Question is ⇒ In a low level AM system, the amplifier which follows the modulated stage must be the, Options are ⇒ (A) linear device, (B) harmonic device, (C) class C amplifier, (D) non-linear device, (E) , Leave your comments or Download question paper.

Question is ⇒ In a low level AM system, the amplifier which follows the modulated stage must be the, Options are ⇒ (A) linear device, (B) harmonic device, (C) class C amplifier, (D) non-linear device, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a low level AM system, the amplifier which follows the modulated stage must be the
A.	linear device [Correct Answer]
B.	harmonic device [Wrong Answer]
C.	class C amplifier [Wrong Answer]
D.	non-linear device [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance

⇒ Damping ratio =
actual resistance/critical resistance
critical resistance/actual resistance
critical resistance
none of the above

⇒ A 555 timer can be used as
an astable multivibrator
monostable multivibrator
frequency Divider only
any of the above

⇒ Which synthesis procedure requires the use of mutual inductance?
Foster's synthesis
Cauer synthesis
Bott-Duffin synthesis
Brune's synthesis

⇒ An ungrounded antenna near the ground
is horizontally polarized
acts as an antenna array
acts as a single antenna of twice the height
is not likely to need an earth mat

⇒ The velocity of electromagnetic wave in a good conductor is
3 x 10⁸ m/s
more than 3 x 10⁸ m/s
very low
high

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ Which one of the following is D/A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒ A noiseless 3 kHz channel can't transmit binary bit at the rate
12000 bps
1000 bps
6000 bps
3000 bps

⇒ In floating point representation, the accuracy is
10 bit
9 bit
8 bit
6 bit

⇒ A universal shift register can shift left or right.
TRUE
FALSE

⇒ In amplifiers, the parasitic oscillation result due to
transistor inter junction capacitance
push pull operator
negative feedback
poor inter-stage coupling

⇒ In the circuit shown below, the outputs Y₁ and Y₂ for the given initial condition Y₁ = Y₂ = 1 and after four input pulses wil
Y₁ = 1, Y₂ = 0
Y₁ = 0, Y₂ = 0
Y₁ = 0, Y₂ = 1
Y₁ = 1, Y₂ = 1

⇒ VSWR = E_max/E_min.
TRUE
FALSE

⇒ In a circuit containing a complex impedance, maximum power transfer takes place when load is
pure resistance
equal to the complex impedance
conjugate complex of the circuit impedance
none of the above

⇒ Which of the following parameters is not specified for digital ICs?
Gate dissipation
Propagation delay
Noise margin
Bandwidth

⇒ Which of the following statements is correct?
R-C is a dual pair
LC is a dual pair
Norton is a series circuit
Thevenin equivalent a parallel circuit

⇒ In a 4 bit counter the output of 3 JK FFs from MSB downward are connected to the NAND gate whose O/P is connected to CLR
it is a MOD-14 counter
it is MOD-13 counter
it is divided by 13 counter
it is divide by 10 counter

⇒ Which of the following conversion is incorrect?
2048.0625 = 100000000000.0001₂
100000011.1001₂ = 131.5625₁₀
101101₂ = 45₈
Hexadecimal B6C₇ = 46791₁₀

⇒ Flow charts that contain decision sy
represent straight line programs
do not represent straight line programs
all of the above
none of the above

⇒ A current wave is i = 100e^-60t The initial and final values of current are
100 and 50
100 and 0
0 and 100
100 and 100

⇒ When a current flows through a coil of insulated wire, the coil shows the properties of a magnet.
TRUE
FALSE

⇒ What will be conversion time of a successive approximation A/D converter which uses 2 MHz clock and 5 bit binary ladder containing 8 V reference.?
2.5 μ sec
25 μ sec
3 μ sec
4 μ sec

⇒ Given digits 2, 2, 3, 3, 3, 4, 4, 4, 4 how many distinct 4 digit numbers greater than 3000 can be formed?
50
51
52
54

⇒ An SR flip flop can be built using NOR gates or NAND gates.
TRUE
FALSE

⇒ If Nyquist plot has a encirclement of (-1 + jo) point, the system is stable if
there are no poles of G(s) H(s) in right-half plane
there is one pole of G(s) H(s) in right-half plane
there is no zeros of G(s) H(s) in right-half plane
none of the above

⇒ Laplace transform method enables us to find the response in
steady state
transient state
both steady and transient state
transient state provided forcing functions do not exist

⇒ 24 telephone channels, each band limited to 3.4 kHz are to be time division multiplexed using PCM. If sampling frequency is 10 kHz and number of quantization levels is 128, the required bandwidth of PCM is
1.68 MHz
240 kHz
81.6 kHz
3.072 MHz

⇒ In a bipolar transistor the barrier potential
0
a total of 0.7 V
0.7 V across each depletion layer
0.35 V

⇒ A full adder can be made out of
two half adders
two half adders and a OR gate
two half adders and a NOT gate
three half adders