Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | A voltage source having an open-circuit voltage of 100 V and internal resistance of 50 ω is equivalent to a current source |

A. | 2 A in parallel with 50 ω. [Correct Answer] |

B. | 2 A with 50 ω in series [Wrong Answer] |

C. | 0.5 A in parallel with 50 ω [Wrong Answer] |

D. | A in parallel with 100 ω [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Which of the following is non-linear circuit parameter?

Inductance

Condenser

Wire wound resistor

Transistor

⇒ The lowest and the highest critical frequencies of an R-L driving point impedance are, respectively

a zero, a pole

a pole, a pole

a zero, a zero

a pole, a pole

⇒ Millman's theorem yields

equivalent resistance

equivalent impedance

equivalent voltage source

equivalent voltage or current source

⇒ For a voltage source

terminal voltage is equal to the source emf.

terminal voltage cannot exceed source emf.

terminal voltage is always lower than source emf.

terminal voltage is higher than the source emf.

⇒ According to Kirchhoff's voltage law, the algebraic sum of all IR drops and e.m.fs. in any closed loop of a network is always

negative

positive

determined by battery e.m.fs.

zero

⇒ Which of the following theorems is applicable for both linear and nonlinear circuits ?

Superposition.

Thevenin's.

Norton's.

None of these.

⇒ In a balanced Wheatstone bridge, if the positions of detector and source are interchanged, the bridge will still remain balanced. This inference can be drawn from

reciprocity theorem.

duality theorem.

compensation theorem.

equivalence theorem.

⇒ Efficiency of power transfer when maximum transfer of power occurs is

100%

80%

75%

50%

⇒ Kirchhoff's s law is applicable to

passive networks only

a.c. circuits only

d.c. circuits only

both ac. as well d.c. circuits

⇒ A passive 2-port network is in a steady-state. Compared to its input, the steady state output can never offer

higher voltage

lower impedance

greater power

better regulation

⇒ Kirchhoff' s laws are valid for

linear circuits only.

passive time invariant circuits.

nonlinear circuits only.

both linear and nonlinear circuits

⇒ A dependent source

may be a current source or a voltage source

is always a voltage source

is always a current source

neither a current source nor a voltage source

⇒ The superposition theorem requires as many circuits to be solved as there are

sources, nodes and meshes

sources and nodes

sources

nodes

⇒ An ideal voltage source should have

large value of emE

small value of e.m.f.

zero source resistance

infinite source resistance

⇒ Kirchhoff's voltage law is related to

junction currents

battery e.m.fs

IR drops

both (b) and (e)

⇒ In Thevenin's theorem, to find Z

all independent current sources are short circuited and independent voltage sources are open circuited

all independent voltage sources are open circuited and all independent current sources are short circuited

all independent voltage and current sources are short circuited

all independent voltage sources are short circuited and all independent current sources are open circuited

⇒ Maxwell' s loop current method of solving electrical networks

uses branch currents.

utilizes Kirchhoff' s voltage law.

is confined to single-loop circuits

is a network reduction method.

⇒ For a voltage source

terminal voltage is always lower than source e.m.f.

terminal voltage cannot be higher than source e.m.f.

the source e.m.f. and terminal voltage are equal

⇒ The circuit has resistors, capacitors and semi-conductor diodes. The circuit will be known as

non-linear circuit

linear circuit

bilateral circuit

none of the above

⇒ A star circuit has element of resistance R/2. The equivalent delta elements will be

R/6

3/2R

2R

4R

⇒ Which of the following statements is/are correct?

Norton's equivalent resistance is the same as Thevenin's equivalent resistance R

_{TH}.

Norton's equivalent is the current equivalent of the network.

The load is connected in parallel to the Norton's equivalent resistance and Norton' s equivalent current source.

all of the above.

⇒ If a circuit does not contain any source of energy or e.m.f. it is known as

unilateral circuit

bilateral circuit

passive network

active network

⇒ A constant current source supplies a current of 300 mA to a load of 1 kω. When the load is changed to 100 ω, the load current will be

3 A

300 mA

30 mA

100 mA

⇒ A linear resistor having 0 < R < ∞ is a

current controlled resistor

voltage controlled resistor

both current controlled and voltage controlled resistor

none of the above

⇒ A network which contains one or more than one source of e.m.f. is known as

linear network

non-linear network

passive network

active network

⇒ Kirchhoff's law is not applicable to circuits with

lumped parameters

passive elements

distributed parameters

non-linear resistances

⇒ If the energy is supplied from a source, whose resistance is i ohm, to a load of loo ohms the source will be

a voltage source

a current source

both of above

none of the above

⇒ To determine the polarity ofthe voltage drop across a resistor, it is necessary to know

value of current through the resistor

direction of current through the resistor

value of resistor

e.m.fs. in the circuit

⇒ Ideal voltage source have

zero internal resistance.

infinite internal resistance.

low value of current.

large value of emf.

⇒ For maximum transfer of power, internal resistance of the source should be

equal to load resistance

less than the load resistance

greater than the load resistance

none of the above