Question is ⇒ In case of a low level AM transmitter, the amplifier modulated stage must be, Options are ⇒ (A) class A, (B) class B, (C) class B (linear), (D) class C, (E) , Leave your comments or Download question paper.

Question is ⇒ In case of a low level AM transmitter, the amplifier modulated stage must be, Options are ⇒ (A) class A, (B) class B, (C) class B (linear), (D) class C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In case of a low level AM transmitter, the amplifier modulated stage must be
A.	class A [Wrong Answer]
B.	class B [Wrong Answer]
C.	class B (linear) [Correct Answer]
D.	class C [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ What does the instruction 'PCHL' in 8085 do?
Load the program counter with contents of register pair H L
Double the contents of register pair H L
Shift the contents of register pair H L by one bit to the right
Shift the contents of register pair H L by one bit to left

⇒ Which of the following statement is correct?
A FET is a current controlled device
A BJT is always reverse biased
The semi-conductor material of the gate in an N-channel JFET is p-type
JFET has higher input impedance than MOSFET

⇒ Debye temperature of metals is
about 10 K
about 200 K
about 600 K
about 2 K

⇒ Which of the following is not a DTP program?
Page maker
Coral draw
Coral ventura
Coral key

⇒ Sometimes the rotating devices in a room having fluorescent lamps appear to be any station. This is due to
defect in the lamp
low voltage
high voltage
stroboscopic effect

⇒ The poles with greater displacement from the real axis correspond to
higher frequencies of oscillations
stable response
lower frequencies of oscillations
unbounded output

⇒ The equivalent resistance between terminals x and y figur
150 Ω
45 Ω
55 Ω
35 Ω

⇒ In fi
Wave A is lagging wave B by ∠θ
Wave A is leading wave B by ∠θ
Wave A is lagging wave B by ∠θ and the two waves have same rms values
Wave A is lagging wave B by ∠θ and the two waves have different rms values

⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above

⇒ If poles lie in first quadrant, damping ratio is
1
more than 1
less than 1
zero

⇒ Which of the following devices exhibit negative resistance characteristics?
UJT
PUT
Both UJT and PUT
UJT, PUT and SBS

⇒ The precision of an instrument indicates its ability to reproduce a certain reading with a given
drift
resolutions
shift
consistency

⇒ End fire coupler is formed
when two equal radiators are operated in phase quadrature at a distance of λ/4 apart
when two equal radiators are operated in parallel at a distance of λ/4 apart
when two equal radiators are operated in phase quadrature at a distance of λ/2 apart
none of the above

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ Armstrong F.M. transmitter performs frequency multiplication in stages
to increase the overall S/N
for convenience
to reduce the bandwidth
to find the desired value of carrier frequency with frequency deviation

⇒ The two conductors of a single phase transmission line suspended in air carry currents in opposite directions. The force per unit length on each conductor varies
directly as the current in either conductor
directly as the distance between the two conductors
directly as the square of the current in either conductor
inversely as the square of the distance between the two conductors

⇒ The disadvantage of counter type ADC as compared to comparator ADC is that
resolution is low
conversion time is more
circuit is more complex
stability is low

⇒ In metals the thermal conductivity K and electrical conductivity σ are related as (K/σT) = L, L is known as
Lattice constant
Lorentz number
Lanevin function
Larmor number

⇒ Figure shows an 8-bit LED display. A light circle means that a LED is ON (binary 1) and a dark circle means a LED is OFF (binary 0). What is the decimal equivalent of the binary number displa
100
121
144
172

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ By the use of which of the following the PPM can be converted to PWM?
A stable multivibrator
Integrator
Monostable multivibrator
Bistable Multivibrator

⇒ Rise time in a transistor is change from
10% of its final value to 90% of its final value
0% of its final value to 90% of its final value
10% of its final value to 100% of its final value
10% to its final value to 50% of its final value

⇒ Which of the following is active transducer?
Photoelectric
Photovoltaic
Photoconductive
Photoemissive

⇒ The discussing sharing of a communication satellite by many geographically dispersed Earth station, DAMA means
Demand-Assigned Multiple Access
Decibel Attenuated Microwave Access
Digital Analog Master Antenna
Dynamically-Assigned Multiple Access

⇒ Which one of the following is loaded in the main memory by the bootstrap loader?
System data
User program
BIOS
Part of DOS

⇒ Which of the following identifiers is invalid in Pascal?
BETA
MAX 40
2ND
A MAX

⇒ For the given circuit, the current
0.0833333333333333
0.208333333333333
0.291666666666667
0.333333333333333

⇒ In AM increased depth of modulation increases __________ and in FM with increased depth of modulation __________ increases.
total transmitted power, bandwidth
bandwidth, bandwidth
bandwidth, total transmitted power
total transmitted power, sideband power

⇒ The two numbers represent in signed 2's complement form are P = 11101101 and Q = 111001110. If Q subtracted from P, the value obtained in signed 2's complement form is
100000111
111
11111001
111111001

⇒ The main advantage of TDM over FDM is
TDM requires more bandwidth than FDM
less complicated in hardware than FDM
better SNR
required filter