Question is ⇒ Sound wave travels as, Options are ⇒ (A) longitudinal waves, (B) transverse waves, (C) both longitudinal and transverse waves, (D) either longitudinal or transverse wave, (E) , Leave your comments or Download question paper.

Question is ⇒ Sound wave travels as, Options are ⇒ (A) longitudinal waves, (B) transverse waves, (C) both longitudinal and transverse waves, (D) either longitudinal or transverse wave, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Sound wave travels as
A.	longitudinal waves [Wrong Answer]
B.	transverse waves [Wrong Answer]
C.	both longitudinal and transverse waves [Wrong Answer]
D.	either longitudinal or transverse wave [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Operator has a value 1 ∠ - 90° or 1 ∠ 90°.

Reason (R): Operator 'a' has a value 1 ∠ 120°.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ An FM radio receiver which is tuned to a 91.6 MHz broadcast station may receive an image frequency of __________ MHz.
102.3
113
70.2
80.9

⇒ A voltage v = 100 sin ωt + 10 sin 5 ωt is applied to a pure capacitor having capacitance of 1 μF. If ω = 314 rad/sec, the current through the capacitor is
0.0314 cos 314 t + 0.0157 cos 1570 t
0.0314 sin 314 t + 0.0157 sin 1570 t
0.0314 cos 314 t + 0.0314 cos 1570 t
0.0157 cos 314 t + 0.0157 cos 1570 t

⇒ If sampling is done at the rate of 10 kHz. The bandwidth required is
35 kHz
70 kHz
10 kHz
1280 kHz

⇒ In TTL the transistors are driven into and out of saturation.
TRUE
FALSE

⇒ As applied to a flip flop the word edge triggered's means
flip flop can change state when clock transition occurs
flip flop can change state when clock signal goes from LOW to HIGH only
flip flop can change state when clock signal goes from HIGH to LOW only
none of the above

⇒

Assertion (A): In imperfect capacitors, the current does not lead the applied ac voltage by 90°.

Reason (R): When subjected to ac fields, the dielectric constant can be expressed as ∈^'_r - j∈^"_r.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In rectifiers the use of RC filters is recommended when
load current is high
load current is small
load current is neither high nor small
either (a) or (c)

⇒ A single phase full converter gives maximum and minimum output voltage at firing angles of
0 and 180° respectively
180° and 0° respectively
0 and 90° respectively
90° and 0° respectively

⇒ In a full wave voltage doubler circuit, the input frequency is 560 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
200 Hz

⇒ The duty cycle of a radar transmitter is equal to
(PRF) (pulse width)
(PRF)/(pulse width)
(pulse width)/(PRF)
(pulse width) + (PRF)

⇒ Which of the following statement is wrong?
A depletion type N-channel MOSFET conducts even when V_GS = 0
A BJT is very sensitive to radiation whereas FET is relatively immune
Bipolars need higher supply voltage than FETs
Both N-channel as well as p-channel JFETs work in the depletion mode

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ Ferrities are particularly suited for high frequency applications because of their
low distortion
low eddy current loss
high conductivity
high mobility

⇒ The log magnitude curve of factor jω is a straight line having a slope of 20 dB/decade.
TRUE
FALSE

⇒ The polar plot of a transfer function passes through (-1, 0) point. The gain margin is
zero
- 1 dB
1 dB
infinity

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒ What is the normal range of analog input voltage?
0 to 1 V
0 to 5 V
5 to 15 V
15V to 30V

⇒ A dielectric does not have leakage current.
TRUE
FALSE

⇒ In a travelling wave tube distributed interaction between an electron beam and a travelling wave takes place
TRUE
FALSE

⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A

⇒ Which of the following stage is not present in AM receiver as compared to FM receiver?
AM amplifier
Demodulator
Amplitude limiter
AF amplitude

⇒ The output of a linear system for any input can be computed in which of the following ways?
Only by summation of inpulse response by convolution integral
Only by summation of step response by superposition integral
Neither a nor b
Either (a) or (b)

⇒ Consider the following
only statement 1 is correct
only statement 2 is correct
both statements are correct
both the statements 1 and 2 are not correct

⇒ For measurement of surface temperature of solids the elements of RTD is usually in the shape of
bar
coil
flat grid
either (a) or (b)

⇒ The dual of A + [B + (AC)] + D is
A + [(B (A + C))] + D
A [B + AC] D
A + [B (A + C)] D
A [B (A + C)] D

⇒ If current is less than 20 mA and time of contact is very small, the effect of current on human body is likely to be temporary.
TRUE
FALSE

⇒ Leakage current approximately doubles for every 10°C increase in the temperature of a transistor has I_CBO = 400 nA at 25°C, then its leakage current at 80°C
10 μA
18 μA
20 μA
15 μA

⇒ Which of the following is not the main characteristic of a FET?
Drain resistance
Forward transconductance
Temperature stability
Amplification factor

⇒ The main advantage of TWT over klystron is
higher bandwidth
higher gain
higher frequency
higher output