Question is ⇒ Assertion (A): The small signal analysis of a transistor amplifier is done to obtain the current gain, voltage gain and the conversion efficiency of an amplifier.Reason (R): The small signal analysis of a transistor amplifier uses the small signal parameters of the transistor., Options are ⇒ (A) Both A and R are individually true and R is the correct explanation of A, (B) Both A and R are individually true but R is not the correct explanation of A, (C) A is true but R is false, (D) A is false but R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): The small signal analysis of a transistor amplifier is done to obtain the current gain, voltage gain and the conversion efficiency of an amplifier.Reason (R): The small signal analysis of a transistor amplifier uses the small signal parameters of the transistor., Options are ⇒ (A) Both A and R are individually true and R is the correct explanation of A, (B) Both A and R are individually true but R is not the correct explanation of A, (C) A is true but R is false, (D) A is false but R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): The small signal analysis of a transistor amplifier is done to obtain the current gain, voltage gain and the conversion efficiency of an amplifier. Reason (R): The small signal analysis of a transistor amplifier uses the small signal parameters of the transistor.
A.	Both A and R are individually true and R is the correct explanation of A [Wrong Answer]
B.	Both A and R are individually true but R is not the correct explanation of A [Wrong Answer]
C.	A is true but R is false [Wrong Answer]
D.	A is false but R is true [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
31 V
32 V
insufficient data
none of these

⇒ Integrated fin line can be utilized as a medium for constructing millimeter wave circuits.
TRUE
FALSE

⇒ In a two phase servomotor the voltages applied to the two stator windings
are equal in magnitude and are in phase
are unequal in magnitude but are in phase
are equal in magnitude but have a phase difference of 90°
are unequal in magnitude and have a phase difference of 90°

⇒

Match the following:

	List I (μP)		List II (Number of bits in register)
A.	8085	1.	32 bit
B.	8086	2.	16 bit
C.	68000	3.	8/16 bit

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-3, B-1, C-2

⇒ Eddy current loss is
proportional to frequency
independent of frequency
proportional to (frequency)²
proportional to (frequency)³

⇒ Saturation of iron core causes distortion.
TRUE
FALSE

⇒ Consider the following statements regarding negative feedback

It increases system gain
It improves sensitivity
It improves system stability

Which of these are not correct?
all
1, 2
1, 3
1 only

⇒ A vibration galvanometer is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ For the time domain response shown in figure the
lies in left half plane
lies on imaginary axis
lies along the positive real axis
may be complex or imaginary

⇒ In figure the output v(t)
phase modulated signal
amplitude modulated signal
frequency modulated signal
none of the above

⇒ The current wave of figure, is passed through a 3 H inductor during the period 0 to 2 sec
is 3 V
is 6 V
increases from 0 at t = 0 to 6 V at t = 2 seconds
increases from 0 at t = 0 to 6 V at t = 2 seconds and then decreases

⇒ In pulse transmitter the ratio of time on to time off is called
efficiency
duty cycle
base
bandwidth

⇒ For maximum output the width of air gap of audio head should be
equal to wavelength
half the wavelength
one quarter the wavelength
very small as compared to wavelength

⇒ For a single phase half wave converter feeding a resistive load, the firing angle a. The waveshape in below figure is
output voltage
input voltage
voltage drop across thyristor
none of the above

⇒ In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is
0
1
2
3

⇒ For matrix A, A^-1 A = 1
TRUE
FALSE

⇒ Calculate the directivity of an antenna for θ_E = 30°, θ_H = 60
46
23
50
100

⇒ Without a spectrum analyser, it is not possible to determine
carrier frequency
antenna pattern
pulse width
spurious signal strength and its location

⇒ The circuit in figure will act as ideal current source with respect to terminals A and B when frequenc
0
1 rad/sec
4 rad/sec
16 rad/sec

⇒ The O/P Power of a power amplifier is several times its input power. It is possible because
power amplifier introduces a -ve resistance
there is +ve feed back in the circuit
step up transformer is use in the circuit
power amplifier converts a part of I/P d.c. power into a.c. power

⇒ Which of these commutation methods uses two leads?
Class A
Class B
Class C
Class D

⇒ A vertical loop antenna, like a horizontal dipole, is vertically polarised.
TRUE
FALSE

⇒ The colour code on a carbon resistor is brown-black-red-gold. The value of resistance is
100 Ω
1000 Ω
1000 Ω ± 5%
1000 Ω ± 10%

⇒ In a rectangular waveguide cutoff wavelength for TE₁₀mode is 8 cm. Then cutoff wavelength for TE₂₀ mode is
8 cm
6 cm
4 cm
2 cm

⇒

Match the following:

	List I		List II
A.	True type	1.	Type of calculator in window
B.	FIND	2.	Window command
C.	WORD PAD	3.	Name of a Font
D.	STANDARD	4.	Has many features of a simple word processor

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-3, B-2, C-4, D-1

⇒ Consider the following mnemonics

MOV
ADD
LXI

Which of the above are valid for 8085?
1 and 2 only
1 only
1, 2 and 3
1 and 3 only

⇒ An electromagnetic wave can be completely guided by a dielectric rod or slab.
TRUE
FALSE

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	PIN diode	1.	Microwave amplification
B.	GaAs MOSFET	2.	Low noise microwave generation
C.	Transferred electron device	3.	Electronic tuning of MW oscillator
D.	Varactor diode	4.	Light wave detection

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ In operational Amplifier, Common mode voltage gain should be
0
∞
1
0.5

⇒ Which of the following refers to SSB suppressed carrier amplitude modulated system?
A3E
H3E
J3E
C3F