Question is ⇒ Frequency band used for radar is generally, Options are ⇒ (A) VLF, (B) VHF, (C) UHF, (D) EHF, (E) , Leave your comments or Download question paper.

Question is ⇒ Frequency band used for radar is generally, Options are ⇒ (A) VLF, (B) VHF, (C) UHF, (D) EHF, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Frequency band used for radar is generally
A.	VLF [Wrong Answer]
B.	VHF [Wrong Answer]
C.	UHF [Correct Answer]
D.	EHF [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figur
L₁ + L₂ + M
L₁ + L₂ - M
L₁ + L₂ + 2M
L₁ + L₂ - 2M

⇒ A 4 cm by 3 cm rectangular waveguide with air cavity, is operating at 12 GHz with TE₁₁ mode. The cut-off frequency is:
6.25 GHz
4.75 GHz
1.5 GHz
8.75 GHz

⇒ Which one of the following statements is wrong. The radar cross-section of a target?
depends on frequency
may be reduced by special coating of non-spherical target
depends on the aspect of target if it is non-spherical
is equal to actual cross-sectional area for small targets

⇒ The shot circuit admittance matrix of a two port network is
non-reciprocal and passive
non-reciprocal and active
reciprocal and passive
reciprocal and active

⇒ The ALU carrier out arithmetic and logic operations (OR AND, NOT, etc.) it processes
decimal numbers
binary numbers
hexadecimal numbers
octal numbers

⇒ Contents of RAM cannot be altered.
TRUE
FALSE

⇒ In figure as the load resistance is cha
the zener current remain constant
the load current remains constant
the output voltage remains constant
the output voltage and current through R remain constant

⇒ Which one of the following is a regulated power supply?
IC 555
IC 844
IC 3080
IC 723

⇒ A voltage tripler circuit uses
2 diodes and 2 capacitors
3 diodes and 3 capacitors
2 diodes and 3 capacitors
3 diodes and 2 capacitors

⇒

Assertion (A): The surge current which an SCR can withstand is much higher than rms on state current.

Reason (R): The duration of surge current is very small.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Match the following:

	List I (Instrument)		List II (Measured quantity)
A.	Hot wire	1.	only voltage
B.	PMMC	2.	phase
C.	Electrostatic	3.	true RMS value
D.	Lock in Amplifier	4.	dc value

A-3, B-2, C-1, D-4
A-1, B-4, C-2, D-3
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1

⇒ A system has poles at 0.01 Hz, 1 Hz and 80 Hz, zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is
-90°
0°
90°
-180°

⇒ MUF is highest in periods of greatest sunspot activity.
TRUE
FALSE

⇒ In a waveguide if TE mode exist for z direction propagation, then
E_z = 0, H_z ≠ 0
E_z = 0, H_z = 0
E_z ≠ 0, H_z = 0
E_z ≠ 0, H_z ≠ 0

⇒ Which of the following may result in instability problem?
Large error
High selectivity
High gain
Noise

⇒ For real and odd signals, the Fourier series coefficient a_k is __________ .
purely imaginary and even
purely real and even
purely imaginary and odd
purely real and odd

⇒ Consider the following stateme
1, 4 are correct
1 and 2 correct
1, 2, 3 are correct
2, 3, 4 are correct

⇒ Wired AND connection can be used in TTL with totem pole output.
TRUE
FALSE

⇒ In a 4-ary FSK, the frequencies are separated by f_s. Then they are
in phase
in phase opposition
orthogonal
none of the above

⇒ X(t) is a stationary process with the power spectral density S_x(f) > 0 for all f. The process is passed through a system shown be
S_y(f) > 0 for all f
S_y(f) = 0 for |f| > 1kHz
S_y(f) = 0 for f = nf₀, f₀ = 2kHz, n any integer
S_y(f) = 0 for f = (2n + 1)f₀ = 1 kHz, n any integer

⇒ A cycloconverter is a group of controlled rectifiers.
TRUE
FALSE

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ Out of the following memory types, one that is volatile is
ferrite-core
semiconductor RAM
semiconductor ROM
magnetic disc

⇒ In single phase half wave regulator, the average current over one full cycle
is always positive
may be positive or negative
may be negative
is always negative

⇒ In all metals
conductivity decreases with increase in temperature
current flow by electrons as well as by holes
resistivity decreases with increase in temperature
the gap between valence and conduction bands is small

⇒ If J, I and a denote current density, current and area of cross section of a conductor, then
J = Ia
J = I/a²
J = I/a
J = Ia²

⇒ Consider the following statements about mutual inductances:

The value should remain constant under all conditions.
The mutual inductance should not vary with temperature.
The inductance should be independent of excitation.
They have two coils wound on a bobbin of hard magnetic material, coils being separated by a range.

Out of the above, correct statement are
2, 3, 4
1, 2, 3
1, 3, 4
1, 2, 4

⇒ Turn on time of a transistor switch is equal to sum of (where t_r is rise time, t_d is delay time)
t_s - t_r
t_s - t_f
t_d + t_r
2t_r

⇒ Figure shows a parallel resonant circuit having resonance frequency of 15 MHZ. At this frequ
its impedance is minimum
its impedance is maximum
its impedance is infinite
its impedance is zero

⇒ A voltage V(t) is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt². If it is measured by a dc meter. The reading will be
0
4
2
2