Question is ⇒ For good quality signal transmission all frequency components should have the same transmission delay, td and same phase shift-Φs. What can be said about the statement?, Options are ⇒ (A) Correct, (B) True from td but not for Φs, (C) Not true for td but true for Φs, (D) Both td and Φs are not involved in quality, (E) , Leave your comments or Download question paper.

Question is ⇒ For good quality signal transmission all frequency components should have the same transmission delay, td and same phase shift-Φs. What can be said about the statement?, Options are ⇒ (A) Correct, (B) True from td but not for Φs, (C) Not true for td but true for Φs, (D) Both td and Φs are not involved in quality, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For good quality signal transmission all frequency components should have the same transmission delay, t_d and same phase shift-Φ_s. What can be said about the statement?
A.	Correct [Wrong Answer]
B.	True from t_d but not for Φs [Wrong Answer]
C.	Not true for t_d but true for Φ_s [Wrong Answer]
D.	Both t_d and Φ_s are not involved in quality [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The input to integrating op-amp is a rectangular wave. The output will be
a sine wave
a rectangular wave
a triangular wave
none of the above

⇒

Assertion (A): The condition of minimum distortion in a transmission line is L = RC/G.

Reason (R): Line loading means addition of inductance to satisfy the condition L = RC/G.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If N bits are lumped together to get an N-bit symbol, the possible number of symbols is
2^N
2^{N - 1}
2^{N - 2}
2^{N - 4}

⇒ A parallel plate capacitor has its length, width and separation doubled. It fringing effects are neglected, to keep the capacitance same, the dielectric constant must be
halved
kept the same
doubled
made 4 times

⇒ The noise figure of klystron amplifier is about
25 dB
3 dB
zero
1 dB

⇒ If J, I and a denote current density, current and area of cross section of a conductor, then
J = Ia
J = I/a²
J = I/a
J = Ia²

⇒ ALU processes
decimal numbers
binary numbers
hexadecimal numbers
all of the above

⇒ Let JCOKE = 20 and LPEPSI =15. Consider the statement 25
23
15
17

⇒ Which one is true for writing array variable in Pascal?
The general form of an array variable is an integer or a real variable name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The general form of an array variable must be an integer name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The subscripts in array variable must be separated by dots
The subscripts must be enclosed within parenthesis

⇒ In a rectangular waveguide
the broad width is generally labelled 'a' and height 'b'
the broad width is generally labelled 'b' and height 'a'
any one of the dimensions may be labelled 'a' and the other 'b'
the length is labelled as 'a'

⇒ A radio station works at 800 kHz and uses AM. If this is a public broadcast system, it should transmit using
parabolic reflector to transmit all round
turnstile antenna for the required land
half wave long horizontal wave
a vertical antenna less than quarter for practical reasons

⇒ Resistivity of rubber is about
10² Ω-m
10^-2 Ω-m
5 x 10⁸ Ω m
5 x 10¹² Ω-m

⇒ Since noise phase modulated FM wave, as the noise sideband frequency approaches the carrier frequency, the noise amplitude
is equalized
is increased
is decreased
remains constant

⇒ If the op-amp in figure has a unity gain frequency of 1 MHz, the cut off frequenc
100 kHz
1 MHz
10 MHz
90 MHz

⇒ 3N 200 is a
semi-conductor diode
P-N-P transistor
dual gate MOSFET
UJT

⇒ A wire has a diameter d and resistance R. If the diameter is made 3d, the length and material remaining the same, the new value of resistance will be
R/3
3 R
R/9
9 R

⇒ A series resonant circuit has parameters 10 ω, 1 H and 0.1 F. It is excited by a voltage v = 100 sin ωt. At resonant frequency, the power dissipated in the circuit is
1000 W
707 W
500 W
414.14 W

⇒ The time needed by a TTL circuit to switch from 0 to 1 or 1 to 0 is about
10 μs
10 ns
100 μs
50 ns

⇒ For an RC admittance function
the lowest critical frequency is a zero
the highest critical frequency is a pole
the lowest critical frequency is zero and the highest critical frequency is a pole
the lowest critical frequency is a pole

⇒ In the assembler, which one of the following is required for variable name in symbol table?
Addresses
Values
Registers
Storage

⇒ If B_max is the maximum flux density, hysteresis loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ The output impedance of an ideal op-amp is
zero
low
high
infinite

⇒ For full wave rectification four diode bridge rectifier is claimed to have following advantages:

Less expensive transformer
Small size transformer
Suitable for higher voltage applications

Which of these are correct?
1 and 2 only
1 and 3 only
2 and 2 only
1, 2, 3

⇒ L/C has the dimension of
time
capacitance
inductance
resistance

⇒ In which of the following semiconductor are holes minority carriers
extrinsic
p type
n type
intrinsic

⇒ PCM employing 4 bit code is used to send data having frequency range from 0 to 2 kHz. The minimum required bandwidth of carrier channel is
2 kHz
4 kHz
8 kHz
16 kHz

⇒ In active filters inductances are divided because they
are always associated with same resistance
are bulky and unsuitable for miniaturization
are non linear
saturate quickly

⇒ Consider the instructions

MOV M, B
OUT 4
LDAX

Which of the above require memory write cycle?
1, 2, 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days

⇒

Assertion (A): The forward resistance of a p-n diode is not constant.

Reason (R): The v-i characteristics of p-n diode is non-linear.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true