Question is ⇒ In the following network, the switch is closed at t = 0 and the sampling starts from t = 0. The sampling frequency is 1, Options are ⇒ (A) 5(1 - e-0.05n), (B) 5e-0.05n, (C) 5(1 - e-5n), (D) 5e-5n, (E) , Leave your comments or Download question paper.

Question is ⇒ In the following network, the switch is closed at t = 0 and the sampling starts from t = 0. The sampling frequency is 1, Options are ⇒ (A) 5(1 - e-0.05n), (B) 5e-0.05n, (C) 5(1 - e-5n), (D) 5e-5n, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the following network, the switch is closed at t = 0 and the sampling starts from t = 0. The sampling frequency is 1
A.	5(1 - e^-0.05n) [Wrong Answer]
B.	5e^-0.05n [Correct Answer]
C.	5(1 - e^-5n) [Wrong Answer]
D.	5^e-5n [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Panel instruments are generally mounted vertically.
TRUE
FALSE

⇒ Which one is not correct for folded dipole antenna?
High I/P impedance
Low I/P impedance
High bandwidth
Used as reactance compensation network

⇒ Two voltages 50 V each have a phase difference of 45°. The rms value of resultant sum of the two voltages is
70.7 V
80.4 V
92.4 V
100 V

⇒ The block diagram of AM transmitter in which high level modulation is used as shown in figure. The block X could
audio power amplifier
buffer RF amplifier
compressor amplifier
none of the above

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ Wave A = 100 sin ωt and wave B = 100 cos ωt. Then
rms values of the two waves are equal
rms values of A is more than that of B
rms values of A is less than that of B
rms values of the two waves may or may not be equal

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ In AM receiver the oscillator frequency is
always equal to signal frequency
always equal to 455 kHz
always higher than signal frequency
always lower than signal frequency

⇒ Which characteristics of a memory chip is called dc characteristics?
Organisation
Timing characteristics
Physical dimensions
Power consumption and bus loading

⇒ If it is desired to tabulate number of students in a class in Fortran language, a proper variable name is
ST
STUD
NSTUD
STD

⇒ The F.T. of a conjugate symmetric function is always
imaginary
real
conjugate Unsymmetric
conjugate symmetric

⇒ Standard AM radio broadcasts are confined to
MF
HF
VHF
UHF

⇒ The wave in wave guide has
group velocity inversely proportional to wavelength
larger frequency than in the free space
diminishing wavelength than in the free space
larger wavelength than in the free space

⇒ Audio cassettes used in household tape recorders have a width of
1"
1/2"
1/4"
1/8"

⇒ De-emphasis circuit is used
to attenuate high frequencies
to attenuate low frequencies
to attenuate mid-band frequencies
None of the above

⇒ A 0-200 V voltmeter has a sensitivity of 1 kΩ per volt. The resistance of voltmeter is
1 kΩ
200 kΩ
100 kΩ
50 kΩ

⇒ The voltage of the source in circuit shown __________ if i(t) = - 20e^{-2t46.6 e^-2t
47 e^-2t
50 e^-2t
0}

⇒ The sign of a floating point number depends on
only the sign of mantissa
only the sign of exponent
the sign of both mantissa and exponent
either (a) or (b)

⇒ Which inductor is linear?
Air cored
Cast iron cored
Sheet steel cored
Iron alloy cored

⇒

Assertion (A): Heaviside partial expansion gives a simple procedure to find inverse Laplace transform of the terms having a complex conjugate pair of roots.

Reason (R): If I(s) = P(s)/Q(s) and all roots of Q(s) = 0 are simple, i(t) will have terms with exponentials having real exponents only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which of the following will be hexadecimal number just for prior to F52B?
E 51 A
F 51 B
E 52 B
F 52 A

⇒ In figure the output V₀
2V₁ + V₂ - 2V₃
2(V₁ + V₂) - V₃
V₁ + V₂ + V₃
V₁ + 2V₂ - V₃

⇒ The number of registers and flags in 8086 are
13 and 5 respectively
9 and 5 respectively
13 and 9 respectively
9 and 9 respectively

⇒ In a line VSWR of a load is 6 dB. The reflection coefficient will be
0.033
0.33
0.66
3.3

⇒ A P-N junction offers
high resistance in forward as well as reverse direction
low resistance in forward as well as reverse direction
conducts in forward direction only
conducts in reverse direction only

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒ In an SCR, the anode current consists of
only holes
only electrons
both electrons and holes
either electrons or holes

⇒ Which device changes parallel data to serial data?
Decoder
Multiplexer
Demultiplexer
Flip flop

⇒ A series resonant circuit has R = 10 Ω, L = 1 μH and C = 1 mF. If R is increased to 20 Ω the resonant frequency
increases
decreases
remains constant
may increases or decreases

⇒ Power is drawn from a source at power factor 0.7. P_av = 300 watt. The reactive power is
0
105
100 VA
107 VA