Question is ⇒ Circuit switching, Message switching and Packet Switching Network belong to which of the following systems?, Options are ⇒ (A) Computer communication system, (B) Electromechanical communication system, (C) PBX system, (D) EPBX system, (E) , Leave your comments or Download question paper.

Question is ⇒ Circuit switching, Message switching and Packet Switching Network belong to which of the following systems?, Options are ⇒ (A) Computer communication system, (B) Electromechanical communication system, (C) PBX system, (D) EPBX system, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Circuit switching, Message switching and Packet Switching Network belong to which of the following systems?
A.	Computer communication system [Correct Answer]
B.	Electromechanical communication system [Wrong Answer]
C.	PBX system [Wrong Answer]
D.	EPBX system [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In Fermi-Dirac statistics, the probability of electron occupation of an energy level equal to Fermi level is
0
0.25
0.5
1

⇒ Electronic tubes used for transmitter differ from their counterparts in the receivers in respect that
they are large in size
they are capable of handling large powers
they generate large amount of heat when in operation
none of the above

⇒ In figure, the curre
is 2 A from A to B
is 2 A from B to A
depends on the value of R
none of the above

⇒

Assertion (A): Dielectric constant is independent of temperature unless the temperature is extremely high.

Reason (R): For normal temperatures the number of atoms per unit volume is constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A clamper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ Antiferromagnetic materials do not have permanent dipoles.
TRUE
FALSE

⇒ The loops ' for , 'while' , 'do-while' are used in
Fortran 77
Pascal
C
none of the above

⇒ When a constant voltage source and constant current source are in series, the current source is ineffective.
TRUE
FALSE

⇒ For an elliptically polarized wave incident on the interface of a dielectric at the Brewster angle the reflected wave will be
elliptically polarized
linearly polarized
right circularly polarized
left circularly polarized

⇒ The difference between sequential and combinational circuits is
Combinational circuits store bits
Combinational circuits have memory
Sequential circuits store bits
Sequential circuits have memory

⇒

Assertion (A): A 4 input variable logic circuit can be implemented using a 8 : 1 multiplexer.

Reason (R): When a multiplexer is used as a logic function generator, the logic design is simple.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In asynchronous TDM, for n signal sources, each frame contains m slots, where m is usually
Less than n
2n
n
greater than 2n

⇒ Low frequency response of amplifier is mainly limited by
input capacitor
bypass capacitor
output capacitor
biasing capacitor

⇒ A waveguide behave as
high Pass filter
low Pass filter
band Pass filter
all Pass filter

⇒ In FM, as the modulating frequency decreases and the modulating voltage amplitude
increases, the modulation index increases
decrease, the modulation index increases
remains constant, the modulation index increases
remains constant, the modulation index decreases

⇒ Linear transistor circuits always operate in
saturation region
cut off region
active region
passive region

⇒ Which of the following is not a valid real constant in C?
1.2 e 2.0
-2.3 e - 2
-2.3 E 2
-2.3 e 2

⇒ Let JCOKE = 3 and LPEPSI = 5. Consider the statement 8
1
15
10

⇒ If carrier modulated by a digital bit stream had one of the possible phases of 0°, 90°, 180°, 270°, then the modulation is called.
BPSK
QPSK
QAM
MSK

⇒ In an RC impedance function
the highest critical frequency is a pole
the highest critical frequency is a zero
the highest critical frequency is a pole or zero
the highest critical frequency is a pole at s = 0

⇒ (11)₂ + (11)₃ = (11)_?
4
5
6
none

⇒ Pirani gauge is used to measure
very low pressure
high pressure
pressure in the range of 1 atmosphere
fluid flow

⇒ In an ac network the sum of currents entering a node is 10 ∠45°. The sum of currents leaving the node is
19.32 ∠45°
15 ∠45°
20 ∠45°
zero

⇒ Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because
it loads the circuit to maximum extent
it loads the circuit moderately
it does not load the circuit at all
it uses centre zero galvanometer instead of Voltmeters

⇒

Assertion (A): 2's complement arithmetic is preferred in digital computers

Reason (R): The hardware required to obtain 2's complement is simple.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ What are the counting stages (Q₁, Q₂) for the counter shown in the figure be
11, 10, 00, 11, 10, ...
01, 10, 11, 00, 10, ...
00, 11, 01, 10, 00, ...
01, 10, 00, 01, 10, ...

⇒ The magnitudes of OC and SC input impedances of a transmission line an 100 Ω and 25 Ω. The characteristic impedance is
25 Ω
50 Ω
75 Ω
100 Ω

⇒ In the wheatstone bridge in figure, each resistance is increased by 0.05%. The value of v₀ will
50 mV
5 mV
0.1 mV
zero

⇒ For a transfer function the coefficients of the numerator and denominator polynomials in s must be real.
TRUE
FALSE

⇒ Antenna used for direction finding is
long dipole
parabolic
rhombic
helical