Question is ⇒ Pick out the odd one, Options are ⇒ (A) stochastic variable, (B) stochastic function, (C) random variable, (D) random experiment, (E) , Leave your comments or Download question paper.

Question is ⇒ Pick out the odd one, Options are ⇒ (A) stochastic variable, (B) stochastic function, (C) random variable, (D) random experiment, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Pick out the odd one
A.	stochastic variable [Wrong Answer]
B.	stochastic function [Wrong Answer]
C.	random variable [Wrong Answer]
D.	random experiment [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Carbon steel has a residual flux density of 1 Wb/m².
TRUE
FALSE

⇒ In figure, V_{020 V
10 V
5 V
0}

⇒ One of the function of the Sio₂ layer in an IC is to
act as a dielectric for capacitors
prevent shorting of elements by interconnections
from cathodes for diodes
afford protection from the radiations

⇒ In a bridge inverter
an output transformer is essential
an output transformer is not essential
an output transformer cannot be connected
an output transformer, if used, can improve the efficiency of the circuit

⇒ While calibrating an ammeter by a dc potentiometer it is necessary to use a standard resistance.
TRUE
FALSE

⇒

Assertion (A): SSB systems generally have duplex operation

Reason (R): SSB systems are generally used in two way communication.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The phase difference (jω - p₁ )
phasor directed from p₁ to jω
phasor directed from origin to p₁
phasor directed from origin to jω point
phasor directed from jω to p₁

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ A transistor is operated as non-saturated switch to eliminate
turn on time
turn off time
storage time
delay time

⇒

Assertion (A): In totem pole output the output impedance is low.

Reason (R): TTL gate with active pull up should not be used in wired AND connection.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The function (s + 2) (s + 4)/[(s + 1)(s + 3)]
is a reactance function
is an RC function
may be a reactance function or an RC function
may be RC function or an RL function

⇒ A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if
load torque is constant
load torque increases with increase in speed
load torque decreases with increase in speed
either (a) or (b)

⇒ In which of the following circuits is op-amp used in open loop configuration?
Comparator
Summing amplifier
Integrating amplifier
Logarithmic amplifier

⇒ An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is
0 to 200 Ω
200 - 400 Ω
200 Ω and above
400 Ω and above

⇒ For graph of figure, one set of fundamental cutsets woul
abc, cde, afe
afde, afe, abdc
cbfe, afe, bdf
cbd, adbe, cde

⇒ In figure, the power dissipated in 4 resistance is P₁ and power associated with 3 A source is P₂.
P₁ = P₂
P₁ < P₂
P₁ > P₂
P₁ may be equal or less than P₂

⇒ The maximum permissible distance between two samples of a 2 kHz signal is
1000 μ sec
500 μ sec
250 μ sec
2000 sec

⇒ The content of which of the following determines the state of the CPU at the end of the execute cycle (when the interrupt is recognized)?

Program counter
Processor register
Certain status conditions

Select the correct answer using the codes given below :
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ At corner frequency the phase angle of factor 1/(1 + jωT) is
+90°
-90°
+45°
-45°

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ If the height of transmitting and receiving antenna in a LOS system are 49 meter and a 9 meter respectively then the distance up to which communication may be possible is about
40 km
110 km
400 km
1100 km

⇒ For a second order system, the position of poles is in the shaded region shown in the given figure. The variation in damping facto
from 0 to 1
from about 0.3 to 0.7
from 1 to 5
from 0 to 3

⇒ Evaluate the power stored in inductor and capac
25 J, 12.5 J
12.5 J, 25 J
25 J, 50 J
12.5 J, 50 J

⇒ In an R-L-C circuit, v(t) = 20 sin (314 t + 5 p/6) and i(t) = 10 sin (314 t + 2p/3). The p.f of the circuit is
0.5 lead
0.866 lag
0.866 lead
0.5 lead

⇒ e^-3^t is a
energy signal
power signal
Both (a) and (b)
none

⇒ A resistance and an inductance are connected in parallel and fed from 50 Hz ac mains. Each branch takes a current of 5 A. The current supplied by source is
0.416666666666667
7.07 A
0.208333333333333
zero

⇒ The capacitance of a cylindrical capacitor is directly proportional to its length.
TRUE
FALSE

⇒ Radar antennas are usually
dipoles
yagi antennas
parabolic dishes
none of the above

⇒

Match the following:

	List I (Electron spin)		List II (Phenomenon)
A.	↑↑↑↑	1.	Antiferromagnetism
B.	↑↓↑↓	2.	Ferrimagnetism
C.	↑↓↑↓	3.	Ferromagnetism

A-1, B-2, C-3
A-3, B-2, C-1
A-2, B-3, C-1
A-3, B-1, C-2

⇒ CC circuit is suitable for impedance matching.
TRUE
FALSE