Question is ⇒ An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be, Options are ⇒ (A) 50 A, (B) 25 A, (C) less than 50 A but more than 25 A, (D) less than 25 A, (E) , Leave your comments or Download question paper.

Question is ⇒ An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be, Options are ⇒ (A) 50 A, (B) 25 A, (C) less than 50 A but more than 25 A, (D) less than 25 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be
A.	50 A [Wrong Answer]
B.	25 A [Wrong Answer]
C.	less than 50 A but more than 25 A [Correct Answer]
D.	less than 25 A [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The action of bellows is similar to that of
mass
viscous friction
spring
none of the above

⇒ Consider the following statements

In a pulsed radar, the transmitted pulses are of high frequency
In a pulsed radar, the transmitted pulses are of high power
In a pulsed radar, the transmitted pulses are of brief duration
In a pulsed radar, the transmitted pulses are of square wave shape.

Of the above statements the correct statements are
1 only
1, 2 and 3 only
1, 2, 3, 4
1 and 3 only

⇒ The poles and zeros of a positive real functions are real or occur in conjugate pair.
TRUE
FALSE

⇒ The voltage drop per ampere-metre of an aluminium conductor is higher as compared to a copper conductor of the same size due to its higher
insulation resistance
resistivity
conductivity
current density

⇒ Two port circuits are connected in parallel. To determine the response, it is more convenient to use
O.C. impedance parameters
S.C. admittance parameters
ABCD parameters
h parameters

⇒ For high frequencies a capacitor like
an open circuit
a short circuit
either open circuit or short circuit
none of the above

⇒

Assertion (A): A series RLC circuit resonates when excited by variable frequency source.

Reason (R): Resonant frequency is geometric mean of half power frequencies.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The full form of the abbreviations TTL and CMOS in reference to logic families are
Triple Transistor Logic and Chip Metal Oxide Semiconductor
Tristate Transistor Logic and Chip Metal Oxide Semiconductor
Transistor Transistor logic and Complementary Metal Oxide Semiconductor
Trisate Transistor Logic and Complementary Metal Oxide Silicon

⇒

Assertion (A): L[e^-at f(t)] = F(s + a)

Reason (R): In use of Laplace transform method, initial conditions may be neglected.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The number of stator field windings in an ac tachometer are
1
2
3
4

⇒ The source of the harmonic distortion in a RC coupled transistor amplifier is usually
power supply
capacitor
R-C circuit
transistor

⇒ The first and the last critical frequencies (singularities) of a driving point impedance function of a passive network having two kind of elements, are a pole and a zero respectively. The above property will be satisfied by
RL network only
RC network only
LC network only
RC as well as RL network

⇒ Which of the following polynomials is not Hurwitz?
P₁ = s⁸ + 2s⁶ + 4s⁴
P₂ = s⁶ - 3s⁴ + 2s² + 1
P₃ = s⁴ + 3s³ + 3s² + 2s + 1
P₄ = s⁷ + 2s⁶ 2s⁴ + 4s³ + 8s² + 8s + 4

⇒ If the frequency is less than the damped frequency in a series- inverter
the distortion of output voltage waveform is low
the distortion of output voltage waveform is high
the distortion of output voltage may be high or low depending on the load impedance
none of the above

⇒ The time needed by a TTL circuit to switch from 0 to 1 or 1 to 0 is about
10 μs
10 ns
100 μs
50 ns

⇒ In a CRO, the frequency of output of time base generator
is only one constant value
is adjustable
varies automatically
either (a) or (c)

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒ The unit of loudness is
phon
sone
decibel
mel

⇒ In a voltage regulator circuit using zener diode the load voltage is nearly constant only if
zener current is very small
zener current is very large
zener current is neither small nor large
None of the above

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒ Two infinitely long wires carrying current are as shown in the figure below. One wire is in the y-z plane and parallel to the y-axis. The other wise is in the x-y plane and parallel to the x-axis. Which components of the resulting magnetic field are non-zero at the ori
x, y, z components
x, y components
y, z components
x, z components

⇒ In a virgin specimen of iron, the direction of spontaneous magnetisation varies from domain to domain.
TRUE
FALSE

⇒ A modem is classified as low speed if data rate handled is
upto 100 bps
upto 250 bps
upto 400 bps
upto 600 bps

⇒ In a microprocessor the clock signal
is always generated internally
is always supplied externally
may be generated internally or supplied externally
is mostly supplied externally

⇒ A string constant in basic is
a string of capital alphabets A to Z, included in question mark
a string of capital alphabets A to Z and digits 0 to 9 included in question mark
a string of capital alphabets A to Z, digits 0 to 9 and special characters
a string of capital alphabets A to Z, digits 0 to 9 and special characters included in question mark

⇒ The power to the base unit of a cordless telephone is supplied by
battery
AC mains
both battery and AC mains
either battery or AC mains

⇒

Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): When the performance of a stable second order system is improved by a PID controller, the system may become unstable.

Reason (R): PID controller increases the order of the system to 3.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ How can the quantizing noise be reduced?
By using de-emphasis circuit
By using RF amplifier in the receiver
By increasing the number of quantization levels
By sending sloping pulses

⇒ The PC contains 0450 H and SP contains 08D 6 H. What will be content of P and SP following a CALL to subroutine at location 02 AFH?
0453 H, 08 D 8 H
0453 H, 08 D 4 H
02 AFH, 08 D 8 H
02 AFH, 08 D 4 H