Question is ⇒ Circular polarization, Options are ⇒ (A) is useful in reducing depolarization effect on received wave, (B) involves critical alignment of transmitting and receiving antenna, (C) is useful in discrimination between reception of adjacent beams, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Circular polarization, Options are ⇒ (A) is useful in reducing depolarization effect on received wave, (B) involves critical alignment of transmitting and receiving antenna, (C) is useful in discrimination between reception of adjacent beams, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Circular polarization
A.	is useful in reducing depolarization effect on received wave [Correct Answer]
B.	involves critical alignment of transmitting and receiving antenna [Wrong Answer]
C.	is useful in discrimination between reception of adjacent beams [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Resistivity of a perfect single crystal of a metal goes to zero as T approaches zero.

Reason (R): Scattering of electrons is due to deviations from perfect periodicity of lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ An 8 bit wide 4 word sequential memory has
Eight 4 bit shift registers
Eight 8 bit shift registers
Four 8 bit shift registers
Foui 4 bit shift registers

⇒ For a nonlinear resistance
v-i plot is not a straight line
resistance increases as current increases
resistance decreases as current increases
current decreases as voltage increases

⇒ For the same length of arrays, half power beam-width of binomial array
is equal to that of uniform arrays
is less than that of uniform array
is more than that of uniform array
is negligible as compared to that of uniform array

⇒ Using the same flip flops
a synchronous flip flop can operate at higher frequency than ripple counter
a ripple counter can operate at higher frequency than synchronous counter
both ripple and synchronous counter can operate at the same frequency
can not determine

⇒ The secondary lobes in binomial arrays can be reduced by
maintaining spacing between two consecutive radiating sources less than λ/2
maintaining the amplitudes in radiating sources, from outer towards the centre source, proportional to the coefficients of the successive terms of the binomial series
both (a) and (b)
none of the above

⇒ In modern MOSFET_S, the material used for the gate is
high purity silicon
high purity silica
heavily doped polycrystalline silicon
epitaxial grown silicon

⇒ A diode can have a very high forward resistance.
TRUE
FALSE

⇒ Acoustic strain gauges
have good linearity of measurement
do not have long term stability
have a large range of measurement
have an accuracy range of 0.1-1% depending on environment

⇒ Which one of the following is a D to A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒

Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ The early effect in a BJT is caused by
fast turn on
fast turn off
large collector base reverse bias
large emitter base forward bias

⇒ For a FM wave carrier modulating frequency is 10 kHz and bandwidth is 2 MHz. If the modulating signal amplitude is doubled, the bandwidth will be
0.5 MHz
1 MHz
2 MHz
4 MHz

⇒ Two discrete time systems with impulse responses h₁[n] = δ[n - 1] and h₂[n] = δ[n - 2] are connected in cascade. The overall impulse response of the cascaded system is
δ[n - 1] + δ[n - 2]
δ[n - 4]
δ[n - 3]
δ[n - 1] + δ[n - 2]

⇒ In figure, the switch S is initially open and steady state conditions are reached. At t = 0 switch is closed. The initial current through 2C capacito
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ For a high pass filter, β = p in attenuation band.
TRUE
FALSE

⇒ Of the various capacitances associated with a junction transistor the gain bandwidth product is affected to maximum extend by
base collector parasitic capacitor
base collector space charge layer capacitance
base emitter space charge layer capacitance
base emitter diffusion capacitance

⇒ Find Y in the circuit bel
f₂
f₂
0
∑(0, 1, 2, 3, 5, 6, 9)

⇒ In 8085 microprocessor, an active low signal INTA is not needed from up service which of the following interrupt requ
TRAP
INTR
RST 7.5
RST 5.5

⇒ In integral cycle control of ac regulators, the period of integral cycle control, i.e., (m + n) T should be
less than mechanical or thermal time constant of the system
more than the mechanical or thermal time constant of the system
more or less than the mechanical or thermal time constant
very high

⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω

⇒ For a n-channel JFET with r₀ = 10 kW, (V_Gs= 0 V, V_P = - 6 V)the drain resistance r_d at V_GS= - 3 V is given by
40 kΩ
2.5 kΩ
4.44 kW
120 kW

⇒ The current through a PN Junction diode with v volts applied to the P region to the N region, where (I₀ is the reverse saturation current to the diode, m the ideality factor, k the Boltzmann constant, T the absolute temperature and q the magnitude of charge on an electron) is
I₀ (e^-qv/mkT - 1)
I₀ e^-qv/mkT
I₀ (1 - e^qv/mkT)
I₀ (e^qv/mkT - 1)

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the collector current will be
1.005 mA
0.985 mA
0.975 mA
0.955 mA

⇒ The main advantage of superheterodyne receiver is
better tracking
simple cut
better alignment
improvement in selectivity and sensitivity

⇒ In a multiphase chopper, the different choppers operate in
series and all simultaneously
parallel and one at a time
parallel and simultaneously
either (b) or (c)

⇒ Which of the following is not a data base function?
DAVERAGE
MAX
DCOUNT
DSTDEV

⇒ For plane wave propagating in free space or two conductor transmission line, what must be the relationship between the phase velocity v_p , the group velocity v_g and speed of light c?
v_p > c > v_g
v_p < c < v_g
v_p = c = v_g
v_p < v_g < c

⇒ A silicon (PN) junction at a temperature of 20°C has a reverse saturation current of 10 pico Ampere. The reverse saturation current at 40°C for the same bias is approximately.
30 pA
40 pA
50 pA
60 pA

⇒ In the diode circuit shown in figure the diodes are ideal. The impedance seen by source is
1 k ohm
2 k ohm
0.5 k ohm
infinite