Question is ⇒ Which of the following statement is false?, Options are ⇒ (A) Television signals are propagated as ground waves, (B) Surface waves can propagate on piezoelectric substrates, (C) The skip distance is the maximum distance upto which ionospheric reflection is possible, (D) Tropospheric scatter propagation is always subjects to fading, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following statement is false?, Options are ⇒ (A) Television signals are propagated as ground waves, (B) Surface waves can propagate on piezoelectric substrates, (C) The skip distance is the maximum distance upto which ionospheric reflection is possible, (D) Tropospheric scatter propagation is always subjects to fading, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following statement is false?
A.	Television signals are propagated as ground waves [Wrong Answer]
B.	Surface waves can propagate on piezoelectric substrates [Wrong Answer]
C.	The skip distance is the maximum distance upto which ionospheric reflection is possible [Correct Answer]
D.	Tropospheric scatter propagation is always subjects to fading [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure, I = 2A, then
5 V
3 V
2 V
1 V

⇒ In figure the phase
will be 90° at ω = 0 and 0° at ω = ∞
will be 0° at ω = 0 and 90° at ω = ∞
will be 45° at ω = 0 and 0° at ω = ∞
will be 45° at ω = 0 and 90° at ω = ∞

⇒

Assertion (A): In many materials, dielectric polarization causes mechanical distortion.

Reason (R): If dielectric polarization causes mechanical distortion then mechanical distortion must cause dielectric polarization.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A radiation thermometer is suitable for temperatures
below 500°C
below 100°C
above 500°C
above 1400°C

⇒ Reflex klystron oscillator is essentially a low power device
TRUE
FALSE

⇒ The number of key words in C is
4
8
16
32

⇒ Consider a parallel plate capacitor being charged. Identify the incorrect statements
Energy stored in the capacitor does not enter it through the connecting wires but through the space around the wires and plates uf capacitor
Rate at which energy flows into this volume is equal to the integration of the Poynting vector over the boundary of the volume between the plates.
The Poynting vector points everywhere radially outward of the volume between the plates
The Poynting vector points everywhere radially into the volume between the plates.

⇒ Four MSI TTL 4-bit ripple counters are cascaded to form a 16-bit binary counter. Its propagation delay is about __________ nanoseconds.
70
140
210
280

⇒ A microcomputer has a 64 K memory. What is the hexadecimal notation for the first memory location?
0
FFFF
0FFF
3FFF

⇒ The drift velocity of electrons is
very small as compared to speed of light
equal to speed of light
almost equal to speed of light
half the speed of light

⇒ The direction of force an a conductor carrying current and lying in a magnetic field can be found by using
Fleming's left hand rule
Fleming's right hand rule
Cork screw rule
Any of the above

⇒ Generally, the gain of a transistor amplifier falls at high frequency due to the
internal capacitance of the device
coupling capacitor at the I/P
skin effect
coupling capacitor at the O/P

⇒ The most commonly used system of modulating for telegraphy is
single tone modulation
on-off keying
frequency shift keying
pulse code modulation

⇒ A waveguide section in a microwave circuit acts as
LP filter
Bandpass filter
HP filter
Band stop filter

⇒ A voltage v = 5 + 50 sin ωt/ + 5 sin 5 &omegat is applied to a pure capacitor of capacitance 1 ωF. If f/= 314 rad/sec, current is
1 + 0.0157 cos 314 t + 0.00785 cos 1570 t
0.0157 cos 314 t + 0.00785 cos 1570 t
0.0157 sin 314 t + 0.00785 sin 1570 t
0.0157 sin (314 t / + 45°) + 0.00785 sin (1570 t + 45°)

⇒ The pole zero diagram of an impedance Z has a pole at s = - 6 and zero at s = - 4 as shown in figure the constant multiplier k = 1. For a signal I_s = cos 6t, the steady state voltage across Z is given in magnitude as u
0.6
0.84
7.2
none

⇒ 1011₂ x 101₂ = __________ ₁₀
55
45
35
25

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the deviation is
4.77 kHz
47.7 kHz
477 kHz
4770 kHz

⇒ In a rectangular waveguide if operating frequency is greater than cut off frequency then propagation constant is
purely real
purely imaginary
equal to unit
a complex number

⇒ If sequence y(n) = x(-n) then it is
Causal
Non-Causal
Depends on x(-n)
None

⇒ The discussing sharing of a communication satellite by many geographically dispersed Earth station, DAMA means
Demand-Assigned Multiple Access
Decibel Attenuated Microwave Access
Digital Analog Master Antenna
Dynamically-Assigned Multiple Access

⇒ At T = 0, the resistivity of a perfect single crystal of a metal is
0
low
high
finite

⇒ For an ac sinusoidal wave, the rms value is 10 A. For the same wave delayed by 60° in each half cycle, the rms value is likely to be
0.416666666666667
7.07 A
6.35 A
3.5 A

⇒ Saturation region of a JFET is also known as
source region
analog region
pinch off region
ohmic region

⇒ Consider an input x(t) as sh
-2 < t < 6
0 < t < 11
-2 < t < 5
2 < t < 6

⇒ Fourier transform of an external exponential e^jW0t
δ(f - f₀)
1
δ(f + f₀)
∞

⇒ For Bode plot of (1 + jωT) has
slope of 20 dB/decade and phase angle + tan^-1 (ωT)
slope of - 20 dB/decade and phase angle + tan^-1 (ωT)
slope of 20 dB/decade and phase angle - tan^-1 (ωT)
slope of - 40 dB/decade and phase angle - tan^-1(ωT)

⇒ The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6
1.2 kΩ
80 Ω
50 W
0

⇒ Gold is often diffused into silicon PN junction devices to
increase the recombination rate
reduce the recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ The rule that resistivity of conductors can be separated into two parts viz. temperature independent and temperature dependent is known as
Matthiessen's rule
Debye rule
Curie rule
Onne's rule