Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | A star circuit has element of resistance R/2. The equivalent delta elements will be |

A. | R/6 [Wrong Answer] |

B. | 3/2R [Correct Answer] |

C. | 2R [Wrong Answer] |

D. | 4R [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ For a voltage source

terminal voltage is always lower than source e.m.f.

terminal voltage cannot be higher than source e.m.f.

the source e.m.f. and terminal voltage are equal

⇒ A, B, C and D represent the transmission parameters of a two-port network. When is the network reciprocal?

AB - CD = 1.

AD - BC = 1.

AB - CD = 0.

AD - BC = 0.

⇒ The elements which are not capable of delivering energy by its own are known as

unilateral elements.

nonlinear elements.

passive elements.

active elements

⇒ For maximum transfer of power, internal resistance of the source should be

equal to load resistance

less than the load resistance

greater than the load resistance

none of the above

⇒ Which of the following theorems can be applied to any network linear or nonlinear, active or passive, time-variant or time-invariant?

Thevenin theorem

Norton theorem

Tellegen theorem

Superposition theorem

⇒ Millman's theorem yields

equivalent resistance

equivalent impedance

equivalent voltage source

equivalent voltage or current source

⇒ For a voltage source

terminal voltage is equal to the source emf.

terminal voltage cannot exceed source emf.

terminal voltage is always lower than source emf.

terminal voltage is higher than the source emf.

⇒ An electric circuit with 10 branches and 7 nodes will have

3 loop equations.

4 loop equations

7 loop equations

10 loop equations.

⇒ The circuit having same properties in either direction is known as____circuit.

bilateral

unilateral

irreversible

reversible

⇒ What is the number of chords of a connected graph G of n vertices and e edges?

n(n - 1)/2

n - 1

e - n - 1

e - n + 1

⇒ An ideal voltage source should have

large emf.

small emf.

zero resistance.

none of these.

⇒ The theorem that enables a number of voltage (or cuiTent) sources to be combined directly into a single voltage (or current) source is the____ theorem.

compensation

reciprocity

Millman's

Maxwell's

⇒ Which of the following is the passive element?

Capacitance

Ideal current source

Ideal voltage source

All of the above

⇒ A star circuit has element of resistance R/2. The equivalent delta elements will be

R/6

3/2R

2R

4R

⇒ Which of the following is a bilateral element?

Constant current source

Constant voltage source

Capacitance

None of the above

⇒ Which of the following is non-linear circuit parameter?

Inductance

Condenser

Wire wound resistor

Transistor

⇒ "Maximum power output is obtained from a network when the load resistance is equal to the output resistance of the network as seen from the terminals of the load".

The above statement is associated with

Millman's theorem

Thevenin's theorem

Superposition theorem

Maximum power transfer theorem

⇒ The superposition theorem is applicable to

voltage only

current only

both current and voltage

current voltage and power

⇒ Kirchhoff's current law is applicable to only

junction in a network

closed loops in a network

electric circuits

electronic circuits

⇒ The lowest and the highest critical frequencies of an R-L driving point impedance are, respectively

a zero, a pole

a pole, a pole

a zero, a zero

a pole, a pole

⇒ Between the branch voltages of a loop the KirchhofFs voltage law imposes

non-linear constraints

linear constraints

no constraints

none of the above

⇒ Which of the following is linear and bilateral parameter ?

resistors

semi-conductor diodes

electron tubes

transistor

⇒ A constant current source supplies a current of 300 mA to a load of 1 kω. When the load is changed to 100 ω, the load current will be

3 A

300 mA

30 mA

100 mA

⇒ A closed path made by several branches of the network is known as

branch

loop

circuit

junction

⇒ Ideal current source have

zero internal resistance.

infinite internal resistance.

low value of voltage.

large value of current.

⇒ The poles and zeroes of an all-pass network are located in which part of the s-plane?

Poles and zeroes are in the right half s-plane.

Poles and zeroes are in the left half s-plane.

Poles in right half and zeroes in left half of s-plane.

Poles in the left half and zeroes in right half of s-plane.

⇒ There are b branches and n nodes the number of equations will be

n - 1

b

b - n

b - n + 1

⇒ Efficiency of power transfer when maximum transfer of power occurs is

100%

80%

75%

50%

⇒ An ideal voltage source has

zero internal resistance

open circuit voltage equal to the voltage on full load

terminal voltage in proportion to current

terminal voltage in proportion to load

⇒ While Thevenizing a circuit between two terminals, V

_{TH}is equal to

short-circuit terminal voltage.

open-circuit terminal voltage.

net voltage available in the circuit.

emf of the battery nearest to the terminals.