensitive
It is a reciprocal device
With increase in its effective aperture area, width of the radiated beam increases.

Which of the above statements are correct?
1, 2 and 3
1, 2 and 4
2 and 3 only
1 and 4 only

⇒ In 8085
the upper 8 address bits appear on address bus and lower 8 bits on address data bus
the lower 8 address bits appear on address bus and the upper 8 address bits appear on address data bus
either upper or lower 8 address bits may appear at address bus
either upper or lower 8 address bits may appear at address data bus

⇒ In a klystron amplifier dc electron velocity is v₀ and dc electron charge density is r₀ the dc beam current is
r₀v₀
r₀^/v₀
v₀^/r₀
(v₀^/r₀)²

⇒ Orbital disturbances of a geosynchronous satellite are caused by the
moon
sun
earth
all of the above

⇒ Self impedance is
same for transmitting (T_t) and receiving antenna (T_r)
T_t > T_r
T_r > T_t
no relation

⇒ Assuming accumulator contain A 64 and the carry is set (1).What will register A and (CY) contain after RAR?
4 DH, 0
D 3H, 0
4 DH, 1
53 H, 0

⇒ Due to which of the following reasons a lightning conductor on top of a building is made into a pointed spike?
Dust particles may not accumulate
Charge per unit area becomes very high for lightening to discharge
Rain drops may not collect
None of the above

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ For a paramagnetic material, susceptiblity increases with increasing temperature.
TRUE
FALSE

⇒ A 10 μF capacitor is charged from a 5 volt source through a resistance of 10 kΩ. The charging current offer 35 m sec. If the initial voltage on C is - 3 V is
0.56 mA
5.6 mA
6 mA
5 μA

⇒ BFO stands for
Beat Frequency Oscillator
Broad Frequency Oscillator
Blocking Frequency Oscillator
Ballistic Frequency Oscillator

⇒ Limiter is not essential in the following detector
foster-Seeley
ratio detector
balanced
none of the above

⇒

Assertion (A): Transient analysis uses Laplace transformation.

Reason (R): Laplace transform method is suitable for solution of integro differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ When a peripheral device is not ready for data transfer it will send to the microprocessor a
low READY bit
high READY bit
low or high READY bit depending on whether input or output is activated
none of the above