Question is ⇒ Consider the following statements about a good power supply: <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">The a.c. ripple should be high</li><li style="padding-top:10px;">Sv, (Voltage stability factor) should be low</li><li style="padding-top:10px;">ST, (Temperature stability factor) should be low</li></ol> Which of the above statements are correct?, Options are ⇒ (A) 1, 2 and 3, (B) 2 only, (C) 3 only, (D) 2 and 3 only, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following statements about a good power supply: <ol style="list-style-type: decimal; padding-bottom:10px;"><li style="padding-top:10px;">The a.c. ripple should be high</li><li style="padding-top:10px;">Sv, (Voltage stability factor) should be low</li><li style="padding-top:10px;">ST, (Temperature stability factor) should be low</li></ol> Which of the above statements are correct?, Options are ⇒ (A) 1, 2 and 3, (B) 2 only, (C) 3 only, (D) 2 and 3 only, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following statements about a good power supply: The a.c. ripple should be high S_v, (Voltage stability factor) should be low S_T, (Temperature stability factor) should be low Which of the above statements are correct?
A.	1, 2 and 3 [Wrong Answer]
B.	2 only [Wrong Answer]
C.	3 only [Wrong Answer]
D.	2 and 3 only [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The equivalent T circuit of this coupled network is shown in figure. Find the values of Z_A, Z_B and Z_{C-j, 6j, 2j
-j, 2j, 6j
j, 2j, - 6j
j, 2j, 6j}

⇒ Which of the following is not correct for two phase servomotor?
Rotor diameter is small
Applied voltages are seldom balanced
Rotor resistance is low
Torque speed curve is linear

⇒ In the given figure forward voltage wave has a magni
90 V
60 V
30 V
10 V

⇒ Which of the following is invariably found in SSB?
Tuned modulator
Class B, RF amplifier
Class C, audio amplifier
All of the above

⇒ UHF and microwaves in the frequency range 300 MHz to 30 GHz can be best transmitted using __________ propagation
sky wave
ground wave
duct
none of the above

⇒ When time constant T in any factor is varied, the shapes of log magnitude and phase angle curves remain the same.
TRUE
FALSE

⇒ For dielectrics in alternating field, polarizability a_e is a complex quantity. The imaginary part of a_e is zero for
ω = 0
ω → ∞
ω = 0 and ω → ∞
ω = natural frequency ω₀

⇒ How many and which types of machine cycles are needed to execute PUSH PSW by 8085 microprocessor?
2, Fetch and memory write
3, Fetch and memory write
3, Fetch and memory read
3, Fetch and memory read and memory write

⇒ A binary adder has
one half adder
one half adder and 2 full adders
two half adders
one half adder and many full adders

⇒ T.V. broadcasting based on
line of sight communication
ionospheric propagation
ground wave
medium wave

⇒ When the channel is noisy, producing a conditional probability of error p = 0.5; the channel capacity and entropy function would be, respectively,
1 and 1
1 and 0.5
0.5 and 1
0 and 1

⇒ Ferromagnetic materials exhibit
a linear B-H behaviour
a non-linear B-H behaviour
an exponential B-H behaviour
none of the above

⇒ An RLC series circuit has R = 1 Ω, L = 1 H, C = 1 F. The damping ratio is
More than 1
1
0.5
Zero

⇒ Flow charts that contain decision sy
represent straight line programs
do not represent straight line programs
all of the above
none of the above

⇒ A fully controlled bridge converter is feeding an RLE load. For some circuit conditions firing angle is 47°. If connections of battery are reversed, the firing angle is likely to be
47°
less than 47°
more than 47°
either more or less than 47°

⇒ Magnesium is alloyed with conducting materials for antenna primarily with the purpose of
increasing efficiency
improving radiative power
reducing weight
increasing density

⇒ Consider the following statements about hybrid ring

Ports 1 and 2 are decoupled.
Port 3 and 4 are coupled.
A signal entering either port 1 or 2 splits equally between ports 3 and 4.
A signal entering either port 3 or 4 splits equally between ports 1 and 2.

Which of the above are correct?
1, 2, 3 and 4
1, 3 and 4
1 and 2
2, 3 and 4

⇒

Match the following:

	List I (Octal)		List II (Hexadecimal)
A.	66	1.	3 F
B.	77	2.	36
C.	55	3.	27
D.	47	4.	3D

A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-2, D-4
A-4, B-1, C-2, D-3

⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A

⇒ A logarithmic amplifier has diode in the feedback path.
TRUE
FALSE

⇒ In a high frequency coaxial line and the length of line characteristic impedance is a function of
properties of insulating material only
inner and outer conductor radius only
both (a) and (b)
neither (a) nor (b)

⇒

Assertion (A): In CC amplifier the collector is at ac ground

Reason (R): CC amplifier is also called emitter follower

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The signal to noise ratio in telemetry should be better than
5 db
10 db
25 db
60 db

⇒ Some possible functions of AGC in a TV receiver are

To increase gain for weak signals
To decrease gain for strong signals
To change the contrast when we switch from one channel to other
To reduce flutter

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2, 3
2, 3, 4

⇒ The frequency response of a microphone means
bandwidth of frequencies having output with in ± 1 dB of the output at 1000 Hz
bandwidth of frequencies having output with in ± 3 dB of the output at 1000 Hz
bandwidth of frequencies having output with in ± 1 dB of the output at 500 Hz
bandwidth of frequencies having output with in ± 3 dB of the output at 500 Hz

⇒ If the bandwidth is increased by 2, the γ_FM γ_AM (where γ is the ratio of SNR of output to SNR at input, FM is frequency modulation and AM is amplitude modulation) is increased by a factor of
2
3
4
6

⇒ Which of the following figures is an ideal equivalent circuit of a n-p-n transis
figure A
figure B
figure C
none

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.
TRUE
FALSE

⇒ Which device changes parallel data to serial data?
Decoder
Multiplexer
Demultiplexer
Flip flop