Question is ⇒ Four voltmeters have following specifications. If accuracy is main consideration which is the best?, Options are ⇒ (A) 100 V, 2 mA, (B) 100 V, 100 mA, (C) 100 V, 1 mA, (D) 100 V, 0.1 mA, (E) , Leave your comments or Download question paper.

Question is ⇒ Four voltmeters have following specifications. If accuracy is main consideration which is the best?, Options are ⇒ (A) 100 V, 2 mA, (B) 100 V, 100 mA, (C) 100 V, 1 mA, (D) 100 V, 0.1 mA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Four voltmeters have following specifications. If accuracy is main consideration which is the best?
A.	100 V, 2 mA [Wrong Answer]
B.	100 V, 100 mA [Wrong Answer]
C.	100 V, 1 mA [Wrong Answer]
D.	100 V, 0.1 mA [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Hay bridge is suitable for measuring inductance of which one of the following inductors?
Having Q value less than 10
Having Q value greater than 10
Having any value of Q
Having phase angle of reactance very large

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Developed by)
A.	CCD charger	1.	Toshiba
B.	New vicon	2.	Philips
C.	Plumbicon	3.	Matushita
D.	Chalnicon	4.	RCA

A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-1, B-2, C-3, D-4

⇒ In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
9 kΩ
6 kΩ
3 kΩ
2 kΩ

⇒ Audio and video signals are called modulating waves.
TRUE
FALSE

⇒ The radiation resistance of a rod tubing antenna is
55 Ω to 60 Ω
60 to 100 Ω
0 to 377 Ω
60 to 200 Ω

⇒ As temperature increases the number of free electrons and holes in an intrinsic semiconductor
increases
decreases
remains the same
may increase or decrease

⇒ Performance of a PIN diode switch is represented by
insertion loss when switch is off
insertion loss when switch is on
insertion loss when switch is on and isolation loss when switch is off
insertion loss when switch is off and isolation loss when switch is on

⇒ The shunt admittance of a transmission line is given by
γ = R + jωL
γ = R - jωL
γ = G + jωC
γ = jωGC

⇒ A fully controlled bridge converter can operate in quadrants
1
1 and 2
1 and 3
1 and 4

⇒ To find current in a resistance connected in a network, Thevenin's theorem is used V_TH = 20 V and R_TH = 5 Ω. The current through the resistance
is 4 A
is 4 A or less
is less than 4 A
may be 4 A or less or more than 4 A

⇒ The number of product terms in the minimized sum of product expression obtained through the following k map is (where "d" denotes don't care states)
2
3
4
5

⇒ A ripple counter has propagation delay.
TRUE
FALSE

⇒ If F_n represents Fourier series coefficient of f(t), then Fourier series coefficient of f(t + t) =
F_ne ^-jω₀^t
F_ne ^jω₀^t
F_ne ^jnω₀^t
F_ne ^-jnω₀^t

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases

⇒ When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common base short circuit current gain a for the transistor is
0.99
1.01
1.001
0.99

⇒ The sum S of A and B in a Half Adder can be implemented by using K NAND gates. The value of K is
3
4
5
none of these

⇒ A coil with large distributed capacitance has a
high resonant frequency
low resonant frequency
low quality factor
low resistance

⇒ Boolean algebra obeys
commutative law
associative law
distributive law
commutative, associative and distributive law

⇒ Consider the following statements in connection with CMOS inverter in figure where both the MOSFET are of enhancement type and both have a threshold voltage of
Only statement 1 is true
Only statement 2 is true
Both the statement are true
Both the statements are false

⇒ The circuit of figur
clipper, sine wave clipped at - 2 V
clamper
clamper, sine wave clamped at zero V
clipper, sine wave clipped at + 2 V

⇒ Logic pulser
generates short duration pulses
generates long duration pulses
generates sinusoidal voltage
generates ideal pulses

⇒ What is the necessary a.c. input power from the transformer secondary used in a half wave rectifier to deliver 500 W of d.c. power to the load?
1232 W
848 W
616 W
308 W

⇒ In figure V_CC = + 30 V, I_C corresponding to Q point is 1 mA. If R_C = 5 kΩ and R_E = 5 kΩ, V_CE corresponding to Q poin
30 V
20 V
25 V
5 V

⇒ The input to integrating op-amp is a rectangular wave. The output will be
a sine wave
a rectangular wave
a triangular wave
none of the above

⇒ In figure, Z₁ = 200∠60° Ω, Z₂ = 400∠ - 90° Ω, Z₃ = 300∠0°. Then Z₄ for bridge to be balanced
150∠30° Ω
400∠ - 90° Ω
300∠90° Ω
600∠ - 150° Ω

⇒ If a number of even functions are added, the resultant sum is
even function
odd funtion
either even or odd function
mixture of odd amd even functions

⇒ The number of spectral component when two sine wave of same frequency multiplied is
2
3
∞
4

⇒ A series resonant circuit has parameters 10 ω, 1 H and 0.1 F. It is excited by a voltage v = 100 sin ωt. At resonant frequency, the power dissipated in the circuit is
1000 W
707 W
500 W
414.14 W

⇒ A push pull amplifier is a
power amplifier
voltage amplifier
current amplifier
both power and current amplifier

⇒ Three resistances of 15 Ω, 10 Ω and 3 Ω are connected in parallel. The overall resistance is
less than 3 Ω
between 15 and 10 Ω
between 10 and 3 Ω
more than 3 Ω