Question is ⇒ In an inverting amplifier using op-amp the current input to the inverting terminal, Options are ⇒ (A) is equal to the current through feedback resistance, (B) is less than the current through feedback resistance, (C) is more than the current through feedback resistance, (D) may be equal to, less or more than current through feedback resistance, (E) , Leave your comments or Download question paper.

Question is ⇒ In an inverting amplifier using op-amp the current input to the inverting terminal, Options are ⇒ (A) is equal to the current through feedback resistance, (B) is less than the current through feedback resistance, (C) is more than the current through feedback resistance, (D) may be equal to, less or more than current through feedback resistance, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an inverting amplifier using op-amp the current input to the inverting terminal
A.	is equal to the current through feedback resistance [Correct Answer]
B.	is less than the current through feedback resistance [Wrong Answer]
C.	is more than the current through feedback resistance [Wrong Answer]
D.	may be equal to, less or more than current through feedback resistance [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In liquids charge carriers are electrons only.
TRUE
FALSE

⇒ For full wave rectification four diode bridge rectifier is claimed to have following advantages:

Less expensive transformer
Small size transformer
Suitable for higher voltage applications

Which of these are correct?
1 and 2 only
1 and 3 only
2 and 2 only
1, 2, 3

⇒ The purpose of incorporating a pre-selector stage in a receiver is to
provide higher selectivity
provide higher fidelity
improve linearity
larger passband

⇒ A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is
0.01 V
0.05 V
0.1 V
0.5 V

⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒ 10 in BCD code represent
10100
1100
10111
None of the above

⇒ A(A + B) =
A
A B
AB
AB

⇒ If the height of transmitting and receiving antenna in a LOS system are 49 meter and a 9 meter respectively then the distance up to which communication may be possible is about
40 km
110 km
400 km
1100 km

⇒ Which of the following represents constant magnitude locus for M = 1?
x = -0.5
x = 0
x² + y² = 1
(x + 1)² + y² = 1

⇒ In the schematic representation of bipolar junction transistor, the direction of arrow shows the direction of flow of
holes
electrons
holes in pnp and electrons in npn
electrons in pnp and holes in npn

⇒ Which of the following terms are applicable to troposcatter propagation?
Faradays rotation
SIOs
Fading
Atmospheric storms

⇒ A pre-emphasis circuit
boosts base frequencies
pre amplifies the complete audio band
amplifies higher audio frequencies
converts FM into phase modulation

⇒ F₂ layer of atmosphere extends from
250 km to 400 km
150 km to 250 km
50 km to 150 km
15 km to 50 km

⇒ The radiation resistance of a doublet antenna of length dl is proportional to
δ l
(δ l)²
(δ l)³
(δ l)⁰⁵

⇒ Kirchoff's laws are applicable to
dc circuits
circuits with sinusoidal excitation only
dc circuits and circuits with sinusoidal excitation
circuits with any excitation

⇒ Consider the following statements as regards pulse repetition frequency

Pulse interval should be as large as possible so that a pulse returns before next pulse is transmitted
Greater the number of pulses reflected from a target, greater is the probability of distinguishing it from the noise

Which of the above are correct?
1 only
2 only
both 1 and 2
neither 1 nor 2

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒ If V = 4 in the figure, the value of I_s is give
0.25
5/2 A
0
none

⇒ A geostationary satellite
is located at a height of 358, 00 km
appears stationary over earth's magnetic pole
is motionless in space but keeps spinning
orbits the earth within a 24 hour period

⇒ The seven segment display used in watches and clocks generally uses
LED
LCD
Photodiode
FET

⇒ An RC series circuit is charged by a voltage E. After a long time the battery is removed and a short circuit is placed across R-C. Then
the polarity of voltage across R is same during discharge and during charge
the polarity of voltage across R during discharging is opposite to that during charging
the polarity of voltage across R depends on time constant RC
none of the above

⇒

Assertion (A): In ionic dielectrics, P = P_e + P_i.

Reason (R): In ionic crystals, permanent electric dipole moment is zero.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a half wave diode rectifier circuit the current flows in the load circuit for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ In order to achieve good stabilization in potential divider method current I₁ through R₁ and R₂ should be
I₁ > 20 I_B
I₁ > 15 I_B
I₁ < 5 I_B
I₁ > 10 I_B

⇒ In a CE amplifier the ac emitter resistance
is zero
is high
is very high
may have any value

⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple

⇒ Which of the following statements is not true in regard to storage time of a diode?
During this time, the diode is reverse-biased
The diode conducts during this time
It is due to the time taken by carriers to depart from the function when the diode is reverse-biased
During this time the diode current is zero

⇒ The slope of the transfer characteristics of an N-channel JFET is
positive
negative
constantly varying
zero

⇒ The block diagram of the given figure
On-off controller
On-off controller with differential gap
On-off controller with integral gap
Three position controller