Question is ⇒ A rectangular pulse train <i>s</i>(<i>t</i>) is shown in figure is convolved with the signal cos<sup>2</sup>(4<span class="symbol">p</span> x 10<sup>3</sup><i>t</i>). The convolved signal will, Options are ⇒ (A) DC, (B) 12 kHZ sinusoidal, (C) 8 kHZ sinusoidal, (D) 14 kHZ sinusoidal, (E) , Leave your comments or Download question paper.

Question is ⇒ A rectangular pulse train <i>s</i>(<i>t</i>) is shown in figure is convolved with the signal cos<sup>2</sup>(4<span class="symbol">p</span> x 10<sup>3</sup><i>t</i>). The convolved signal will, Options are ⇒ (A) DC, (B) 12 kHZ sinusoidal, (C) 8 kHZ sinusoidal, (D) 14 kHZ sinusoidal, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A rectangular pulse train s(t) is shown in figure is convolved with the signal cos²(4p x 10³t). The convolved signal will
A.	DC [Wrong Answer]
B.	12 kHZ sinusoidal [Wrong Answer]
C.	8 kHZ sinusoidal [Wrong Answer]
D.	14 kHZ sinusoidal [Correct Answer]
View Answer 1 -4 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

Match the following:

	List I (Camera pick up tubes)		List II (Developed by)
A.	CCD charger	1.	Toshiba
B.	New vicon	2.	Philips
C.	Plumbicon	3.	Matushita
D.	Chalnicon	4.	RCA

A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-1, B-2, C-3, D-4

⇒ It is required to increase the maximum range of a radar by a factor of two. The peak power transmitted in the radar system has to be increased by a factor of
2
4
8
16

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ In a RL circuit, the angle, θ by which the current lags the voltage is
0 > θ > - 90°
90°
0°
0 < θ < 90°

⇒ In an RC phase shift oscillator, the total phase shift of the three RC lead networks is
360°
180°
90°
0°

⇒ In a dynamometer instrument, the moving coil is pressure coil.
TRUE
FALSE

⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the half power beamwidth
4°
2°
10°
15°

⇒ When we use RRC instruction once in 8085, the number is
multiplied by 2
divided by 2
multiplied by 4
divided by 4

⇒ The response of a thermistor overs the whole of its temperatures range is
linear
non-linear
almost linear
either (a) or (c)

⇒ The gate electrode in the FET corresponds to the
collector in a bipolar transistor
base in a bipolar transistor
emitter in a bipolar transistor
none of the above

⇒ The following circuit is implementation of

Sum of full adder

Carry of half adder

Difference of full subtractor

<
(i) only
(iii) only
(ii) only
(i) and (ii)

⇒ The frequency tolerance for the RF carrier in the standard AM radio broadcast band is
zero
+20 Hz
+1000 Hz
+25 Hz

⇒ A silicon (PN) junction at a temperature of 20°C has a reverse saturation current of 10 pico Ampere. The reverse saturation current at 40°C for the same bias is approximately.
30 pA
40 pA
50 pA
60 pA

⇒ For a half wave rectified voltage, the form factor and peak factor respectively are
1.11 and 2
1.57 and 2
1.11 and 1.11
1.57 and 2

⇒ FM broadcast is used in
VHP range
UHF range
MF range
both VHP and UHF range

⇒ The O/P Power of a power amplifier is several times its input power. It is possible because
power amplifier introduces a -ve resistance
there is +ve feed back in the circuit
step up transformer is use in the circuit
power amplifier converts a part of I/P d.c. power into a.c. power

⇒ Determine the voltage V_CB in the circuit bel
3.4 V
5.4 V
7.4 V
9.4 V

⇒ The first geostationary satellite was named
Intelsat I
Intelsat II
Intelsat III
Early bird

Assertion (A): Class A and Class B amplifier predominate in audio applications.

Reason (R): Class C amplifier is used at radio frequencies.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ AM amplifier having noise figure of 20 dB and available power gain of 15 dB is followed by a mixer circuit having noise figure of 9 dB. The overall noise figure as referred to input in dB is
10.44
11.07
21.52
0.63

⇒ In Fortran 77 negation is a unary operation.
TRUE
FALSE

⇒ In all pure metals, temperature coefficient of resistance is positive.
TRUE
FALSE

⇒ In radar PRF depends on maximum range.
TRUE
FALSE

⇒ For stable network the real parts of poles and zeros of driving point functions must be
negative
negative or zero
zero
positive

⇒ Which one of the following is not a useful quantity for comparing the noise performance of receivers?
Noise figure
Noise temperature
Input noise voltage
Equivalent noise resistance

⇒ If too large current passes through the diode
all electrons will leave
all holes will freeze
excessive heat may damage the diode
diode will emit light

⇒ Unit step is a
energy signal
power signal
neither energy nor power signal
none

⇒ The number of valence electrons in pentavalent impurity is
5
4
3
1

⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
31 V
32 V
insufficient data
none of these

⇒ Consider two random processes x(t) and y(t) have zero mean, and they are individually stationary. The random process is z(t) = x(t) + y(t). Now when stationary processes are uncorrelated then power spectral density of z(t) is given by
S_x(f) + S_y(f) + 2S_xy(f)
S_x(f) + S_y(f) + 2S_xy(f) + 2S_yx(f)
S_x(f) + S_y(f)
S_x(f) + S_y(f) - 2S_xy(f) - 2S_yx(f)