Question is ⇒ If RADIUS = 3.0 the result of the following FORTRAN 77 program will be <c, Options are ⇒ (A) 1.5708, (B) 1, (C) 28.2744, (D) 18, (E) , Leave your comments or Download question paper.

Question is ⇒ If RADIUS = 3.0 the result of the following FORTRAN 77 program will be <c, Options are ⇒ (A) 1.5708, (B) 1, (C) 28.2744, (D) 18, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If RADIUS = 3.0 the result of the following FORTRAN 77 program will be
A.	1.5708 [Correct Answer]
B.	1 [Wrong Answer]
C.	28.2744 [Wrong Answer]
D.	18 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ What will be equipotential surfaces for a pair of equal and opposite line charges?
Spheres
Concentric cylinders
Non-concentric cylinders
None of the above

⇒ Resistivity of carbon is around
10 to 70 m-ohm-cm
80 to 130 m-ohm-cm
800 to 1300 m-ohm-cm
8000 to 13000 m-ohm-cm

⇒ In calculating input impedance, the load impedance is considered to be connected at the output.
TRUE
FALSE

⇒ The moving iron instruments are generally repulsion type.
TRUE
FALSE

⇒ In colour TV receiver, varactor diode is used for
detection
rectification
tuning
both (a) and (b)

⇒ At absolute zero temperature a semiconductor behaves like
an insulator
a super conductor
a good conductor
a variable resistor

⇒ For the compensator in the given figure the maximum phase lea
sin^-1 (1/3)
30°
45°
60°

⇒ As compared to an ordinary semiconductor diode, a Schottky diode
has lower cut in voltage
has higher cut in voltage
lower reverse saturation current
both (b) and (c)

⇒ Short-circuited stubs are used, because open-circuited stubs are
liable to radiate
complex in nature
providing open-circuit environments
unable to provide work over large frequency range

⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.

⇒ AC hum is picked up from power cables
TRUE
FALSE

⇒

Assertion (A): A thermocouple transducer is based on Seeback effect.

Reason (R): In a thermocouple transducer used for temperature measurement, the cold junction is usually kept in ice bath.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which memory is available in all technologies?
PROM
EEPROM
ROM
EPROM

⇒ Which one of the following is a transferred electron device?
BARITT diode
IMPATT diode
TRAPATT diode
Gunn diode

⇒ The sum of two or more arbitrary sinusoidal is
always periodic
periodic under certain conditions
never periodic
periodic only if all the sinusoidals are identical in frequency and phase

⇒ A 3 bit binary adder should use
3 full adders
2 full adders and 1 half adder
1 full adder and 2 half adders
3 half adders

⇒ In a series RLC circuit, the value of resistance for critical damping is
L/C
(L/C)^0.5
1/LC
2/L/C

⇒ A 3 phase ac regulator uses
3 thyristors
6 thyristors
9 thyristors
12 thyristors

⇒ An average responding rectifier type electronic voltmeter has its scale calibrated in terms of rms value of sine wave. If 100 V peak value square wave is fed to this voltmeter, the reading will be
111 V
100 V
90.9 V
70.7 V

⇒ A system has high gain and phase margin. The system is
very stable
sluggish
very stable and sluggish
oscillatory

⇒ If f(t) ↔ F(jω), f(- t) ↔
- F(jω)
F(- jω)
F(jω)
0.5 F(jω)

⇒ The equation D = ∈₀∈_r E refers only to isotropic materials.
TRUE
FALSE

⇒ Low gain-bandwidth product of a JFET is due to
reduced number of holes
junction capacitive effects
low degree of isolation between input and output
all of the above

⇒ Computer ICs work reliably because
they are based on two state design
these are made from pure silicon
these are maintained at two temperatures
none of the above

⇒ When a particular mode is existed in a waveguide, there appears an extra electric component, in the direction of propagation. In what mode is the wave propagating?
Transverse electric
Transverse magnetic
Transverse electromagnetic
Longitudinal

⇒ Which one of following is correct for broadside array?
Direction of radiation is perpendicular to axis
Also perpendicular to the plane
Current is fed of equal amplitude equal phase
All

⇒ An 8 bit binary number is to be entered into an 8 bit serial shift register. The number of clock pulses required is
1
2
4
8

⇒ In a CE amplifier the input impedance is equal to the ratio of
ac base voltage to ac base current
ac base voltage to ac emitter current
ac emitter voltage to ac collector current
ac collector voltage to ac collector current

⇒ In LED the radiation is in
visible region
infrared region
both (a) and (b)
neither (a) nor (b)

⇒ Speeds of sound and radio waves are equal.
TRUE
FALSE