Question is ⇒ A tweeter should be fed from the input through a, Options are ⇒ (A) low pass filter, (B) high pass filter, (C) band pass filter, (D) band stop filter, (E) , Leave your comments or Download question paper.

Question is ⇒ A tweeter should be fed from the input through a, Options are ⇒ (A) low pass filter, (B) high pass filter, (C) band pass filter, (D) band stop filter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A tweeter should be fed from the input through a
A.	low pass filter [Wrong Answer]
B.	high pass filter [Correct Answer]
C.	band pass filter [Wrong Answer]
D.	band stop filter [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The resistivity of intrinsic semiconductor decreases with increase in temperature.

Reason (R): The forbidden gap decreases with increase in temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): It is possible that a digital circuit gives the same output for different input voltages

Reason (R): A digital circuit is also called logic circuit.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Consider the following instruction of 8085 μp :

MOV M, A
AODC
MVI A, FF
CMP M

Which of these cause change in the status of flag(s)?
1 and 2
1, 2 and 3
3 and 4
2 and 4

⇒ For the given truth table, the correct Boolean expressio
XYZ + X YZ + X Y Z
X Y Z + XYZ + X YZ
X Y Z + XYZ + XY Z
XYZ + XYZ + XY Z

⇒ Consider the following DO statement in Fortran 77 1
11
10
4

⇒ Two network said to be dual to each other
if mesh equation of one is same to other of node equation
if mesh equation of both is same
if node equation of both is same
neither mesh equation nor node equation is same

⇒ V MOS have the advantage of
faster switching
no thermal run away
both (a) and (b)
none of the above

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then Find width of major lobe for broadside
6°
5.73
51.25
0°

⇒ In a series resonant circuit, the resonant frequency is
geometric mean of half power frequencies
arithmetic mean of half power frequencies
difference of half power frequencies
none of the above

⇒ The resistance of a 230 V, 100 W lamp is
529 Ω
2300 Ω
5290 Ω
23 Ω

⇒ If CS = A₁₅ A₁₄ A₁₃ is used as chip select logic of a 4 K RAM in 8085 system, its memory range is
3000 H - 3 FFF H
7000 H - 7 FFFH
5000 H - 5 FFF H and 6000 H - 6 FFF H
6000 H - 6 FFF H and 7000 H - 7 FFF H

⇒ A reactance function
has a pole at origin
has a zero at origin
may have a pole or zero at origin
has a pole or zero at origin and a pole or zero at infinity

⇒ A 50 Hz current has an amplitude of 10 A. The rate of change of current at t = 0.005 after i = 0 and is increasing is
2221.44 A/s
0
- 2221.44 A/s
- 3141.6 A/s

⇒ Which of these has lowest dielectric strength?
Dry air
Wet air
Cotton
Paper

⇒ If the drift velocity of holes under a field gradient of 100 V/m is 5m/sec. Their mobility is
0.05
0.5
50
500

⇒ A bypass capacitor produces
dc ground
ac ground
both dc and ac ground
none of the above

⇒ In a communication system, noise is most likely to affect the signal
at the receiver
at the transmitter
at the information source
in the channel

⇒ j⁶ =
j
j²
j³
- j

⇒ Homodyne detection means
coherent detection
non-coherent detection
asynchronous detection
none of the above

⇒ In a full wave voltage doubler circuit, the input frequency is 560 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
200 Hz

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the starting torque is 100 N-m. At 25 Hz, the starting torque
will be less than 100 N-m
will be more than 100 N-m
may be more or less than 100 N-m depending on motor parameters
very small

⇒ In Jone chopper, the commutating element
is a capacitor
is a capacitor and an inductor
is a capacitor and an auto transformer
none of the above

⇒ The operating modes of 8255 A are called
mode 0 and mode 1
mode 0, mode 1 and mode 2
mode 0 and mode 2
mode 0, mode 2 and mode 3

⇒ A TR (transmitter receiver) tube has
low loss for low power signals and high
high loss for low power signals and low loss for high level signal
low loss for both low level and high level signals
high loss for both low level and high level signals

⇒ A resistance strain gauge is usually
wire grid type
foil type
any of these
none of these

⇒

Assertion (A): In a push pull circuit each transistor stays in the active region for one half cycle

Reason (R): A push pull amplifier has low distortion

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The gap width in audio heads is about 0.01 mm.
TRUE
FALSE

⇒ The core of a coil has a length of 10 cm. The self inductance is 8 mH. If the core length is doubled, all other quantities remaining the same, the self inductance will be
32 mH
16 mH
8 mH
4 mH

⇒ A rectangular pulse train s(t) is shown in figure is convolved with the signal cos²(4p x 10³t). The convolved signal will
DC
12 kHZ sinusoidal
8 kHZ sinusoidal
14 kHZ sinusoidal

⇒ The breakdown voltage in a zener diode
is almost constant
is very small
may destroy the diode
decreases with increase in current