Question is ⇒ If velocity of sound waves in air at 0°C is 330 m/s, the velocity at 40°C is about, Options are ⇒ (A) 330 m/s, (B) 334 m/s, (C) 353 m/s, (D) 380 m/s, (E) , Leave your comments or Download question paper.

Question is ⇒ If velocity of sound waves in air at 0°C is 330 m/s, the velocity at 40°C is about, Options are ⇒ (A) 330 m/s, (B) 334 m/s, (C) 353 m/s, (D) 380 m/s, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If velocity of sound waves in air at 0°C is 330 m/s, the velocity at 40°C is about
A.	330 m/s [Wrong Answer]
B.	334 m/s [Wrong Answer]
C.	353 m/s [Correct Answer]
D.	380 m/s [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following material is preferred for transformer cores operating in micro wave frequency range?
Ferrites
Silicon steel
Superalloy
Copper

⇒ The ratio of diffusion constant for hole D_P to the mobility for holes is proportional to
T²
T
1/T
T³

⇒ RS latch can be built with
NOR gates
NAND gates
NOR or NAND gates
none of the above

⇒ Current density has the dimensions
IL
IL^-2
IL^-3
I²L^-2

⇒ In Weston frequency meter, the magnetic axes of the two fixed coils are
parallel
perpendicular
inclined at 60°
inclined at 15°

⇒ In a wave the electric field lines are vertical. Then the wave is
horizontally polarized
vertically polarized
either (a) or (b)
neither (a) nor (b)

⇒ Radiation resistance of an antenna is a
dc resistance
ac resistance
either (a) or (b)
none of the above

⇒ In an integral controller
the output is proportional to input
the rate of change of output is proportional to input
the output is proportional to rate of change of input
none of the above

⇒ The input to a coherent detector is DSB - SC signal plus noise. The noise at the detector output is
in phase component
quadrature component
zero
the envelope

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ For the wave shown in figure, the average and rms values
50 A and 57.73 A
57.73 A and 50 A
25 A and 57.73 A
57.73 A and 70.7 A

⇒ Dielectric materials have high specific resistance.
TRUE
FALSE

⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W

⇒ In a micro computer the control bus
transmits and receives control signals between processor and other devices
transmits and receives control signals, also sends and receives data
transmits and receives control signals, sends and receives data and transmits address of the device
none of the above

⇒ An electron shell corresponding to principal quantum number n can contain a maximum of
n² electrons
2n² electrons
2n electron
n³ electron

⇒ The effective electrical length of an antenna is __________ its physical length
greater than
equal to
less than
none of the above

⇒ In a multicavity klystron amplifier the electron velocity of the order of
10 m/s
10³ m/s
10⁶ m/s
10¹² m/s

⇒ A transmission line discontinuity is defined as any interruption in the uniformity of the line.
TRUE
FALSE

⇒ The current through a PN Junction diode with v volts applied to the P region to the N region, where (I₀ is the reverse saturation current to the diode, m the ideality factor, k the Boltzmann constant, T the absolute temperature and q the magnitude of charge on an electron) is
I₀ (e^-qv/mkT - 1)
I₀ e^-qv/mkT
I₀ (1 - e^qv/mkT)
I₀ (e^qv/mkT - 1)

⇒ A variable resistance R and capacitive reactance X_C are connected in series. As R is varied, the locus of Z is
a straight line parallel to Y axis in 4th quadrant
a straight line parallel to X axis in 4th quadrant
a straight line parallel to Y axis in second quadrant
a straight line parallel to Y axis in first quadrant

⇒ A DIAC has two terminals, anode and cathode.
TRUE
FALSE

⇒ Highest resistivity of the following is
nichrome
constantan
metal
manganin

⇒ Wave guides are pressurised above normal atmospheric pressure for
increasing the power handling capacity
improving conductivity of walls
preventing higher modes from propagation
varying the wave impedance

⇒ In a driving point function, the degrees of numerator and denominator polynomials in s may differ by either zero or one only.
TRUE
FALSE

⇒ For a second order system ω_n is natural frequency, ω_d is frequency of damped oscillations and ζ is damping factor. Then
ω_d = ω_n ξ
ω_d = ω_n (1 - ξ)²
ω_d = ω_n (1 - ξ)^0.5
ω_d = ω_n (1 - ξ²)^0.5

⇒

Assertion (A): If A = 0.5 ∠ 20°, A² = 0.25 ∠ 40°.

Reason (R): When drawing a phasor diagram, sinusoids may have the same or different frequencies.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a simple on-off controller with differential gap, the magnitude of differential gap determines
the level of accuracy
the life of controller
both (a) and (b)
neither (a) nor (b)

⇒ In a television transmitter, the output stage is most likely to be
screen modulated class C amplifier
plate modulated class C amplifier
grid modulated class A amplifier
grid modulated class C amplifier

⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above

⇒ A (75 - J50) ohm load is connected to a coaxial of Z₀ = 75 ohm at 10 GHz. The best method of matching is to connect
an inductance at load
a short circuited stub at load
a short circuited stub at specific distance from load
a capacitance at specific distance from load