Question is ⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is, Options are ⇒ (A) 25, (B) 50, (C) 100, (D) 200, (E) , Leave your comments or Download question paper.

Question is ⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is, Options are ⇒ (A) 25, (B) 50, (C) 100, (D) 200, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
A.	25 [Wrong Answer]
B.	50 [Correct Answer]
C.	100 [Wrong Answer]
D.	200 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A meter with a resistance of 100 Ω and a full scale deflection of current of 1 mA is to be converted into voltmeter of 0 - 5 V range. The multiplier resistance should be
490 Ω
5000 Ω
4900 Ω
5100 Ω

⇒ In TE₁₀ mode of rectangular waveguide
there is one half sine wave variation along x direction and one along y direction
there is one half sine wave variation along y direction and one along x direction
there is one full sine wave variation along x direction and one along y direction
none of the above

⇒ Which of the following can be accessed only sequentially?
Floppy disk
Hard disk
Magnetic tape
ROM

⇒ Consider the following statements

In a pulsed radar, the transmitted pulses are of high frequency
In a pulsed radar, the transmitted pulses are of high power
In a pulsed radar, the transmitted pulses are of brief duration
In a pulsed radar, the transmitted pulses are of square wave shape.

Of the above statements the correct statements are
1 only
1, 2 and 3 only
1, 2, 3, 4
1 and 3 only

⇒ Analysis of EM wave in waveguide based on
circuit theory
field theory
optical theory
both (a) and (b)

⇒ Image frequency rejection mainly depends upon
detector
mixer
IF
RF

⇒ Which of the following is true?
SOP is a two level logic
POS is a two level logic
Both SOP and POS are two level logic
Hybrid function is two level logic

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ In the circuit of the given figure, V_{05 V
3.1 V
2.5 V
0}

⇒ A cycloconverter for single phase operation has
one positive group and one negative group converters
two positive group and two negative group converters
three positive group and three negative group converters
any of the above

⇒ The relational operators allowed in Pascal are
=, >, <, > =, < = and < >
=, >, < and < >
=, >, <, > = and < =
>, <, > = and < =

⇒ Consider the following instruction of 8085 μp :

MOV M, A
AODC
MVI A, FF
CMP M

Which of these cause change in the status of flag(s)?
1 and 2
1, 2 and 3
3 and 4
2 and 4

⇒ Figure represen
NPN transistor
PNP transistor
Zener diode
Power diode

⇒ The chemical effect of current is used in
dc ampere hour meter
dc ammeter
ac energy meter
all of the above

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	PIN diode	1.	Microwave amplification
B.	GaAs MOSFET	2.	Low noise microwave generation
C.	Transferred electron device	3.	Electronic tuning of MW oscillator
D.	Varactor diode	4.	Light wave detection

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ High purity copper is obtained by
rolling casting
casting
electrolytic refining
induction heating

⇒ The sensitivity of a superheterodyne receiver is determined by
the gain IF amplifier
the gain of RF amplifier
the noise figure
all of the above

⇒ If the secondary burden of a CT 15 VA and secondary current is 5 A, the load impedance of CT is
0.6 Ω
5 Ω
6 Ω
10 Ω

⇒ The switch in the circuit shown was on position a for a long time, and is moved to position b at time t = 0. The current i(t) for t > 0 is give
0.2e^-125tu(t) mA
20e^-1250tu(t) mA
0.2e^-1250tu(t) mA
20e^-1000tu(t) mA

⇒ In figure, D₁ turns on
v_i is more than V₁
v_i is less than V₁
v_i is between V₁ and V₂
none of the above

⇒ The direction of rotation of a CD is
clockwise
anticlockwise
clockwise or anticlockwise depending on frequency of data stored
mostly anticlockwise but some times clockwise

⇒

Match the following:

	List I (Types of N-bit ADC)		List II (Characteristics)
A.	Flash converter	1.	Integrating Type
B.	Successive	2.	Fastest converter approximation
C.	Counter ramp	3.	Maximum conversion time = N bits
D.	Dual slow	4.	Used a DAC in its feedback path

A-2, B-3, C-4, D-1
A-1, B-3, C-4, D-2
A-2, B-4, C-3, D-1
A-1, B-4, C-3, D-2

⇒ A medium is said to be isotropic when
∈ = 0
∈ = μ
∈ = σ
∈ is scalar constant

⇒ Which one of the following bipolar transistors has the highest current gain bandwidth Product (f_r) for similar geometry?
NPN germanium transistor
NPN silicon transistor
PNP germanium transistor
PNP silicon transistor

⇒ Which of the following 8 bit microprocessors has maximum addressing modes?
8085
Z 80
6800
6809

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ In a 3 phase full wave regulator feeding a star connected resistance load, firing angle is 75°. Then the number of thyristors conducting at one time is
1
2
3
4

⇒ A 0-150 voltmeter has a guaranteed accuracy of 1% of full scale reading. If actual reading is 83 V, the percentage error is
0.0083
0.01
0.0181
none of the above

⇒ Calculate the stability factor and change in I_C from 25°C to 100°C for, β = 50, R_B/ R_E = 250, ΔI_C0 = 19.9 nA for emitter bias configuration.
42.53, 0.85 μA
40.91, 0.58 μA
40.91, 0.58 μA
41.10, 0.39 μA

⇒

Assertion (A): A high dv/dt may cause triggering of a thyristor.

Reason (R): A high dv/dt results in charging current in the thyristor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct