Question is ⇒ In the given circuit, the switch has been in position 1 for quite a long time. At <i>t</i> = 0 the switch is moved to position 2. At this position what is the time const, Options are ⇒ (A) 0.1 s, (B) 1 s, (C) 0.11 s, (D) 1.11 s, (E) , Leave your comments or Download question paper.

Question is ⇒ In the given circuit, the switch has been in position 1 for quite a long time. At <i>t</i> = 0 the switch is moved to position 2. At this position what is the time const, Options are ⇒ (A) 0.1 s, (B) 1 s, (C) 0.11 s, (D) 1.11 s, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given circuit, the switch has been in position 1 for quite a long time. At t = 0 the switch is moved to position 2. At this position what is the time const
A.	0.1 s [Correct Answer]
B.	1 s [Wrong Answer]
C.	0.11 s [Wrong Answer]
D.	1.11 s [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A uniform plane EM wave incident normally on a plane surface of a dielectric material is reflected with a VSWR of 3. What percentage of incident power that is reflected?
0.1
0.25
0.5
0.75

⇒ A Weston frequency meter is
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ Which TM mode in rectangular waveguide has lowest cutoff frequency?
TM₁₁
TM₀₁
TM₁₀
TM₂₁

⇒

Assertion (A): An electron having charge - e and mass m and lying in an electric field E is subjected to an acceleration - (e/m) E.

Reason (R): If there are n electrons/m³ moving with velocity v_x and each electron has a charge - e, the current density J = - n ev_x.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): A thermocouple transducer is based on Seeback effect.

Reason (R): In a thermocouple transducer used for temperature measurement, the cold junction is usually kept in ice bath.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a capacitor filter, the time constant R_LC should be small.
TRUE
FALSE

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒ A constant k low pass filter has f_c = 500 Hz. At f = 1000 Hz, the attenuation is
zero
infinity
may be zero or infinity
more than zero but less than infinity

⇒ In an idealized half wave rectified system the average and r.m.s. values of voltage are __________ respectively.
2V_m/p, V_m/2
V_m/p, V_m/2
V_m/p, V_m/2
V_m.p, V_m/2

⇒ Almost all high level languages have provision for logical operations.
TRUE
FALSE

⇒ The density of states (i.e. number of states per eV per m³) in the conduction band for energy level E is proportional to
E
E
E^1.5
E²

⇒ For a microprocessor system using IO-mapped IO the following statement is NOT true
memory space available is greater
not all data transfer instructions are available
IO and memory address spaces are distinct
IO address space is greater

⇒ A vibration galvanometer is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒

Assertion (A): At a temperature of 1000 K, thermionic emission current is about 0.1 A/cm² of surface.

Reason (R): Thermionic emission current is given by I_th = SA₀ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ If 4 quadrant operation is required we need
dual converter
full converter
semi converter
none of the above

⇒ A network N is dual of network N if
both of them have same mesh equation
both of them have same node equation
mesh equation of one are the node equations of the other
KCL and KVL equations are the same

⇒ Audio frequency range lies between
20 Hz and 20 kHz
20 kHz and 20 MHz
2 MHz and 20 MHz
20 MHz and 200 MHz

⇒ In which one of the following types of analog to digital convertors the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ In fabricating silicon BJT in ICs by the epitaxial process, the number of diffusions used is usually
2
3
4
6

⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.
TRUE
FALSE

⇒ As compared to TTL, CMOS logic has
higher speed of operation
higher power dissipation
smaller physical size
all of the above

⇒ Which of the following real expressions is incorrect in Pascal?
Y - X
(A + B) (C + D)
X / Y - Z
P * Z - 5.0

⇒ An RLC series circuit is underdamped. To make it overdamped, the value of R
has to be increased
has to be decreased
has to be increased to infinity
has to be reduced to zero

⇒ When a material becomes a superconductor, its resistivity becomes
very small
zero
about 10% of normal value
about 20% of normal value

⇒ PAM stands for
Phase Angle Modulation
Phase Amplitude Modulation
Pulse Amplitude Modulation
Pulse Angle Modulation

⇒ Which of the following is a passive component?
Semiconductor devices
Vacuum tube devices
Capacitors
All of the above

⇒ With negative feedback the closed loop gain is always less than open loop gain.
TRUE
FALSE

⇒ In a 3 phase semiconverter, the output voltage becomes discontinuous for
firing angle > 30°
firing angle > 60°
firing angle > 90°
firing angle > 120°

⇒ The mass of proton and electron are
1.672 x 10^-26 kg and 9.107 x 10^-31 kg respectively
9.107 x 10^-26 kg and 9.107 x 10^-31 kg respectively
9.107 x 10^-29 kg and 9.107 x 10^-31 kg respectively
9.107 x 10^-30 kg and 9.107 x 10^-31 kg respectively

⇒ The IF bandwidth of a radar receiver is inversely proportional to
pulse interval
pulse width
PRF
none of the above