Question is ⇒ Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 106, Options are ⇒ (A) 15.58 x 106, (B) 15.58 kHz, (C) 1.58 x 103, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 106, Options are ⇒ (A) 15.58 x 106, (B) 15.58 kHz, (C) 1.58 x 103, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 10⁶
A.	15.58 x 10⁶ [Wrong Answer]
B.	15.58 kHz [Correct Answer]
C.	1.58 x 10³ [Wrong Answer]
D.	None of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is Doppler effect not used?
CW radar
FM radar
MTI system
Moving target plotting on PPI

⇒ Which of these has semi-conductor metal junction?
PIN diode
Photo diode
Tunnel diode
Schottky diode

⇒ In which frequency range is the noise figure in a transistor independent of frequency
intermediate frequencies
high frequency
low frequencies
both low and high frequencies

⇒ CC circuit is suitable for impedance matching.
TRUE
FALSE

⇒ Which of the following memories normally has highest storage capacity?
Magnetic disc
Magnetic tape
Semiconductor memory
Core memory

⇒ Which of the following methods does not cause any reduction in instruction length?
Using program counter
Common source and destination address
Implicit source and destination address
Machine language programming

⇒ The 2's complement representation of the decimal number -4 is
100
1100
1011
1010

⇒ A function table is required in very large numbers the memory most switched for this purpose would be
ROM
PROM
EPROM
EAROM

⇒ A differentiating amplifier has capacitor in the input path.
TRUE
FALSE

⇒ In satellite communication, frequency modulation is used because satellite channel has
small bandwidth and negligible noise
large bandwidth and severe noise
maximum bandwidth and minimum noise
high modulation index

⇒ The most noise resistant modulation system is
PCM
SSB suppressed carrier
FM
pulse position modulation

⇒ A speech signal, band limited to 4kHz and peak voltage varying between + 5V and - 5V is sampled at the Nyquist rate. Each sample is quantized and represented by 8 bits. The number of quantization levels required to reduce the quantization noise by a factor of 4 would be
1024
512
256
64

⇒ A TRIAC is a semiconductor device which acts as a
2 terminal unidirectional switch
2 terminal bidirectional switch
3 terminal bidirectional switch
4 terminal multidirectional switch

⇒ In Pascal if I = 45, I div 10 * 10 =
45
40
0.45
0.4

⇒ The voltage e_o indicated in the figure has been measured by an ideal voltmeter. Which of the following can be calcula
Bias current of inverting input only
Bias current of inverting and non-inverting inputs only
Input offset current only
Both the bias currents and the I/P offset current

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ A total of 16 equally probable events exist. If it is required to select one out of them, the number of required bits is
2
4
3
5

⇒ If S represents the carrier synchronization at the receiver and r represents the bandwidth efficiency, then the correct statement for the coherent binary PSK is
r = 0.5, S is required
r = 1.0, S is required
r = 0.5, S is not required
r = 1.0, S is not required

⇒

Assertion (A): The circuit in figure produces repetitive narrow pulses when input is fed with sine or triangular waveform having peak value more than + V

Reason (R): The high gain op-amp produces voltages at two levels. If input is more than + V, the output is + 15 V otherwise the output is - 1
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Match the following:

	List I		List II
A.	Mu Metal	1.	very high magnetic permeability
B.	Samrium/cobalt	2.	very high magnetic remanence
C.	Sapphire	3.	very high thermal conductivity
D.	Ferrites	4.	very stable magnetic permeability

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒ While calibrating an ammeter by a dc potentiometer it is necessary to use a standard resistance.
TRUE
FALSE

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be.
opaque to the visible light
transparent to the visible light
transparent to the ultraviolet radiation
opaque to the infrared radiation

⇒ In the periodic train of rectangular pulses F₀ = (V₀/T)d
TRUE
FALSE

⇒ Which class of amplifiers operates with least distortion?
Class A
Class B
Class C
Class AB

⇒ In a 3 phase full converter, the firing angle is less than 60°. The instantaneous output voltage
will have positive part only
will have both positive and negative parts
may have both positive and negative parts
will have negative part if load is inductive

⇒ For an amplifier, the coupling method which gives the highest gain in
impedance coupling
transformer coupling
capacitance coupling
resistance coupling

⇒ The leads in a TRIAC are denoted by
anode cathode, gate
T₁ T₂, gate
T₁, T₂, anode
T₁, T₂, T₃

⇒ In an home T.V. receiver, the leed in from the antenna is
coaxial cable of 75 Ω
ordinary twisted wire
bar copper wire
twin wire

⇒ The slope of log magnitude curve changes by - 40 dB/decade at a certain frequency and the error between asymptote and actual curve is positive. This means that
a double pole is present
a pair of complex conjugate poles is present
either (a) or (b)
neither (a) nor (b)

⇒ The number of valence electrons in pentavalent impurity is
5
4
3
1

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math