Question is ⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high., Options are ⇒ (A) CMRR, (B) bandwidth, (C) slew rate, (D) open-loop gain, (E) , Leave your comments or Download question paper.

Question is ⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high., Options are ⇒ (A) CMRR, (B) bandwidth, (C) slew rate, (D) open-loop gain, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
A.	CMRR [Wrong Answer]
B.	bandwidth [Wrong Answer]
C.	slew rate [Wrong Answer]
D.	open-loop gain [Correct Answer]
View Answer 2 -8 Explanation:- Answer : D Discuss it below : AKJ ELECTRICAL POINT Said on 2021-11-01 22:16:28 Slew rate !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The minimum charge carried by an ion is
zero
equal to the change of an electron
equal to the change of a pair of electrons
equal to the change of electrons left in the atom

⇒ Which of the statement is correct?
h and g matrices are inverse of each other
z and y matrices are inverse of each other
for reciprocal networks AD - BC = 1
ABCD parameters are used in transistor circuit

⇒ In an homogeneous dielectric subjected to an electric field E, the dipole moment per unit volume is ∈₀(∈_r - 1) E.
TRUE
FALSE

⇒ In forward active region, the operation of a BJT
both junctions are forward biased
both junctions are reverse biased
emitter base junction is forward biased and base collector junction is reverse biased
emitter base junction is reverse biased and base collector junction is reverse biased

⇒ A silicon diode is forward biased and total applied voltage is 5 V. The voltage across p-n junction is
5 V
Slightly less than 5 V
0.7 V
0

⇒ Two capacitors of 1 μF and 2 μF capacitance are connected in parallel across a 30 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be
30 μC each
60 μC each
30 μC and 60 μC respectively
60 μC and 30 μC respectively

⇒ Which of the following is a circularly polarized antenna?
Rhombic
Circular loop
Helical
Yagi

⇒ A permanent magnet moving coil meter can be used as
ac only
dc only
both ac and dc
low frequency ac and dc

⇒ The image frequency of a superheterodyne receiver is
created within the receiver itself
not rejected by IF tuned circuits
independent of the frequency of tuning
due to insufficient adjacent channel rejection

⇒ The voltage across a zener diode
is constant in forward direction
is constant in reverse direction
is constant in both forward and reverse directions
none of the above

⇒ If A = 131 ± 4 and B = 106 ± 4, the percentage range of doubt in A - B is
0.04
0.08
0.16
0.32

⇒ If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is
16.6
44.4
66.6
75

⇒ Two discrete time systems with impulse responses h₁[n] = δ[n - 1] and h₂[n] = δ[n - 2] are connected in cascade. The overall impulse response of the cascaded system is
δ[n - 1] + δ[n - 2]
δ[n - 4]
δ[n - 3]
δ[n - 1] + δ[n - 2]

⇒ When a thyristor is conducting, the voltage drop across it
is absolutely constant
decreases with increase in load current
increases slightly with increase in load current
none of the above

⇒ To measure an emf by dc potentiometer it is necessary to standardise the potentiometer with the help of a standard cell.
TRUE
FALSE

⇒ In a computer the data transfer between hard disk and CPU is nearly the same as that between diskette and CPU.
TRUE
FALSE

⇒ A planar array radar uses a high gain planar array antenna.
TRUE
FALSE

⇒ Which group of instructions is used to change sequence of operations in a computer program?
Data transfer group
Branch group
Arithmetic group
Logic group

⇒ Which one of the following cannot be used to remove the unwanted sideband in SSB?
Balanced modulator
Phase shift method
Filter system
Third method

⇒ The internal structure of PL A is similar to
RAM
ROM
both RAM and ROM
neither RAM nor ROM

⇒ Which of the following circuit has the greatest bandwidth?
f_r = 455 MHz; Q = 10
f_r = 455 MHz; Q = 100
f_r = 1 MHz; Q = 100
f_r = 1 MHz; Q = 10

⇒ In brushless excitation system of modern alternators, the main exciter is
dc generator
ac generator
either dc or ac generator
induction generator

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
0.76, 0.24
0.95, 0.3
0.24, 076
0.3, 0.95

⇒ The binary addition 1 + 1 =
11
10
111
100

⇒ At room temperature a semiconductor material is
perfect insulator
conductor
slightly conducting
any of the above

⇒ The read and write cycle times of cache memory are in the range of
1 - 3 ns
25 ns - 45 ns
200 ns - 300 ns
1 μs

⇒ In end fire array the principle direction of radiation
is perpendicular to the array axis
is perpendicular to the array axis and also to the plane containing the array elements
coincides with the direction of the array
is at 45° to the direction of array axis

⇒ To convert SR latch to D latch
connect both S and R to D
connect D to S directly and D to R through inverter
connect D to R directly and D to S through inverter
connect S to D and leave R open

⇒ IC (instruction cycle), FC (fetch cycle) and EC (executive cycle) are related as
IC = FC - EC
IC = FC + EC
IC = FC + 2EC
EC = IC + EC

⇒ The minimum gate current which can turn on SCR is called :
trigger current
holding current
junction current
breakover current