Question is ⇒ For the network in figure, which of the following expressions gives the value of net inductance between terminals A and B, Options are ⇒ (A) 1 only, (B) 1 and 2, (C) 3 and 4, (D) 2 and 4, (E) , Leave your comments or Download question paper.

Question is ⇒ For the network in figure, which of the following expressions gives the value of net inductance between terminals A and B, Options are ⇒ (A) 1 only, (B) 1 and 2, (C) 3 and 4, (D) 2 and 4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the network in figure, which of the following expressions gives the value of net inductance between terminals A and B
A.	1 only [Wrong Answer]
B.	1 and 2 [Correct Answer]
C.	3 and 4 [Wrong Answer]
D.	2 and 4 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Mouse is a very suitable input device for computers.
TRUE
FALSE

⇒ Which of the following elements act as donor impurities?

Gold
Phosphorus
Boron
Antimony
Arsenic
Indium

Select the correct answer using the codes given below:
1, 2, 3
1, 2, 4, 6
3, 4, 5, 6
1, 4, 5

⇒

Assertion (A): A higher level language is less efficient that machine language but more efficient than assembly language.

Reason (R): It is easier to learn and use higher level language than machine language.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In the given figure, the combinations of two non touching loop
1
2
3
4

⇒ The I/P impedance (Z_i) and the O/P impedance (Z_o) of an ideal trans conductance (Voltage controlled current source) amplifier are
Z_i = 0, Z_o = 0
Z_i = 0, Z_o = ∞
Z_i = ∞, Z_o = 0
Z_i = ∞, Z_o = ∞

⇒ The accuracy of measurement by ohmmeter is very good.
TRUE
FALSE

⇒ 1's complement of 11100110 is
11001
10000001
11010
0

⇒ A rectangular pulse train s(t) is shown in figure is convolved with the signal cos²(4p x 10³t). The convolved signal will
DC
12 kHZ sinusoidal
8 kHZ sinusoidal
14 kHZ sinusoidal

⇒ The minimum decimal equivalent of the number 11C0 is
183
194
268
269

⇒ Which addressing mode is suitable only for these instructions in which there is only one operand?
Implicit
Register
Direct
Immediate

⇒ For class B operation the theoretical maximum efficiency is
1
0.785
0.5
0.275

⇒ What is the chemical bonding in silicon semiconductor?
Metallic
Ionic
Covalent
van der Waals

⇒ A typical microcomputer has 65, 536 registers in its memory. It will be specified as
65.536 memory
65.536 K memory
64 K memory
8 K memory

⇒ The input to ALU are the contents of accumulator and temporary register.
TRUE
FALSE

⇒ For an amplifier, the coupling method which gives the highest gain in
impedance coupling
transformer coupling
capacitance coupling
resistance coupling

⇒ Binary storage of decimal number 44 in 8 bits is
101100
10101100
10101101
101101

⇒ Short-circuited stubs are preferred to open circuited stubs because the latter are
more difficult to make and connect
incapable of giving a full range of reactances
made of transmission line with a different characteristic impedance
liable to radiate

⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?
3 dB
4 dB
5 dB
6 dB

⇒ In a transistor CE mode, V_CC = +30 V. If the transistor is in cut off region, V_CE =
+30 V
+20 V
10 V
zero

⇒ In 2 out of 5 code, decimal number 8 is
11000
10100
11000
1010

⇒ CSSB stands for
Compatible Single Sideband
Compressed Single Sideband
Carrier Single Sideband
Coded Single Sideband

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. How much feedback should be used to provide the desired level?
0.0003
0.0033
0.013
0.033

⇒ 23.6₁₀ = __________ ₂
11111.1001
10111.1001
111.101
10111.1

⇒ To cover all inhabited regions of the Earth, the number of geosynchronous communication satellites required
5
3
10
2

⇒ In a half bridge inverter, the freewheeling diodes are needed
even when load is resistive
only when load is inductive
only when load is inductive or capacitive
for all types of loads

⇒ SSI refers to ICs with
less than 12 gates on the same chip
less than 8 gates on the same chip
less than 6 gates on the same chip
less than 3 gates on the same chip

⇒ The ASCII code is for information interchange by a binary code for
alphabet only
number only
alpha-numeric and other common symbols
none of these

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ A ground wave travels along surface of ground.
TRUE
FALSE

⇒ A 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V. It meets standard linearity then resolution in percent and volts.
3% 7 V
6.4 V, 2%
0.1%, 1.57 V
1.57%, 0.1 V