Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Laser</td><td>1.</td><td>Emits monochromatic light of low intensity</td></tr><tr><td>B.</td><td>Solar cell</td><td>2.</td><td>Consumes electrical power due to incident light</td></tr><tr><td>C.</td><td>Photodiode</td><td>3.</td><td>Delivers power to a load</td></tr><tr><td>D.</td><td>LED</td><td>4.</td><td>Emits monochromatic light of high intensity</td></tr></tbody></table>, Options are ⇒ (A) A-4, B-3, C-1, D-2, (B) A-3, B-4, C-2, D-1, (C) A-4, B-3, C-2, D-1, (D) A-3, B-4, C-1, D-2, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Laser</td><td>1.</td><td>Emits monochromatic light of low intensity</td></tr><tr><td>B.</td><td>Solar cell</td><td>2.</td><td>Consumes electrical power due to incident light</td></tr><tr><td>C.</td><td>Photodiode</td><td>3.</td><td>Delivers power to a load</td></tr><tr><td>D.</td><td>LED</td><td>4.</td><td>Emits monochromatic light of high intensity</td></tr></tbody></table>, Options are ⇒ (A) A-4, B-3, C-1, D-2, (B) A-3, B-4, C-2, D-1, (C) A-4, B-3, C-2, D-1, (D) A-3, B-4, C-1, D-2, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I		List II
A.	Laser	1.	Emits monochromatic light of low intensity
B.	Solar cell	2.	Consumes electrical power due to incident light
C.	Photodiode	3.	Delivers power to a load
D.	LED	4.	Emits monochromatic light of high intensity

A-4, B-3, C-1, D-2

A-3, B-4, C-2, D-1

A-4, B-3, C-2, D-1

A-3, B-4, C-1, D-2

View Answer 1 -1

Explanation:-
Answer : C
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In p type semiconductor, the hole concentration
is nearly equal to density of acceptor atoms
is much greater than density of acceptor atoms
is much less than density of acceptor atoms
may be equal to or more or less than density of acceptor atoms

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above

⇒

Match the following:

	List I (Types of N-bit ADC)		List II (Characteristics)
A.	Flash converter	1.	Integrating Type
B.	Successive	2.	Fastest converter approximation
C.	Counter ramp	3.	Maximum conversion time = N bits
D.	Dual slow	4.	Used a DAC in its feedback path

A-2, B-3, C-4, D-1
A-1, B-3, C-4, D-2
A-2, B-4, C-3, D-1
A-1, B-4, C-3, D-2

⇒ An antenna is considered to be in free space where its height above the ground is
λ
2λ
less than 3λ
more than 5λ

⇒ In a bistable multivibrator, commutating capacitors are used to
increase the base storage charge
provide ac coupling
increase the speed of response
alter the frequency of the output

⇒ A high resistance was measured by loss of charge method. The voltmeter resistance was 10¹⁰ ohms. The calculation gave the value of unknown resistance as 0.8 x 10⁹ ohms. The true value of resistance is
0.8 x 10⁹ Ω
less than 0.8 x 10⁹ Ω
more than 0.8 x 10⁹ Ω
either (b) or (c)

⇒

Match the following:

	List I		List II
A.	Serial Binary adder	1.	(2n - 1)t_pd
B.	Ripple carry adder	2.	(n - 1)t_pd
C.	Carry look ahead binary adder	3.	Operation time independent of size
		4.	6t_pd for 4 bit carry look ahead adder

A-2, B-1, C-3
A-2, B-1, C-4
A-1, B-2, C-4
A-1, B-2, C-3

⇒ In a dynamometer 3 phase power factor meter, the planes of the two moving coils are at
60°
0°
120°
90°

⇒ In figure, the value of R shoul
0.2 Ω
0.1 Ω
0.05 Ω
0.1 Ω

⇒ Evaluate the power stored in inductor and capac
25 J, 12.5 J
12.5 J, 25 J
25 J, 50 J
12.5 J, 50 J

⇒ In mode filter of the given figure which of the following modes is unaffe
TE₀₁
TE₁₀
TE₁₁
all TM

⇒ Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C
0.5
5
5.657
5.756

⇒ A 4 bit counter with four flip-flops will count upto decimal
8
15
31
63

⇒ Which of the following term does not apply to the Yagi-Uda array?
High gain
Folded dipole
Parasitic
Good bandwidth

⇒ In a ratio detector
the linearity is worse than in a phase discriminator
the output is twice that obtainable from a similar phase discriminator
stabilization against signal strength variations is provided
the circuit is the same as in a discriminator, except that the diodes are reversed

⇒ Which of the following is not a conducting material?
Copper
Tungsten
Germanium
Platinum

⇒ The temperature coefficient of resistivity of semiconductors is
positive
negative
may be positive or negative
very low

⇒ Final value theorem is used to find
steady state value of system output
initial value of output
transient beaviour of output
none of these

⇒ When microprocessor processes both positive and negative numbers, the representation used is
l's complement
2's complement
signed binary
any of the above

⇒ A network N is dual of network N if
both of them have same mesh equation
both of them have same node equation
mesh equation of one are the node equations of the other
KCL and KVL equations are the same

⇒ Calculate cut off frequency for dominant mode in rectangular waveguide if dimensions are a = 2, b = 1 cm.
7.5 GHz
1.5 GHz
15 GHz
150 GHz

⇒ For a high pass filter, β = p in attenuation band.
TRUE
FALSE

⇒ A Clapp's oscillator is
a modified Hartley oscillator
a modified Colpitt's oscillator
a modified RC oscillator
none of the above

⇒ Shannon's Law relates
antenna gain to frequency
noise power to bandwidth
information-carrying capacity to S/N ratio
transmission losses to noise

⇒ A signal g(t) = A then g(t) is a
energy signal
power signal
neither energy nor power signal
insufficient data

⇒ For a series R-L-C circuit tuned at resonant frequency which of the following statements is correct?
The voltage across inductance is greater than applied voltage
The voltage across capacitance is greater than applied voltage
The voltage across both inductance and capacitance is greater than applied voltage
The voltage across both inductance and capacitance is less than applied voltage

⇒ The moving iron instruments are generally repulsion type.
TRUE
FALSE

⇒ The permanent magnet field system of brushless dc servo- motor is generally on
stator
rotor
partly on stator and partly on rotor
either (a) or (b)

⇒ A CE amplifier has a high input signal. In the wave shape of emitter current
positive and negative half cycles will be symmetrical
positive half cycle will be elongated and negative half cycle will be compressed
positive half cycle will be compressed and negative half cycle will be elongated
the half cycles may be either elongated or compressed

⇒ If input frequency is 50 Hz, the frequency of output wave in a half wave diode rectifier circuit is
25 Hz
50 Hz
100 Hz
200 Hz