Question is ⇒ A binary ladder network D/A converter requires, Options are ⇒ (A) resistors of one value only, (B) resistors of many different values, (C) resistors of two different values, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A binary ladder network D/A converter requires, Options are ⇒ (A) resistors of one value only, (B) resistors of many different values, (C) resistors of two different values, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A binary ladder network D/A converter requires
A.	resistors of one value only [Wrong Answer]
B.	resistors of many different values [Wrong Answer]
C.	resistors of two different values [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Maximum effective aperture of an antenna which is operating at a wavelength of 3 meters and has a directivity of 100
71.68 m²
716 m²
7.16 m²
71.6 m²

⇒ The reading of the voltmeter V in figure should be __________ v
60
10
66
0

⇒ If the drift velocity of holes under a field gradient of 100 V/m in 5 m/s, their mobility (in SI units) is
0.05
0.5
50
500

⇒ The duration of sunspot cycle is
1 year
11 years
55 years
100 years

⇒ For generating 1 MHz frequency signal, the most suitable circuit is
phase shift oscillator
weinbridge oscillator
colpitt's oscillator
clapp oscillator

⇒ In frequency modulation noise can be further reduced by
increasing deviation
reducing deviation
reducing carrier frequency
increasing signal amplitude

⇒ An advantage of memory interlacing is that
a larger memory is obtained
effective speed of memory is increased
cost of memory is reduced
a non-volatile memory is obtained

⇒ Which of the following elements act as donor impurities?

Gold
Phosphorus
Boron
Antimony
Arsenic
Indium

Select the answer using the following codes :
1, 2 and 3
1, 2, 4, and 6
3, 4, 5 and 6
2, 4 and 5

⇒ In a RS flip-flop no change occurs during
prohibited mode
set mode
reset mode
disable mode

⇒ In a JFET
drain current is very nearly equal to source current
drain current is much less than source current
drain current may be equal to or less than source current
drain current may be even more than source current

⇒ What is the address space of 8086 CPU?
One Megabyte
256 Kilobytes
1 K Megabytes
64 Kilobytes

⇒ In a series inverter
the commutating elements carry full load current
the commutating elements carry upto 50% of load current
the commutating elements do not carry load current
any of the above

⇒ In the op-amp circuit of figure, V_{03 V₁ - 4 V₂
-3 V₁ + 4 V₂
3(V₁ - V₂)
-3(V₁ - V₂)}

⇒ In TV transmitter, visual exciter may consist of

Video processing unit
Visual modulator
VSB filter
Delay equaliser
Frequency converter

Which of the above are actually a part of visual exciter?
1, 2 and 3
2, 3 and 4
1, 2, 3 and 4
1, 2, 3, 4 and 5

⇒

Assertion (A): The line integral of B about a closed contour, in a region containing steady current, is μ₀ times the total net current, following through the contour of integration.

Reason (R): The curl of B is equal to μ₀ times the current density vector J

Both (A) and (R) are true and (R) is the correct explanation of (A)
Both (A) and (R) are true but (R) is not the correct explanation of (A)
(A) is true but (R) is false
(A) is false but (R) is true

⇒

Assertion (A): Free space does not interfere with normal radiation and propagation of radio waves

Reason (R): Free space has no magnetic or gravitational fields.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A source of angular frequency 1 rad sec has a source impedance consisting of 1 Ω resistance in series with 1 H inductance. The load that will obtained the maximum power transfer is
1 Ω resistance
1 Ω resistance in parallel with 1 H inductance
1 Ω resistance in series with 1 F capacitor
1 Ω resistance in parallel with 1 F capacitor

⇒ In figure the coordinates of Q point on the load line are (Neglect V_{BEI_C = 10 mA, V_CE = 15 V
I_C = 5 mA, V_CE = 22.5 V
I_C = 5 mA, V_CE = 15 V
I_C = 10 mA, V_CE = 22.5 V}

⇒ A compiler is a software programme which
change high level Programming language into low level machine language
change the program into binary form
assembles the program
executes the program

⇒ The power factor of a single phase load can be calculated if instruments available are
one voltmeter, one ammeter
two ammeters
two voltmeters
one voltmeter, one ammeter and one wattmeter

⇒ The inputs to logic gate are 0. The output is 1. The gate is
NAND or XOR
OR or XOR
AND or XOR
NOR or Ex-NOR

⇒ Consider the following ON GO TO statement in Ba
10, 20, 30, 20 respectively
10, 20, 20, 30 respectively
20, 30, 20, 10 respectively
10, 30, 20, 20 respectively

⇒ In an n type semiconductor
number of free electrons and holes are equal
number of free electrons is much greater than the number of holes
number of free electrons may be equal or less than the number of holes
number of holes is greater than the number of free electrons

⇒ An FM transmitter delivers 80W to a load of 30 W when no modulation is present. The carrier is now frequency modulated by a single sinusoidal signal and the peak frequency deviation is so adjusted to make the amplitude of the second sideband is zero in the given out
84 W
97.44 W
100 W
77.44 W

⇒ The equivalent circuit of an ideal diode is
a charging condenser
a discharging condenser
a switch
a resistor

⇒ Binary number 1101 is equal to octal number
17
16
15
14

⇒ An 8085 microprocessor is operating at 2 MHz frequency and executes the following progr
12
13
14
15

⇒ A typical signal strength received from a geosynchronous communication satellite is of the order of a few
milliwatts
kilowatts
picowatts
watts

⇒ In a D latch
a high D sets the latch and low D resets it
a low D sets the latch and high D resets it
race can occur
none of the above

⇒ Find R_{AB2 Ω
1.5 Ω
3 Ω
None of the above}