Question is ⇒ In the above case the modulation index will be, Options are ⇒ (A) 9.6, (B) 28.8, (C) 57.6, (D) 100, (E) , Leave your comments or Download question paper.

Question is ⇒ In the above case the modulation index will be, Options are ⇒ (A) 9.6, (B) 28.8, (C) 57.6, (D) 100, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the above case the modulation index will be
A.	9.6 [Wrong Answer]
B.	28.8 [Wrong Answer]
C.	57.6 [Wrong Answer]
D.	100 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If V_a1 = V_a2 = 100 V and V_a0 = 0, then V_a, V_b, V_c are
200, -100 and -100 V
100, 100, 300 V
200, 100, 100 V
100, -100, 100 V

⇒

Assertion (A): A JFET behaves as a resistor when V_GS < V_P.

Reason (R): When V_GS < V_P, the drain current in a JFET is almost constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The gain of a current element is
0 dB
1.67 dB
1.76 dB
3 dB

⇒ At present, the radio-frequency band mainly used by most satellites is
EHF
UHF
VHF
SHF

⇒ In broadcast television, the number of lines per frame is chosen to be odd number to
reduce the required bandwidth
improve resolution
reduce peak power requirement
make interlacing easier

⇒ Which of the following terms are equivalent?

A ⊕ B ⊕ C
A ⊕ B ⊙ C
A ⊙ B ⊕ C
A ⊙ B ⊙ C

1 and 4; 2 and 3
1 and 3
2 and 3
1, 2 and 4

⇒ In a microwave resistor the wall thickness is made as small as possible to
have high value of R
have low value of R
minimize capacitive effect
reduce inductance

⇒ A periodic voltage v(t) = 1 + 4 sin ωt + 2 cos ωt is applied across a 1 ohm resistance. The power dissipated is
1 W
11 W
21 W
24.5 W

⇒ The current in a circuit with 10 Ω resistance is i = 3 + 4 sin (100 t + 45°) + 4 sin (300 t + 60°) A. The rms current and power dissipated are
41 A and 410 W
35 A and 350 W
5 A and 250 W
11 A and 1210 W

⇒ A silicon wafer has 100 nm of oxide it and is inserted in a furnace at a temperature above 1000°C for further oxidation in dry oxygen. The oxidation rate
is independent of current oxide thickness and temperature
is independent of current oxide thickness but depends on temperature
slows down as the oxide grows
is zero as the existing oxide prevents further oxidation

⇒ Long distance short-wave radio broadcasting uses
ground wave
ionospheric wave
direct wave
any of the above

⇒ Which of the following is necessary transistor action?
The base region must be very wide
The base region must be very narrow
The base region must be made of some insulating material
The collector region must be heavily doped

⇒ Stepper motors find applications in
X-Y plotters
numerically controlled machining equipment
printers
all of the above

⇒ A full subtractor has a total of
2 inputs
3 inputs
4 inputs
5 inputs

⇒ In most electric irons, the thermister used for controlling temperature is
vapour-filled bulb
high-expansion steel rod
bimetallic strip
thermopile

⇒ The current in an RL series circuit is 1 - e^-t amperes. Then di/dt is
1 - e^-t
- e^-t
e^t
e^-2t

⇒ The logical expression Y = A + AB is equivalent to
Y = AB
Y = AB
Y = A + B
Y = A + B

⇒ As compared to full wave rectifier, a half wave rectifier
has higher ripple factor
has lower ripple factor
may have higher or lower ripple factor
has same ripple factor

⇒ The shunt admittance of a transmission line is given by
γ = R + jωL
γ = R - jωL
γ = G + jωC
γ = jωGC

⇒ The model of a system
is unique
depends on desired degree of accuracy
depends on the type of analysis
both (b) and (c)

⇒ In figure the open circuit em
15 V
1.45 V
1.475 V
1.485 V

⇒ In a positive edge triggered D flip flop
D input is called direct set
Preset is called direct reset
Present and clear are called direct set and reset respectively
D input overrides other inputs

⇒ The code used to reduce the error due to ambiguity in reading of a binary optical encoder is
Octal code
Excess-3 code
gray code
BCD code

⇒ Figure shows a pole zero plot of I(s). The likely current response in time domai
i (t) = e^-1 - e^-3t
i (t) = e^-1 - 2e^-2t
i (t) = e^-1 - e^-2t
i (t) = e^-1 - e^-4t

⇒ Metals approach superconductivity conditions
near absolute zero temperature
near critical temperature
at triple point
under the conditions of high temperature and pressure

⇒ The number of valence electrons in donor impurity are
5
4
3
1

⇒ A planar graph has 6 nodes and 7 branches. The number of meshes in the dual graph is
2
3
4
6

⇒ The gradient of any scalar field always yields __________ .
a solenoidal field
a conservative field
an irrotational field
none of these

⇒ In telecast
video and audio signals are frequency modulated
video signals are frequency modulated but audio signals are amplitude modulated
both audio and video signals are amplitude modulated
video signals are amplitude modulated and audio signals are frequency modulated

⇒ A microcomputer has memory locations from 0000 to FFFF, each storing 1 byte. How many bytes can be the memory store?
12333
14666
16384
16655