Question is ⇒ A single phase half wave converter is feeding a resistive load. Output dc power is Pdc and total power delivered to load is Pac then, Options are ⇒ (A) Pdc = Pac for all values of firing angles, (B) Pdc = Pac if firing angle is less than 180°, (C) Pdc < Pac for all values of firing angles, (D) Pdc < Pac if firing angle is less than 180°, (E) , Leave your comments or Download question paper.

Question is ⇒ A single phase half wave converter is feeding a resistive load. Output dc power is Pdc and total power delivered to load is Pac then, Options are ⇒ (A) Pdc = Pac for all values of firing angles, (B) Pdc = Pac if firing angle is less than 180°, (C) Pdc < Pac for all values of firing angles, (D) Pdc < Pac if firing angle is less than 180°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A single phase half wave converter is feeding a resistive load. Output dc power is P_dc and total power delivered to load is P_ac then
A.	P_dc = P_ac for all values of firing angles [Wrong Answer]
B.	P_dc = P_ac if firing angle is less than 180° [Wrong Answer]
C.	P_dc < P_ac for all values of firing angles [Wrong Answer]
D.	P_dc < P_ac if firing angle is less than 180° [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In which function is each term known as minterm?
SOP
POS
Hybrid
Both SOP and POS

⇒ A signum function is
zero for t greater than zero
zero for t less than zero
unity for t greater than zero
2∪(t) - 1

⇒ Which of the following output configurations are available in a TTL gate?

Open collector output
Totem pole output
Tristate output

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ If u is input, y is output and a, b are constants, the system y = au + b
is linear
is nonlinear
may be linear or nonlinear dependig on values of a and b
may be linear or nonlinear depending on value of u

⇒ Consider the sequence x(n) whose fourier transform X(e^jω) is depicted for - p ≤ ω ≤ p as shown in fig
1 - True, 2 - True, 3 - True, 4 - True
1 - False, 2 - True, 3 - False, 4 - True
1 - True, 2 - False, 3 - True, 4 - False
1 - False, 2 - False, 3 - False, 4 - True

⇒ In Bode method of stability analysis, the error curve is not symmetric about corner frequency.
TRUE
FALSE

⇒ Which of the following is the least important consideration while selecting a logic technology?
Power dissipation
Noise immunity
Number of pins
Cost

⇒ Optical encoders most commonly used in control systems are
absolute encoders
secondary encoders
incremental encoders
none of the above

⇒ At a very low temperature, a semiconductor
becomes a conductor
becomes an insulator
may become a conductor or an insulator
will remain a semiconductor becomes a conductor or an insulator

⇒ Troposphere is the portion of atmosphere
nearest to ground
between 50 to 90 km above ground
between 110 to 220 km above ground
between 250 to 350 km above ground

⇒ A crowbar circuit is generally needed for protection under fault conditions.
TRUE
FALSE

⇒ A transponder is a satellite equipment which
receives a signal from Earth station and amplifies
changes the frequency of the received signal
retransmits the received signal
does all of the above-mentioned functions

⇒ The most commonly used logic family is
ECL
TTL
CMOS
PMOS

⇒ When a complex voltage wave is applied to a capacitor the resulting current wave is more distorted than the voltage wave.
TRUE
FALSE

⇒ The simplest standing wave is due to the value of reflection co-efficient is
-1
zero
unity
infinity

⇒ The resistance of a metallic wire would
increase as f increase
decrease as f increase
remains the same at all frequencies
increase with f up to a certain frequency and then decrease

⇒ Read the following statements as regards register pairs in microprocessor 8085

B represents B, C pair with B as high order register and C as low order register.
D represents D, E pair with D as high order register and E as low order register.
H represents H, L pair with H as high order register and L as low order register.

Which of the above statements are correct?
All
1 and 3
1 and 2
2 and 3 only

⇒ Which of the following statement is false?
Bandwidth of a circuit is given by the range of frequencies lying between half-power points
Half-power points on a resonance curve are those points where power is half of that at resonance
Half-power points are also known as 3 dB points
At both half-power points, the p.f. = 0.707 lagging

⇒ TV receivers use flyback switched mode power supply because
it can supply many voltage outputs
it does not require a filter choke and is cheap
it has very good regulation at all loads
both (a) and (c)

⇒ For the system in the given figure the root l
is on real axis between points s = -1 and s = -3.6
is on real axis between points s = 0 and s = -1
is on real axis between points s = -3.6 and s = ∞
is on real axis between points s = 0 and s = -3.6

⇒ Which one is true for writing array variable in Pascal?
The general form of an array variable is an integer or a real variable name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The general form of an array variable must be an integer name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The subscripts in array variable must be separated by dots
The subscripts must be enclosed within parenthesis

⇒ In the analogy between electric and magnetic circuits, flux is analogous to
current
voltage
rate of charge of current
rate of charge of voltage

⇒ An ideal voltage source can not be converted into an equivalent current source.
TRUE
FALSE

⇒ In which of the transformer is the secondary nearly short circuited under normal operating conditions?
CT
PT
Distribution transformer
Power transformer

⇒ The circuit in figure is switched on at t = 0. At any time t, i(t3 + 3e^-1
6 - 3e^-1
3 - 3e^-t
6 - 6e^-1

⇒ In the circuit of figure, the switch is closed at t = 0 with i_L (0) = 0 and V_C (0) = 0. In the steady state n_c equ
100 v
0 v
∞
- 100 v

⇒ TRAP is __________ whereas RST 7.5, RST 6.5, RST 5.5 are __________ .
maskable, non-maskable
maskable, maskable
non-maskable, non-maskable
non-maskable, maskable

⇒ A single phase cycloconverter with centre tapped input transformer requires
2 thyristors
4 thyristors
8 thyristors
either 2 or 4 thyristors

⇒ Which of the following is not a keyword in C?
int
float
return
capital

⇒ In an R-S latch, to set the output to high
R is low and S is high
R and S are high
R and S are low
R is high and S is low

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math