Question is ⇒ The two pressure coils in a single phase power factor meter of turns, Options are ⇒ (A) the same dimension and the same numbers of turns, (B) the same dimension but different number of turns, (C) different dimension and different numbers of turns, (D) different dimension but the same numbers of turns, (E) , Leave your comments or Download question paper.

Question is ⇒ The two pressure coils in a single phase power factor meter of turns, Options are ⇒ (A) the same dimension and the same numbers of turns, (B) the same dimension but different number of turns, (C) different dimension and different numbers of turns, (D) different dimension but the same numbers of turns, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The two pressure coils in a single phase power factor meter of turns
A.	the same dimension and the same numbers of turns [Correct Answer]
B.	the same dimension but different number of turns [Wrong Answer]
C.	different dimension and different numbers of turns [Wrong Answer]
D.	different dimension but the same numbers of turns [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a line VSWR of a load is 6 dB. The reflection coefficient will be
0.033
0.33
0.66
3.3

⇒ Higher order active filters are used for variable
bandwidth
gain in the pass band
impedance
roll off rate

⇒ The integral of k δ(t) is
a step function of magnitude k
a step function 'of magnitude 1/k
a ramp of slope k
a ramp of slope 1/k

⇒ In the circuit shown in the figure the power dissipated in 30 Ω resistor will be maximum if the value of
30 Ω
10 Ω
9 Ω
zero

⇒ An npn transistor has a Beta cutoff frequency f_β of 1 MHz, and a common emitter short circuit low frequency current gain β₀ of 200. It unity gain frequency f_T and the alpha cut off frequency f_a2 respectively are
200 MHz, 201 MHz
200 MHz, 199 MHz
199 MHz, 200 MHz
201 MHz, 200 MHz

⇒ A padder is basically a/an
insulator
variable resistor
capacitor
inductor

⇒ Let f(A, B) = A ⊕ B; then the simplified form of the function f(f(x ⊕ y, z)w) is
(x ⊕ y ⊕ z)w
x ⊕ y ⊕ z ⊕ w
(x ⊕ y ⊕ z) + w
none of these

⇒ The addition of a pole to the open loop transfer function pulls the root locus
to the right
to the left and making the system more stable
towards right or left depending on the position of new pole
none of the above

⇒ The ASCII code is
5-bit code
7-bit code
9-bit code
11-bit code

⇒ In microstrip line has dielectric material most commonly used is
silicon
rubber
plastic
bakelite

⇒ Low gain-bandwidth product of a JFET is due to
reduced number of holes
junction capacitive effects
low degree of isolation between input and output
all of the above

⇒ The ac collector current is nearly equal to
ac base current
ac signal current
ac supply current
ac emitter current

⇒ In a rectangular waveguide there is one half wave variation of electric field across the narrow dimension and two half wave variations of electric field across wider dimension. The dominant mode is
TM₁₂
TE₁₃
TE₂₁
TM₂₅

⇒ In the circuit shown, the device connected to Y5 can have address in the r
2000 - 20FF
2D00 - 2DFF
2E00 - 2EFF
FD00 - FDFF

⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti
0.02 V/μsec, 1.59 KHz
0.04 V/μsec, 1.59 KHz
0.02 V/μsec, 3.58 KHz
0.02 V/μsec, 1.59 KHz

⇒ Dielectric constant, under the condition of alternating fields, is a complex quantity.
TRUE
FALSE

⇒ Read the following rules for scanning Boolean expressions in Pascal

The expressions are scanned from left to right.
The operations are scanned in the order NOT, AND, OR.
All operators (i.e., NOT, AND and OR) are scanned together.
In one scanning all the operators of only one type are scanned.

Which of the above are correct?
All
1, 2 and 3 only
1, 2 and 4 only
2, 3 and 4 only

⇒ In 8085 microprocessor, which of the following interrupts is unmaskable interrupts?
RST 5.5
RST 7.5
TRAP
INTR

⇒ As frequency is increased, the skin effect
increases
decreases
remains the same
either (b) or (c)

⇒ In open circuit impedance parameters, the independent variables are
I₁ and I₂
V₁ and V₂
V₁ and I₁
V₂ and I₂

⇒ One of the following can be used to generate a pulse whenever triggered
flip-flop
monostable multivibrator
stable multivibrator
Schmitt trigger

⇒ Coupling and bypass filters can be a source of
low-frequency parasitics
high-frequency parasitics
carrier frequency parasitics
none of the above

⇒ In the signal flow graph in the given figure the number of forward paths and pairs of non-touching loops are respecti
3 and 1
3 and 2
4 and 2
2 and 4

⇒ Directive gain is
a power ratio
a voltage ratio
a current ratio
a distance ratio

⇒ During processing the instructions, data, intermediate results and final results in a computer are held in
CPU
ALU
Primary memory
Secondary memory

⇒ Which of the following is the point of reference JFET?
Drain
Gate
Source
None of the above

⇒ The overall noise temperature T_e, absolute temperature T and noise figure F are related as
T_e = T(F - 1)
T_e = F(T - 1)
T = T_e(F - 1)
T_e = (T)(F)

⇒ A dc voltage source is connected across a series RLC circuit, Under steady state conditions, the applied dc voltage drops entirely across the
R only
C only
L only
R and L

⇒ What would be the reading of voltmeter as shown in below figure. The voltmeter has a 0-1 V scale and is a 20000 Ω/V me
0.4545 V
0.082 V
0.82 V
4.54 V

⇒ In following figure, the initial contents of the 4-bit serial in parallel out, right shift, shift register as shown in figure are 0110. After 3 clock pulses the contents of the shift register wil
0
101
1010
1110