Question is ⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?, Options are ⇒ (A) 3 dB, (B) 4 dB, (C) 5 dB, (D) 6 dB, (E) , Leave your comments or Download question paper.

Question is ⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?, Options are ⇒ (A) 3 dB, (B) 4 dB, (C) 5 dB, (D) 6 dB, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?
A.	3 dB [Wrong Answer]
B.	4 dB [Wrong Answer]
C.	5 dB [Wrong Answer]
D.	6 dB [Correct Answer]
View Answer 3 -4 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 16-megabit dynamic random access memory (DRAM) is an integrated circuit capable of storing __________ characters (bytes).
1048567
16 x 1024 x 10⁶
16 x 10⁶
2.1 x lo⁶

⇒

Assertion (A): CRO can be used to study waveshape accurately.

Reason (R): Input impedance of a CRO is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Due to the formation of Schottky defects the density of the crystal
increases slightly
increases appreciably
decreases slightly
decreases appreciably

⇒ If memory chip size is 256 x 1 bits, the number of chips required to make 1 k byte memory is
8
12
24
32

⇒ The output of a Piezoelectric crystal has
low amplitude and low impedance
high amplitude and low impedance
low amplitude and high impedance
high amplitude and high impedance

⇒ Which of them radiates emission?
LED only
LCD only
Both LED and LCD
Neither LED nor LCD

⇒ A circuit using an op-amp is shown in the given figure. It
voltage series feedback
voltage shunt feedback
current shunt feedback
current series feedback

⇒ A 0.5 μF capacitor is connected across a 10 V battery. After a long time, the circuit current and voltage across capacitor will be
0.5 A and 0 V
0 A and 10 V
20 A and 5 V
0.05 A and 5 V

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5

⇒

Assertion (A): Atomic number of sodium is 11.

Reason (R): Sodium has a body centred cubic lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Ferrites are
hard materials
brittle materials
not easily machinable
materials with all above properties

⇒ In a series RLC circuit excited by e = E_m sin ωt is seen that LC < 1/ω². Then
I lags E
I leads E
I leads E are in phase
voltage across L and C are equal

⇒ A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
ω₁
less than ω₁
more than ω₁
either more than ω₁ or less then ω₁

⇒ In TV transmitter, visual exciter may consist of

Video processing unit
Visual modulator
VSB filter
Delay equaliser
Frequency converter

Which of the above are actually a part of visual exciter?
1, 2 and 3
2, 3 and 4
1, 2, 3 and 4
1, 2, 3, 4 and 5

⇒ For a class B amplifier using a supply of V_CC = 30 V and driving a load of 16 Ω the maximum efficiency will be __________ .
0.724
0.7854
0.624
0.6854

⇒ For satellite transmission, analog signals may be converted into digital form with the help of
modem
transponder
codec
compandor

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88W
7.3 W
73 W

⇒ A DIAC has two terminals, anode and cathode.
TRUE
FALSE

⇒ The maximum forward current in case of signal diode is in the range of
1 A to 10 A
0.1 A to 1 A
few milli amperes
few nano amperes

⇒ The no. of comparators required in a 3 bit comparator type ADC is
2
3
7
8

⇒ Television signals are propagated as ground waves.
TRUE
FALSE

⇒ Which of the following is invalid integer variable name in Fortran?
IAEG
I 124
AILG
MI AC

⇒ In the circuit shown in given figure, the values of i(0⁺) and I(∞), will be respecti
zero and 1.5 A
1.5 A and 3 A
3 A and zero
3 A and 1.5 A

⇒ In an integral controller
the output is proportional to input
the rate of change of output is proportional to input
the output is proportional to rate of change of input
none of the above

⇒ Foster Seeley discriminator uses a
double tuned circuit in which primary and secondary are tuned to different frequencies
double tuned circuit in which primary and secondary are tuned to same frequencies
single tuned circuit
three triodes in series

⇒ The V_s is give
8 V
13 V
1 V
4 V

⇒ If Y(s) = 1 + s, the network has
1 Ω resistor and 1 F capacitor in series
1 Ω resistor and 1 F capacitor in parallel
1 Ω resistor and 1 H inductor in series
1 Ω resistor and 1 H inductor in parallel

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ The voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit) is 25 volts. The maximum voltage on the reverse biased diode will be
100 V
50 V
25 V
12.5 V