Question is ⇒ Which of the following 8085 instructions does not belong to arithmetic group?, Options are ⇒ (A) <code>SHLD addr</code>, (B) <code>SUI data</code>, (C) <code>ADCM</code>, (D) <code>INR r</code>, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following 8085 instructions does not belong to arithmetic group?, Options are ⇒ (A) <code>SHLD addr</code>, (B) <code>SUI data</code>, (C) <code>ADCM</code>, (D) <code>INR r</code>, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following 8085 instructions does not belong to arithmetic group?
A.	`SHLD addr` [Correct Answer]
B.	`SUI data` [Wrong Answer]
C.	`ADCM` [Wrong Answer]
D.	`INR r` [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I (Comm.services)		List II (Bandwidth)
A.	AM broadcast	1.	10 kHz
B.	Telephone	2.	4 kHz
C.	wide-band FM	3.	200 kHz
D.	TV	4.	7 MHz

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-1, B-4, C-3, D-2
A-3, B-2, C-1, D-4

⇒ A 750 A circuit uses thyristor of current rating 175 A. If derating is 25%, the number of thyristors in parallel is
3
4
6
10

⇒ When an ac circuit has sources of different frequencies, the only method of analysis is superposition theorem.
TRUE
FALSE

⇒ Hollow waveguides are used as transmission lines at frequencies
above 1 GHz
above 5 GHz
above 10 MHz
above 1 MHz

⇒

Assertion (A): The gate current of an SCR is always in the form of pulses.

Reason (R): The gate losses, in pulse triggering, are low.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Bellows converts
pressure difference into displacement
pressure difference into voltage
displacement into pressure difference
either (a) or (c)

⇒ The breakdown voltage in a zener diode
is almost constant
is very small
may destroy the diode
decreases with increase in current

⇒ For BJT transistor. The maximum power dissipation is specified as 350 mW if ambient temperature is 25°C. If ambient temperature is 60°C the maximum power dissipation should be limited to about
100 mW
250 mW
450 mW
600 mW

⇒ If resistance is 20 Ω and inductance is 2 H in a R-L series circuit, then time constant of this will be
0.001 s
0.1 s
10 s
100 s

⇒ In waveguide Degenerate modes are
two mode having same cut off frequency
two mode having same power
two mode having same phase velocity
it is a hypothetical mode

⇒ To realize the full power of 8086 the pin of 8086 connected to ground is
DEN
ALE
INTR
MN / MX

⇒ Which of the following circuits cannot be demodulate SSB?
Product detector
Balanced modulator
Phase discriminator
BFO

⇒ A heterodyne frequency changer is called a
Modulator
Mixer
Demodulator
Frequency translator

⇒ A dc circuit breaker must use
natural commutation
forced commutation
both natural and forced commutation
either natural or forced commutation

⇒ The advantage of semiconductor strain gauge over resistance strain gauge is
it is more sensitve
it is more linear
it is less temperature dependent
it is cheaper

⇒ To realize following function 'f'3
6
4
10

⇒ In the 8421 BCD code, the decimal number 125, is written as
1111101
0001 0010 0101
7 D
none of these

⇒ The resistance of resistance strain gauge is about
5 Ω
50 Ω
120 Ω
0.5 Ω

⇒ Consider the following statement: In case of a superconductor
B = 0
μ_r is high
diamagnetism is high
transition temperature varies with isotopic mass.
Of the above statements
1 and 2 are correct
2, 3, 4 are correct
1, 3, 4 are correct
2, 4 are correct

⇒ An integrating amplifier has resistance in feedback path.
TRUE
FALSE

⇒ The upper and lower side frequencies for 3 kHz audio modulation with a 27 MHz carrier frequency will be
30 and 24 MHz
27.3 and 26.7 MHz
27.3 and 26.97 MHz
27.3 and 26.97 MHz

⇒ In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
class A
class B
class C
class AB

⇒ Soft iron is suitable for making temporary magnets.
TRUE
FALSE

⇒ A series circuit has fixed resistance and variable reactance. The impedance locus will be a straight line parallel to Y-axis.
TRUE
FALSE

⇒ For the switch circuit, taking open as 0 and closed as 1, the expression for the circuit is Y. Y is give
A + (B + C) D
A + BC + D
A(BC + D)
none of these

⇒ Consider the following state
1 only
1 and 2
2 only
3 only

⇒ ARQ stands for
Automatic Repeat Quest
Analog Repeat Request
Automatic Repeat Request
None Of the above

⇒ When the mains supply is switched off the contents of primary computer memory are lost.
TRUE
FALSE

⇒ The emitter coupled pair of BJT's gives a linear transfer relation between the differential output voltage and the differential input voltage V_id only when the magnitude of V_id is less a times the thermal voltage, where a is
4
3
2
1

⇒ In a power diode the reverse recovery time is the time from the instant the forward current is zero to the instant when reverse recovery current has decayed to
50% of peak reverse current
25% of peak reverse current
10% of peak reverse current
zero value

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math