Question is ⇒ The concept on which Superposition theorem is based is, Options are ⇒ (A) reciprocity, (B) duality, (C) non-linearity, (D) linearity, (E) , Leave your comments or Download question paper.

Question is ⇒ The concept on which Superposition theorem is based is, Options are ⇒ (A) reciprocity, (B) duality, (C) non-linearity, (D) linearity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The concept on which Superposition theorem is based is
A.	reciprocity [Wrong Answer]
B.	duality [Wrong Answer]
C.	non-linearity [Wrong Answer]
D.	linearity [Correct Answer]
View Answer 17 -13 Explanation:- Answer : D Discuss it below : Nikhil Said on 2020-05-24 00:49:22 A network in which electrical properties are NOT changed when the input and output terminals are interchanged is called * 1 point (A) Symmetrical network (B) Linear network (C) Bilateral network (D) Unilateral network !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An ideal voltage source should have
large emf.
small emf.
zero resistance.
none of these.

⇒ In a series parallel circuit, any two resistances in the same current path must be in
series with each other
parallel with each other
series with the voltage source
parallel with the voltage source

⇒ A, B, C and D represent the transmission parameters of a two-port network. When is the network reciprocal?
AB - CD = 1.
AD - BC = 1.
AB - CD = 0.
AD - BC = 0.

⇒ The circuit having same properties in either direction is known as____circuit.
bilateral
unilateral
irreversible
reversible

⇒ According to Kirchhoff's voltage law, the algebraic sum of all IR drops and e.m.fs. in any closed loop of a network is always
negative
positive
determined by battery e.m.fs.
zero

⇒ A dependent source
may be a current source or a voltage source
is always a voltage source
is always a current source
neither a current source nor a voltage source

⇒ While calculating R_th in Thevenin's theorem and Norton equivalent
all independent sources are made dead
only current sources are made dead
only voltage sources are made dead
all voltage and current sources are made dead

⇒ Kirchhoff's voltage law is concerned with
IR drop.
battery emf.
junction voltage.
both (a) and (b).

⇒ For a voltage source
terminal voltage is always lower than source e.m.f.
terminal voltage cannot be higher than source e.m.f.
the source e.m.f. and terminal voltage are equal

⇒ Millman's theorem yields
equivalent resistance
equivalent impedance
equivalent voltage source
equivalent voltage or current source

⇒ Kirchhoff's current law is applicable to only
junction in a network
closed loops in a network
electric circuits
electronic circuits

⇒ Maxwell' s loop current method of solving electrical networks
uses branch currents.
utilizes Kirchhoff' s voltage law.
is confined to single-loop circuits
is a network reduction method.

⇒ There are b branches and n nodes the number of equations will be
n - 1
b
b - n
b - n + 1

⇒ Aterininalwhere three on more branches meet is known as
node
terminus
combination
anode

⇒ To determine the polarity ofthe voltage drop across a resistor, it is necessary to know
value of current through the resistor
direction of current through the resistor
value of resistor
e.m.fs. in the circuit

⇒ An ideal voltage source should have
large value of emE
small value of e.m.f.
zero source resistance
infinite source resistance

⇒ A voltage source having an open-circuit voltage of 100 V and internal resistance of 50 ω is equivalent to a current source
2 A in parallel with 50 ω.
2 A with 50 ω in series
0.5 A in parallel with 50 ω
A in parallel with 100 ω

⇒ For high efficiency of transfer of power, internal resistance of the source should be
equal to the load resistance
less than the load resistance
more than the load resistance
none of the above

⇒ If the number of branches in a network is 'B', the number of nodes is 'N' and the number of dependent loops is 'L' then the number of independent node equations will be
N + L - 1
B - 1
B - N
N - 1

⇒ Which of the following is the passive element?
Capacitance
Ideal current source
Ideal voltage source
All of the above

⇒ A closed path made by several branches of the network is known as
branch
loop
circuit
junction

⇒ A delta circuit has each element of value R/2. The equivalent elements of star circuit with be
R/6
R/3
2R
3R

⇒ Which of the following is linear and bilateral parameter ?
resistors
semi-conductor diodes
electron tubes
transistor

⇒ A capacitor is generally a
bilateral and active component
active, passive, linear and nonlinear component
linear and bilateral component
non-linear and active component

⇒ The superposition theorem is applicable to
linear, non-linear and time variant responses
linear and non-linear resistors only
linear responses only
none of the above

⇒ Which of the following is an active element in a circuit?
Current source
Resistance.
Inductance.
Capacitance.

⇒ A network has 4 nodes and 3 independent loops. What is the number of branches in the network?
5
6
7
8

⇒ Kirchhoff's voltage law is related to
junction currents
battery e.m.fs
IR drops
both (b) and (e)

⇒ Kirchhof's voltage law applies to circuits with
non-linear elements only
linear elements only
linear, non-linear, active and passive elements
linear, non-linear, active, passive, time varying as wells as time-invariant elements

⇒ The number of independent equations to solve a network is equal to
the number of chords
the number of branches
sum of the number of branches and chords
sum of number of branches, chords and nodes