Question is ⇒ For a = - 1, find the value of V2</, Options are ⇒ (A) ∞, (B) 0, (C) V1, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ For a = - 1, find the value of V2</, Options are ⇒ (A) ∞, (B) 0, (C) V1, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a = - 1, find the value of V₂
A.	∞ [Wrong Answer]
B.	0 [Correct Answer]
C.	V₁ [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Beamwidth of an antenna depends upon
shape of radiation pattern
dimensions
wavelength
all of the above

⇒ For making a capacitor it is better to have a dielectric having
high permittivity
low permittivity
permittivity same as that of air
permittivity which is neither high nor low

⇒ After the death of INSAT-IB, the mainstay of the entire Indian satellite network for some time to come would be
INSTELSAT-V
INSAT-ID
INSAT-2
ARABSAT

⇒ The correct relation between joules and calories is
calories = joules/4.156
joules = calories/4.156
calories = joules x 10⁷/4.156
joules = calories x 10⁷/4.156

⇒ In the signal flow graph of figure, y/x equ
3
42857
2
None of the above

⇒ For a waveguide, which of the following statements is wrong?
It is usually made of brass or aluminium
It is usually rectangular or circular in shape
The dielectric region is usually air
The wall thickness is very small as compared to skin depth

⇒ If the intrinsic resistivity at 300°K is 0.37 ohm-m and the electron and hole mobilities at 300°K are 0.28 and 0.15 m²/volt-sec, then the intrinsic carrier concentration of Germanium is __________ .
2.92 x 10¹⁹/m³
2.92 x 10^-19/m³
1.92 x 10¹⁹/m³
3.92 x 10¹⁹/m³

⇒ For an npn transistor connected as shown in the figure V_BE = 0.7 volts. Given that reverse saturation current of the junction at room temperature 300K is 10^-13A, the emitter curr
30 mA
39 mA
49 mA
20 mA

⇒ An electromagnetic wave is incident normally on a dielectric boundary. It is
totally reflected
partially reflected and partially refracted
totally absorbed
none of the above

⇒ In a discharging R-L circuit voltage across the resistor exhibits
a linear rise
a linear decay
an exponential growth function
an exponential decay function

⇒ A direct current can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a standard resistance
by dc potentiometer in conjunction with volt ratio box
none of the above

⇒ For attenuation of low frequencies we should use
shunt capacitance
series capacitance
shunt inductance
series inductance

⇒ Two port network is said to be symmetrical if
Δ_h = 1
Z₁₁ = Z₂
A = Δ
all

⇒ X and Y are two random variable and Z = X + Y. Let σ_x², σ_y² and σ_z² be variance of X, Y and Z. Then
σ_z² = σ_x² + σ_y²
σ_z² ≤ σ_x² + σ_y²
σ_z² < σ_x² + σ_y²
σ_z² > σ_x² + σ_y²

⇒ In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be
0.6 T
more than 0.6 T
less than 0.6 T
0.6 T or less than 0.6 T

⇒ Microwave signals follow the curvature of the earth and the phenomenon
tropospheric scatter
faraday effect
duct propagation
none

⇒ In the equivalent circuit of a moving coil cone type loudspeaker, the mass of the moving system is represented by
a resistance
a capacitance
an inductance
a conductance

⇒ Flash ADC is
serial ADC
parallel ADC
series-parallel ADC
successive approximation ADC

⇒ Consider the circuit shown below of 2 : 1 MUX is given by the function g = ac + bc
X ⊕ Y
XY + EXY
XE + XY
none of these

⇒ In integral cycle control of ac regulator, the input power factor is equal to
duty cycle a
a²
a
(a)^1/3

⇒
Assertion (A): De sauty's bridge is suitable only for pure capacitor.
Reason (R): Capacitors are mostly perfect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The most commonly used bias in BJT amplifier circuits is
voltage divider bias
emitter bias
collector bias
collector feedback bias

⇒ In a superheterodyne receiver, having no RF amplifier, the IF is 455 kHz. The image frequency at 1000 kHz is
1455 kHz
545 kHz
1910 kHz
90 kHz

⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?
636 pF
180 pF
65 pF
30 pF

⇒ In a transistor I_E = 10 mA, I_CO = 0.5 μA and a = 0.995. Then I_CEO =
100 μA
25 μA
10.1 mA
10.5 mA

⇒ Each cell of static RAM contains
4 MOS transistors
4 MOS transistors and 1 capacitor
2 MOS transistors
4 MOS transistors and 2 capacitors

⇒ A thermistor is a
thermocouple
thermometer
miniature resistance
heat sensitive explosive

⇒
Assertion (A): If the duty cycle of chopper is low the current would not become discontinuous
Reason (R): If the time constant L/R of the load in chopper is low the current may become discontinuous.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For an ideal 3000 Hz channel, S/N ratio is
3
1.5
4
2

⇒ Which instrument needs creep compensation?
Dynamometer wattmeter
Induction wattmeter
Energy meter
Both (b) and (c)

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math