Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
At a given probability of error, binary coherent FSK is interior to binary coherent PSK by | |
A. | 6 dB [Wrong Answer] |
B. | 3 dB [Correct Answer] |
C. | 2 dB [Wrong Answer] |
D. | 0 dB [Wrong Answer] |
View Answer
Explanation:-
Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ Colour picture tube needs higher anode voltage and needs larger beam and cathode currents than monochrome tube because
it is bigger in size
it has higher level of illumination
the tube has to illuminate three phosphors simultaneously
the tube has lower efficiency because of aperture mask
⇒ The temperature coefficient of a thermistor
is positive
is negative
zero
may be positive or negative depending on its composition
⇒ The impulse response h[n] of a linear time invariant system is given by h[n] = ∪[n + 3 ] + ∪[n - 2] -2∪[n -7]. The above system is
stable but non-casual
stable and casual
casual but unstable
unstable and not casual
⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half the secondary winding is 40 V. If diodes are ideal, the average output voltage is
40 V
25.5 V
20 V
2.55 V
⇒ For the collector-feedback amplifier shown below the voltage gain A_{v} will be _________
-113.07
-103.07
-107.07
-93
⇒ The binary number 0.10110111101 is equal to hexadecimal number
B3A
B5A
B7A
BA7
⇒ A + AB =
A
A
A + B
A + B
⇒ The L/C has the dimension of
time
capacitance
velocity
resistance
⇒ Wagner earthing device is used to eliminate error due to
electromagnetic coupling
electrostatic coupling
both electrostatic and electromagnetic coupling
either (a) or (b)
⇒ In 3 phase power measurement by two wattmeter method, both wattmeters had equal reading. The power factor of load is
1
0.5 lagging
0.5 leading
0
⇒ As per time displacement theorem in Laplace transformation, displacement in the time domain by T becomes
division by s in the s domain
division by e^{-sT} in the s domain
multiplication by s in the s domain
multiplication by e^{-sT} in the s domain
⇒ Watthour meter is an integrating instrument
TRUE
FALSE
⇒ A second order system exhibits 100% overshoot. The damping ratio is
0
1
< 1
> 1
⇒ Inverter 74 LS04 has following specifications I_{0H} max = - 0.4 mA, I_{0L max} = 8 mA, I_{IH max} = 20 μA, I_{IL max} = 0.
10
20
60
100
⇒ If a function has only cosine terms, it must satisfy the equation
f(t) = -f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above
⇒
Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true
⇒ The following switching functions are to be implemented using a decoder
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line
⇒ A dc separately excited motor has a constant field current. The armature is fed from a single phase supply through a semi-converter. When a = 0, speed is 600 rpm. If a = 90°, the speed is likely to be
about 300 rpm
about 150 rpm
about 75 rpm
about zero
⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be
out of phase by 90°
in phase
out of phase by 45°
out of phase 180°
⇒ In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0^{+Unit stepUnit impulseUnit rampUnit step plus unit ramp}
⇒ For the circuit, let us assume that R = 1 Ω, L = 10^{-3} H, and V(t) = 10 cos (1000t + 30°)V and the differential equation for I(t) is give
7.07 cos (1000t + 15°) A
70.7 cos (1000t - 30°) A
7.07 cos (1000t - 15°) A
7.07 cos (1000t + 15°) A
⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts
⇒ A counter has a modulus of 10. The number of flip flops is
10
5
4
3
⇒ A single phase full bridge inverter for R-L loads needs
4 thyristors
4 thyristors and 4 diodes
4 thyristors and 2 diodes
8 thyristors
⇒ In figure the total inductance of the circui
L_{1} + L_{2}
L_{1} + L_{2} + M
L_{1} + L_{2} + 2M
L_{1} + L_{2} + M
⇒ In load commutated chopper, the commutating element
is capacitor
is capacitor and inductor
is capacitor, inductor and auxiliary thyristor
any of the above depending on load
⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20
⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5
⇒ The Kirchoff's laws fail in which of the following circuits?
Linear circuits
Non-linear circuits
Lumped parameters circuits
Distributed parameters circuits
⇒ The rating of a transformer to deliver 100 watts of D.C. power to a load under half wave rectifier will be nearly
1 kVA
350 VA
175 VA
108 VA
⇒ Colour picture tube needs higher anode voltage and needs larger beam and cathode currents than monochrome tube because
it is bigger in size
it has higher level of illumination
the tube has to illuminate three phosphors simultaneously
the tube has lower efficiency because of aperture mask
⇒ The temperature coefficient of a thermistor
is positive
is negative
zero
may be positive or negative depending on its composition
⇒ The impulse response h[n] of a linear time invariant system is given by h[n] = ∪[n + 3 ] + ∪[n - 2] -2∪[n -7]. The above system is
stable but non-casual
stable and casual
casual but unstable
unstable and not casual
⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half the secondary winding is 40 V. If diodes are ideal, the average output voltage is
40 V
25.5 V
20 V
2.55 V
⇒ For the collector-feedback amplifier shown below the voltage gain A_{v} will be _________
-113.07
-103.07
-107.07
-93
⇒ The binary number 0.10110111101 is equal to hexadecimal number
B3A
B5A
B7A
BA7
⇒ A + AB =
A
A
A + B
A + B
⇒ The L/C has the dimension of
time
capacitance
velocity
resistance
⇒ Wagner earthing device is used to eliminate error due to
electromagnetic coupling
electrostatic coupling
both electrostatic and electromagnetic coupling
either (a) or (b)
⇒ In 3 phase power measurement by two wattmeter method, both wattmeters had equal reading. The power factor of load is
1
0.5 lagging
0.5 leading
0
⇒ As per time displacement theorem in Laplace transformation, displacement in the time domain by T becomes
division by s in the s domain
division by e^{-sT} in the s domain
multiplication by s in the s domain
multiplication by e^{-sT} in the s domain
⇒ Watthour meter is an integrating instrument
TRUE
FALSE
⇒ A second order system exhibits 100% overshoot. The damping ratio is
0
1
< 1
> 1
⇒ Inverter 74 LS04 has following specifications I_{0H} max = - 0.4 mA, I_{0L max} = 8 mA, I_{IH max} = 20 μA, I_{IL max} = 0.
10
20
60
100
⇒ If a function has only cosine terms, it must satisfy the equation
f(t) = -f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above
⇒
Assertion (A): In high Q circuits poles of Y(s) lie close to ω axis in complex frequency plane.
Reason (R): Q is inversely proportional to damping factor.
Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true
⇒ The following switching functions are to be implemented using a decoder
- f_{1} = ∑m (1, 2, 4, 8, 10, 14)
- f_{2} = ∑m (2, 5, 9, 15)
- f_{3} = ∑m (2, 4, 5, 6, 7)
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line
⇒ A dc separately excited motor has a constant field current. The armature is fed from a single phase supply through a semi-converter. When a = 0, speed is 600 rpm. If a = 90°, the speed is likely to be
about 300 rpm
about 150 rpm
about 75 rpm
about zero
⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be
out of phase by 90°
in phase
out of phase by 45°
out of phase 180°
⇒ In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0^{+Unit stepUnit impulseUnit rampUnit step plus unit ramp}
⇒ For the circuit, let us assume that R = 1 Ω, L = 10^{-3} H, and V(t) = 10 cos (1000t + 30°)V and the differential equation for I(t) is give
7.07 cos (1000t + 15°) A
70.7 cos (1000t - 30°) A
7.07 cos (1000t - 15°) A
7.07 cos (1000t + 15°) A
⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts
⇒ A counter has a modulus of 10. The number of flip flops is
10
5
4
3
⇒ A single phase full bridge inverter for R-L loads needs
4 thyristors
4 thyristors and 4 diodes
4 thyristors and 2 diodes
8 thyristors
⇒ In figure the total inductance of the circui
L_{1} + L_{2}
L_{1} + L_{2} + M
L_{1} + L_{2} + 2M
L_{1} + L_{2} + M
⇒ In load commutated chopper, the commutating element
is capacitor
is capacitor and inductor
is capacitor, inductor and auxiliary thyristor
any of the above depending on load
⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20
⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5
⇒ The Kirchoff's laws fail in which of the following circuits?
Linear circuits
Non-linear circuits
Lumped parameters circuits
Distributed parameters circuits
⇒ The rating of a transformer to deliver 100 watts of D.C. power to a load under half wave rectifier will be nearly
1 kVA
350 VA
175 VA
108 VA