Question is ⇒ In a CB amplifier the maximum efficiency could be, Options are ⇒ (A) 0.99, (B) 0.85, (C) 0.5, (D) 0.25, (E) , Leave your comments or Download question paper.

Question is ⇒ In a CB amplifier the maximum efficiency could be, Options are ⇒ (A) 0.99, (B) 0.85, (C) 0.5, (D) 0.25, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a CB amplifier the maximum efficiency could be
A.	0.99 [Wrong Answer]
B.	0.85 [Wrong Answer]
C.	0.5 [Wrong Answer]
D.	0.25 [Correct Answer]
View Answer 1 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ If a EM wave propagating in z direction then
component of EM wave will exist in z direction
component of EM wave will not exist in z direction
component of EM wave will exist in y direction
component of EM wave will exist in x direction

⇒

Assertion (A): When the performance of a stable second order system is improved by a PID controller, the system may become unstable.

Reason (R): PID controller increases the order of the system to 3.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The passband of the tuned circuits of a radio receiver should be equal to
20 kHz
455 kHz
1455 kHz
more than 455 kHz

⇒ Magnitude Plot of a Composite signal x(t) = e^2jt + e^3jt is
half wave rectified sinusoidal
full wave rectified sinusoidal
exponentially increasing sinusoidal
exponentially decreasing sinusoidal

⇒ Power gain of a multicavity klystron amplifier is
more than 30 dB
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above

⇒ Introducing a resistor in the emitter of a common amplifier stabilizes the d.c. operating point against variations in
only the temperature
only β of the transistor
both temperature and β
none of these

⇒ The input differential stage of op-amp. 741 is baised at about 10 μA current such a low current of the input stage gives

high CMRR
high differential gain
low differential
high input impedance

Which of these are correct?
1 and 2
1, 2 and 4
3 and 4
1, 2, 3 and 4

⇒ 2's complement number 00011111 = __________ ₁₀
31
-31
11
-11

⇒ CC circuit is suitable for impedance matching.
TRUE
FALSE

⇒ A 4 bit DAC gives an output of 4.5 V for input of 1001. If input is 0110, the output is
1.5 V
2.0 V
3.0 V
4.5 V

⇒ In a series RLC circuit, p-f is leading if X_C < X_L.
TRUE
FALSE

⇒ Which of the following is/are correct? The circuit shown in the fig
1 and 3
1 and 2
1 and 4
3 only

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40.12
4.878
2.2

⇒ Which of the following is not a valid character constant in C?
A'
2'
='
2

⇒ In amplitude modulation, carrier signals A cos ωt has its amplitude A modulated in proportion with message bearing (low frequency) signal m(t). The magnitude of m(t) is chosen to be __________ .
less than 1
less than or equal to 1
more than 1
none of these

⇒ The disadvantage of counter type ADC as compared to comparator ADC is that
resolution is low
conversion time is more
circuit is more complex
stability is low

⇒ For the circuit shown in the following figure I₀-I₃ are inputs to the 4:1 multiplexer R(MSB) and S are control
PQ + PQ S + Q R S
P Q + PQ R + P Q S
P Q R + P QR + PQRS + Q R S
PQ R + PQR S + P Q R S + Q R S

⇒ For a core having a relative permeability μ_r, magnetic dipole moment per unit volume M and field strength H, the flux density B is
B = μ_r (H + M)
B = μ₀ (H + M)
B = μ₀μ_r (H + M)
B = μ₀μ_r (H - M)

⇒ An electromechanical closed loop control system has the following characteristics equation :s³ + 6Ks² + (K + 2)s
K = 0.528
K = 2
K = 0
K = -2528

⇒ The following components are used to measure power output of a 2 kW TWT amplifier

TWT
Low pass/High pass filter
Low power 20 dB attenuator
40 dB directional coupler with matched load
Power meter.

The correct sequence of connections of these components is:
1, 4, 2, 3, 5
1, 3, 4, 2, 5
1, 2, 4, 3, 5
1, 4, 3, 2, 5

⇒ In a CD the sampling frequency is nearly
half the highest frequency in audio signal
equal to highest frequency in audio signal
double the highest frequency in audio signal
four times the highest frequency in audio signal

⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 1 GHz is about
100°
50°
5°
2°

⇒ The Z inverse of the given Z transfor
Unit step
Unit ramp
Unit impulse
Unit parabola

⇒ A DIAC has two terminals, anode and cathode.
TRUE
FALSE

⇒ A h is the unit of quantity of electricity.
TRUE
FALSE

⇒ All inverters use forced commutation.
TRUE
FALSE

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ In an AM transmitter after the modulation stage, class C amplifier
can be used
cannot be used
may be used, but it has no use
can't be determine to use

⇒ Which of the following photodetector does not provide gain?
Phototransistor
Photoconductor
Avalanche photodiode
p-i-n photodiode