Question is ⇒ Which one of the following is analog?, Options are ⇒ (A) PCM, (B) PWM, (C) Delta modulation, (D) Differential PCM, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following is analog?, Options are ⇒ (A) PCM, (B) PWM, (C) Delta modulation, (D) Differential PCM, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following is analog?
A.	PCM [Wrong Answer]
B.	PWM [Correct Answer]
C.	Delta modulation [Wrong Answer]
D.	Differential PCM [Wrong Answer]
View Answer 3 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure the diode is ideal (zero cut in voltage zero forward resistance). Then the current through diod
0
0.166666666666667
0.0416666666666667
none of the above

⇒ In the signal flow graph of figure, y/x equ
3
42857
2
None of the above

⇒ It is desired that transmission line and load should match for a range of frequencies. The best method is
to use a balun
to use a single stub of adjustable position
to use a double stub
to use a broad band amplifier

⇒ Consider the following statemen
1, 2, 3, 4
1, 2, 3
1, 2
1, 3, 4

⇒ In a series circuit with X_L constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE

⇒ The circuit shown in figure
low pass filter
high pass filter
band pass filter
band stop filter

⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.
TRUE
FALSE

⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is
0.001
1000
2 digit
1 mV

⇒ Two identical NMOS transistors M₁ and M₂ are connected as shown below. V_bias is chosen so that both transistors are in saturation. The equivalent g_m of the pair is defined t
the sum of individual g_m's of the transistors
the product of individual g_m's of the transistors
nearly equal to the g_m of M₁
nearly equal to g_m / g₀ of M₂

⇒ The effect of earth's magnetic field on radiowaves is minimum when
the electric field lines of radio waves and flux line of earth's magnetic field are in the same direction
the electric field lines of radio waves and flux lines of earth's magnetic field are at right angles
the electric field lines of radiowaves and flux lines of earth's magnetic field oppose each other
both (b) and (c)

⇒ In binary data transmission DPSK is preferred to PSK because
a coherent carrier is not required to the generated at the receiver
for a given energy per bit, the probability for zero is less
the 180° phase shifts of the carrier
more protection is provided against impulse noise

⇒ TE₁₀ mode of propagation of electromagnetic energy in waveguides can be thought of as
three TEM waves travelling along length of wave-guide
One TEM wave travelling along length of wave guide and one TEM wave propagation in the transverse plane
One TEM wave travelling along the length of wave guide and two TEM waves
none of the above

⇒ A 75 ohm line is first short terminated and minima locations are noted. Then the short is replaced by resistive load and minima location are again noted. If minima location are not altered and VSWR is 3, the value of resistive load is
25 Ω
50 Ω
225 Ω
250 Ω

⇒ An npn transistor has a Beta cutoff frequency f_β of 1 MHz, and a common emitter short circuit low frequency current gain β₀ of 200. It unity gain frequency f_T and the alpha cut off frequency f_a2 respectively are
200 MHz, 201 MHz
200 MHz, 199 MHz
199 MHz, 200 MHz
201 MHz, 200 MHz

⇒ The expression given is F(A, B, C, D, E, F, G, H) = Σ(33, 48, 102, 158, 222, 229, 233, 243, 255); then the __________ and __________ minterms are grouped together into dual and variable __________ is reduced using the dual
243, 233, D
222, 158, B
243, 255, A
229, 243, E

⇒ For the logic circuit of the given figure the simplified Boolean expressio
Y = AB + A C
Y = (AB) (A C)
Y = ABC
Y = A B + A C

⇒ Fleming's left hand rule is used to find
direction of force on a current carrying conductor
direction of flux in solenoid
direction of magnetic field due to a current carrying conductor
direction of induced emf

⇒ In the following astable multivibrator circuit, which properties of v₀(t) depends on R_{2Only the frequency
Only the amplitude
Both the amplitude
Neither the amplitude nor the frequency}

⇒ A Hartley oscillator is used for generation
very low frequency oscillation
radio frequency oscillation
microwave oscillation
audio-frequency oscillation

⇒ The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by
forward characteristics of thyristors
reverse recovery characteristics of thyristors
both forward and reverse recovery characteristics of thyristors
none of the above

⇒ Which one the following is an advantage of AM over FM?
FM has wide bandwidth
FM has better
FM is more immune to noise
Probability of noise spike generation is less in AM

⇒ Armstrong FM transmitter uses
LC oscillator
crystal oscillator
RC oscillator
either (a) or (c)

⇒ In ac circuits maximum power is delivered to a load if load impedance is conjugate of source impedance.
TRUE
FALSE

⇒ A single phase full wave regulator feeds a resistive load. The firing angle of thyristors is 90°. The input power factor is
1
0.707 lagging
0.5 lagging
0.2 lagging

⇒ The most commonly used microphone for public address systems is
carbon
crystal
moving coil
condenser

⇒ In a one pole active low pass filter, the cut off frequency is f_c. Then
gain decreases at the rate of 20 dB per decade increase in frequency above f_c
gain decreases at the rate of 20 dB per decade decrease in frequency below f_c
gain decreases at the rate of 40 dB per decade increase in frequency above f_c
gain decreases at the rate 40 dB per decade decrease in frequency below f_c

⇒ A balun provides an impedance transformation of
0.667361111111111
0.334027777777778
0.167361111111111
0.0840277777777778

⇒ In 8085 microprocessor, what is the memory address stored on the stack, when the program is interrup
0210 H
0.211 H
0118 H
020 FH

⇒ As frequency increases, the transmission efficiency
decreases
increases
is not affected
either (a) or (c)

⇒ Which one of the following effects is used in measuring power?
Seeback
Ferrari
Induction
Hall