Question is ⇒ 100101<sub>2</sub> is equal to decimal number, Options are ⇒ (A) 47, (B) 37, (C) 21, (D) 17, (E) , Leave your comments or Download question paper.

Question is ⇒ 100101<sub>2</sub> is equal to decimal number, Options are ⇒ (A) 47, (B) 37, (C) 21, (D) 17, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	100101₂ is equal to decimal number
A.	47 [Wrong Answer]
B.	37 [Correct Answer]
C.	21 [Wrong Answer]
D.	17 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
is forward biased
is reverse biased
may be forward biased or reverse biased
forward biased initially but reverse biased afterwards

⇒ In using KCL it is necessary that current leaving a node is written as negative.
TRUE
FALSE

⇒ Light dependent resistors are
highly doped semiconductor
intrinsic semiconductor
lightly doped semiconductor
either (a) or (c)

⇒ The effect of lead resistance is important in measurement of
resistance of shunt
resistance of shunt winding
resistance of ammeter
both (a) and (c)

⇒ If the number of ways an event may result ins analysed into m successes and n failures, each equally likely to occur, the probability of success in a single trial is m( m + n)
TRUE
FALSE

⇒ Consider the directive T : DS105. This directive
directs the assembler to reserve a sequence of 105 bytes in the memory
directs the assembler to reserve a sequence of 105 bits in the memory
directs the assembler to reserve a sequence of consecutive 105 bytes in the memory
directs the assembler to reserve a sequence of consecutive 105 bits in the memory

⇒ Reflectors and lens antennas are commonly used
in LF communication systems
not beyond 100 kHz
in the range 10 MHz to 100 MHz
above 100 MHz

⇒ A system is said to be static system, when present output depend upon
present I/P
presrent and past
present and future
past and future

⇒

Assertion (A): A decrease in temperature increases the reverse saturation current in a p-n diode.

Reason (R): When a diode is reverse biased surface leakage current flows.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which circuit has its output signal from, the emitter?
Common base
Common emitter
Emitter follower
None of the above

⇒ Television receiver antenna is usually
loop type
yagi antenna
parabolic dishes
none of the above

⇒ In ASCII, letter B is coded as
1000001
1000010
100100
1001000

⇒ The function of duplexer in a RADAR is
to permit the use of same antenna for transmission and reception
to provide gain to the transmitted power
to amplify the received signal
both (b) and (c)

⇒ If the average power of radar transmitters is 2 kW and the peak power of the transmitter is 1000 kW, what will be the duty cycle?
0.002
0.02
0.001
0.01

⇒ A series circuit has R = 5 Ω and C = 10 μF. At t = 0 it is switched on to a 10 V dc battery. The maximum current in the circuit is
0.0833333333333333
0.0416666666666667
10⁶A
10 μA

⇒ In telecast
video and audio signals are frequency modulated
video signals are frequency modulated but audio signals are amplitude modulated
both audio and video signals are amplitude modulated
video signals are amplitude modulated and audio signals are frequency modulated

⇒ Consider the following program for 8085OACH
53 H
OADH
54 H

⇒ In a rectangular waveguide
the broad width is generally labelled 'a' and height 'b'
the broad width is generally labelled 'b' and height 'a'
any one of the dimensions may be labelled 'a' and the other 'b'
the length is labelled as 'a'

⇒ Magnetic flux density has the dimensions
MI^-1T^-2
M^-1I^-2T^-2
ML^-3T^-2
MI^-1T^-3

⇒ The function of interface circuit is
to match output conditions of driver with input conditions of load device
to match output conditions of load device with input conditions of driver
both (a) and (b)
neither (a) nor (b)

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒ The scale of hot wire instrument is linear.
TRUE
FALSE

⇒ Vidicon and plumbicon operate on the principle of
photo conduction
photo emission
photo voltaic
none of the above

⇒ A balanced modulator circuit uses
two identical diodes with same V-I characteristics
two triodes with different V-I characteristics
two diodes with different V-I characteristics
a diode and a triode

⇒ For a full rectified sine wave, the form factor and peak factor respectively are
1.57 and 2
1.57 and 2
1.11 and 1.11
1.11 and 2

⇒ The current flow in a semiconductor is due to
holes
electrons
holes and electrons
holes, electrons and ions

⇒ In each of circuits below, indicate which diode is conduct
Figure A
Figure B
Figure C
All the three

⇒ In an hydrogen atom, an electron moves in the field of a proton. The stability of orbit requires equilibrium between coulomb's force and centrifugal force.
TRUE
FALSE

⇒ In a half wave rectifier, the load current flows
only for the positive half cycle of the input signal
only for the negative half cycle of the input signal
for full cycle
for less than fourth cycle

⇒ What is the effect of cut in voltage on the wave form of output as compared to input in a semiconductor diode?
The duration of output waveform is less than 180°
Output voltage is less than input voltage
Output voltage is more than input voltage
Both (a) and (b)