Question is ⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about, Options are ⇒ (A) 50 mV, (B) 60 mV, (C) 66 mV, (D) 80 mV, (E) , Leave your comments or Download question paper.

Question is ⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about, Options are ⇒ (A) 50 mV, (B) 60 mV, (C) 66 mV, (D) 80 mV, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about
A.	50 mV [Wrong Answer]
B.	60 mV [Wrong Answer]
C.	66 mV [Correct Answer]
D.	80 mV [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Tape recorders use
cone type loudspeakers
horn type loudspeakers
either cone type or horn type loudspeakers
none of the above

⇒ When a p-n junction is forward biased, the current remains zero till the applied voltage overcomes the barrier potential.
TRUE
FALSE

⇒ The maximum power that can be transferred to the load is resistor R_L from the voltage source in the figur
1 W
10 W
0.25 W
0.5 W

⇒ In the circuit shown below, the outputs Y₁ and Y₂ for the given initial condition Y₁ = Y₂ = 1 and after four input pulses wil
Y₁ = 1, Y₂ = 0
Y₁ = 0, Y₂ = 0
Y₁ = 0, Y₂ = 1
Y₁ = 1, Y₂ = 1

⇒ A memoryless source emits n symbols each with a probability p. The entropy of the source as a function of n
increases as log n
decreases as log (1/n)
increases as n
increases as n log n

⇒ Which of the following statements is true regarding the fundamental mode of the metallic waveguides sh
Only P has no cutoff- frequency
Only Q has no cutoff- frequency
Only P has no cutoff- frequency
All there have cut-off frequency

⇒ Probability density function of thermal noise is
Poisson
Binomial
Gaussian
None of the above

⇒

Assertion (A): The steady state response, of a stable, linear, time invariant system, to sinusoidal input depends on initial conditions.

Reason (R): Frequency response, in steady state, is obtained by replacing s in the transfer function by jω

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The numbers of accelerating anodes in a CRO is
1
2
3
4

⇒ Which type of modulator amplifier is used in AM transmitter?
Class A
Class B
Classes AB
Class C with negative feedback

⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz?
0.6698
0.7698
0.503
0.6598

⇒ Which of these has poor overload capacity?
PMMC instrument
Hot wire instrument
Dynamometer instrument
Both (a) and (c)

⇒ Addition of 0.3 to 3.5% silicon to iron
increases the electrical resistivity of iron
decreases the electrical resistivity of iron
does not change electrical resistivity of iron
silicon can't be added with iron

⇒ Which of the following circuit has the greatest bandwidth?
f_r = 455 MHz; Q = 10
f_r = 455 MHz; Q = 100
f_r = 1 MHz; Q = 100
f_r = 1 MHz; Q = 10

⇒ Which is not a valid dimension statement?
DIMENSION KAT(10, 20)
DIMENSION BAT (30, 20)
DIMENSION KAT(K, 10)
DIMENSION BAT (10, 5)

⇒

Assertion (A): Tristate logic is used for bus oriented systems

Reason (R): The outputs of a tristate logic are 0, 1 and indeterminant.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The waveshape of output voltage of half bridge inverter is
sinusoidal
square
triangular
either (a) or (b)

⇒ In a lag network the input frequency is 100 f_c where f_c is critical frequency. The voltage gain is
0 dB
-20 dB
-40 dB
-60 dB

⇒ At a P-N junction, the potential barrier is due to the charges on either side of the junction, which consists of
fixed donor and acceptor ions
majority carriers only
minority carriers only
both majority and minority carriers

⇒ In a backward wave oscillator the wave travelling along the line winds itself back and forth
TRUE
FALSE

⇒ An e-mail message can be sent to many recipients.
TRUE
FALSE

⇒ The resistance of a bulb at the time of full brightness is 1200 Ω. Then the resistance at room temperature is about
1200 Ω
120 Ω
600 Ω
10 Ω

⇒ The tape recorders used in homes have
common head and common amplifier system for recording and playback
different heads and amplifiers for recording and playback
same head but different amplifiers for recording and playback
different heads but same amplifier for recording and playback

⇒ In a 50 cm TV tube, a path difference of 2 km between direct wave and interfering wave would mean a displacement between main image and ghost image equal to
0.3 cm
3 cm
6 cm
9 cm

⇒ Choose the correct option

Mesh is the smallest loop of circuit
Loop is smallest path of circuit
Loop does not contain any mesh
Loop may have one or more than one mesh

1, 2, 3, 4
3, 4, 2
1, 4
3, 2

⇒ The conductivity of an intrinsic semiconductor is
generally less than that of a doped semiconductor
given by σ₁ = en_i (μ_n - μ_p)
given by σ₁ = en_i (μ_p + μ_n)
given by σ₁ = n_i (μ_n + μ_p)

⇒ Consider the following statements about PCM

PCM is not noise resistant
PCM requires complex encoding and quantizing circuitry
PCM requires large bandwidth

Which of the above are correct?
1 only
1, 2, 3
2, 3
1 and 3

⇒ An 8085 executes the following instructionsPC = 2715 H HL = 30A0 H
PC = 30A0H HL = 2715H
PC = 6104 H HL = 6140 H
PC = 6140H HL = 2715H

⇒ The lowest frequency used in satellite communications is __________ GHz.
0.8
3
18
30

⇒ A voltage v = 100 sin ωt + 10 sin 5 ωt is applied to a pure capacitor having capacitance of 1 μF. If ω = 314 rad/sec, the current through the capacitor is
0.0314 cos 314 t + 0.0157 cos 1570 t
0.0314 sin 314 t + 0.0157 sin 1570 t
0.0314 cos 314 t + 0.0314 cos 1570 t
0.0157 cos 314 t + 0.0157 cos 1570 t