Question is ⇒ In a turnstile antenna the crossed dipoles are excited with voltages, Options are ⇒ (A) in phase with each other, (B) 90° out of phase with each other, (C) 120° out of phase with each other, (D) 180° out of phase with each other, (E) , Leave your comments or Download question paper.

Question is ⇒ In a turnstile antenna the crossed dipoles are excited with voltages, Options are ⇒ (A) in phase with each other, (B) 90° out of phase with each other, (C) 120° out of phase with each other, (D) 180° out of phase with each other, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a turnstile antenna the crossed dipoles are excited with voltages
A.	in phase with each other [Wrong Answer]
B.	90° out of phase with each other [Correct Answer]
C.	120° out of phase with each other [Wrong Answer]
D.	180° out of phase with each other [Wrong Answer]
View Answer 1 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Some typical examples of macroscopic quantities are
conductivity
µ_r
dielectric constant
all of the above

⇒ Two coils are connected in parallel. Their fluxes are adding. If the connections of one of the coils are reversed, the total inductance of the arrangement
will decrease
may increase or decrease
will remain the same
will increase

⇒ The total field produced by an antenna array system at a distance from it is
sum of the field produced by the individual antennas of the array system
directional gain of antenna
linear antenna gain
vector sum of the field produced by the individual antennas of the array system

⇒ The use of SSB
halves the bandwidth required for transmission
does not affect the bandwidth for transmission
decreases the bandwidth required for transmission by 25%
decreases the bandwidth required for transmission by 66.6%

⇒ The main difference between the broadside arrays and end fire arrays is that
individual elements are fed with same current in broadside arrays and of different magnitude in end fire arrays
in broadside arrays the elements are equidistant whereas in end fire array the distance between elements increases progressively
the total number of elements in broadside array is always one and a half times that of elements in end fire arrays
in broadside array the individual elements are fed in, out of phase by 180° whereas in end fire array individual elements are fed with currents of equal magnitude but their phases vary progressively along the line in such a way as to make the entire arrangement substantially unidirectional

⇒ In a FET, g_m varies as
I_DS
I_DS2
1/IDS
I_DS

⇒ In log magnitude Bode diagram the slope of high frequency asymptote of (1 + jωT) is
20 dB per decade
10 dB per decade
20 dB per octave
10 dB per octave

⇒ Consider the following statements about a good power supply:

The a.c. ripple should be high
S_v, (Voltage stability factor) should be low
S_T, (Temperature stability factor) should be low

Which of the above statements are correct?
1, 2 and 3
2 only
3 only
2 and 3 only

⇒ The rotation of direction of E field of a linearly polarized wave passing through a magnetised ferric medium is called
Lorentz rotation
Faraday rotation
Steinmitz rotation
Fleming's rotation

⇒ If A = 629 ± 8 and B = 131 ± 3, A - B with range of doubt is
498 ± 8
498 ± 4
498 ± 11
498 ± 13

⇒ A single phase semiconverter is feeding a highly inductive load and has freewheeling diode across the load. The waveshapes of output voltage and output current
are similar
are not similar
may be similar or dissimilar
are similar only if firing angle is zero

⇒ Consider a baseband binary PAM receiver shown below. The additive channel noise n(t) is whit with power spectral density S_N(f) = N₀/2 = 10^-20 W/Hz. The low-pass filter is ideal with unity gain and cutoff frequency 1 MHz. Let Y_k represent the random variable y(t_k0.5 x e^-3.5
0.5 x e^-5
0.5 x e^-7
0.5 x e^-10

⇒ Which of the following expressions is invalid in Fortran?
IA + IB
IB * IC / ID
IA * B
- K * I + J

⇒ Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded t
the output wave is distorted
the output wave is under modulated
the modulation index is 100%
the modulation index is 50%

⇒ Figure sho
JFET
n-channel MOSFET
p-channel MOSFET
none of the above

⇒ When a pentavalent impurity is added, the semiconductor becomes
p type
n type
intrinsic
neutral

⇒ In operational Amplifier, Common mode voltage gain should be
0
∞
1
0.5

⇒ The spectrum of the white noise and an impulse function is similar in following aspects
both have similar magnitude spectrum
both have similar magnitude and Phase spectrum
no relation
similar phase spectrum

⇒ In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
all calculations done earlier have to be repeated
replace all calculated voltages by reverse values
replace all calculated currents by reverse values
replace all calculated voltages and currents by reverse values

⇒ In 2 out of 5 code, decimal number 8 is
11000
10100
11000
1010

⇒ The series element in band pass filter is
capacitive
inductive
parallel combination of inductance and capacitance
series combination of inductance and capacitance

⇒ In a TV receiver there is no raster, no picture and no sound. The most likely defective stage is
power supply unit
video output circuit
horizontal oscillator
balun

⇒ A surge voltage
has very high magnitude and very long duration
has very high magnitude and very small duration
has very high magnitude and very small duration and can be positive or negative
can be only positive

⇒ As B is increased from zero to about 2T, μ_r, of a ferromagnetic material
increase
decrease
first increases then decreases
remains the same

⇒ A battery charger can drive a current of 5A with 1Ω resistance connected at its output. If it can charge 2 V battery at 7 A rate, its Thevenin's equivalent circuit will be
7.5 in series with 0.5 Ω resistance
1.25 V in series with 1.5 Ω resistance
7.5 V in parallel with 0.5 Ω resistance
12.5 V in parallel with 1.5 Ω resistance

⇒ If u is input, y is output and a, b are constants, the system y = au + b
is linear
is nonlinear
may be linear or nonlinear dependig on values of a and b
may be linear or nonlinear depending on value of u

⇒ An m derived low pass filter has f_c = 1000 Hz, f_∞ = 1250 Hz and m = 0.6. If m is increased, then
both f_c and f_∞ will increase
both f_c and f_∞ will decrease
f_c will remain constant but f_∞ will decrease
f_c will remain constant but f_∞ will increase

⇒ In figure the input and output Miller capacitances
0.25 μF each
500 pF each
0.25 μF and 500 pF respectively
500 pF and 0.25 μF respectively

⇒ In figure, the effective capacitance between A and
2 μF
4 μF
8 μF
10 μF

⇒ Surface impedance at high frequencies is a consideration for
good conductors
semiconductors
dielectrics
ferrites

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math