Question is ⇒ If reflection coefficient is 1/5, then corresponding VSWR is given by, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 42796, (E) , Leave your comments or Download question paper.

Question is ⇒ If reflection coefficient is 1/5, then corresponding VSWR is given by, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 42796, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If reflection coefficient is 1/5, then corresponding VSWR is given by
A.	1 [Wrong Answer]
B.	2 [Wrong Answer]
C.	3 [Wrong Answer]
D.	42796 [Correct Answer]
View Answer 5 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): In microprocessor 8085 DMA allows direct access to memory to speed up data transfer.

Reason (R): HOLD and HLDA signals are used for DMA operations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Diffraction of EM waves
arises only with spherical wave front
may occur around the edge of an obstacle
occurs when waves pass through a big slot
none of the above

⇒ In the synthesis of RLC network
the number of elements in Bott-Duffin synthesis and Brune's synthesis are always equal
the number of elements in Bott-Duffin synthesis is more than that in Brune's synthesis
the number of elements in Bott-Duffin synthesis is less than that in Brune's synthesis
the number of elements in Bott-Duffin synthesis may be more or less than that in Brune's synthesis

⇒ If F_n represents Fourier series coefficient of f(t), then Fourier series coefficient of f(t + t) =
F_ne ^-jω₀^t
F_ne ^jω₀^t
F_ne ^jnω₀^t
F_ne ^-jnω₀^t

⇒ For a resistance of about 15 kΩ operating in a frequency range of a few MHz, the noise voltage is in the range of
a few μV
about 100 μV
a few μV
a few volts

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter

⇒ Consider the following

Maximum energy of electrons liberated photoelectrically is independent of light intensity
Maximum energy of electrons liberated photoelectrically varies nonlinearly with frequency of incident light.

(1) is true and (2) is false
(1) and (2) both are true
(1) is false and (2) is true
(1) and (2) both are false

⇒ Which of the following array names is invalid in Fortran 77?
B(2, 4)
B(M, 3)
B(M, R)
B(3, 6)

⇒ The circuit of figur
Precision integrator
Hartley oscillator
Butterworth high pass filter
Wien bridge oscillator

⇒ Which one of the following is digital?
Pulse code modulation
Pulse width modulation
Pulse frequency modulation
Pulse position modulation

⇒

Assertion (A): The regular or irregular stacking of atoms has importanteffect on properties of materials.

Reason (R): The arrangement of atoms in a given material can be studied using X-rays.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The simplest register is
buffer register
shift register
controlled buffer register
bidirectional register

⇒ A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.999 V, the resolution is
1 V
0.01 V
1 mV
1 μV

⇒ If 1 kVA transformer is used for all of the following rectifiers, the d.c. power availability will be least in case of
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ A sine wave with slew rate distortion looks like
step wave
square wave
triangular wave
cosine wave

⇒ In a D-type latch EN = 1, D = 1, the O/P is
1
0
don't care
blocked

⇒ Choose the correct match for input resistance of various amplifier configurations shown below configurat
CB-LO, CC-MO, CE-HI
CB-LO, CC-HI, CE-MO
CB-MO, CC-HI, CE-LO
CB-HI, CC-LO, CE-MO

⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is
a resistor
a capacitor
an inductor
a diode

⇒ In a class C operation V_CC = 40 V and V_CE(sat) = 0.4 V. The efficiency is
0.9
0.495
0.01
0.005

⇒ Consider the following statements about advantages of phase discriminator over slope detector

Fewer tuned circuits
Greater limiting
Better linearity
Easy alignment

Which of the above are true?
1, 2, 3, 4
2, 3, 4
1, 2, 3
1, 3, 4

⇒ The power dissipated in 4 Ω resistance in figur
64 W
32 W
16 W
8 W

⇒ If E_y is the voltage applied to Y plates, the vertical deflection of beam is proportional to
E_y
E_y
E_y^1.5
E_y²

⇒ T-flip-flop is commonly used as
a delay switch
a digital counter only
a digital counter and frequency divider
any of the above

⇒ Which of following antenna does not depend upon the frequency?
Log-periodic
Parabolic
Conical
All of the above

⇒ Which of the following does not cause losses in optical fibre cables?
Stepped index operation
Impurities
Microbending
Attenuation in glass

⇒ For F₁ layer the maximum ionic density is 2.3 x 10⁴ electrons per cc. The critical frequency for this layer will be
1.36 MHz
13.6 MHz
136 MHz
1360 MHz

⇒ A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is
2
4
8
18

⇒ Consider the following statement in FORTRAN 77 2 values could be read and stored asX (0), Y (0)
4 values could be read and stored asX (0), Y (0), X (2), Y (2)
6 values could be read and stored as X (0), Y (0), Y (2), X (3), Y (3)
none of the above

⇒ In phase shift keying the input signal is
s_t(t) = A cos ω₀t and s₂(t) = - A cos ω₀t
s₁(t) = s₂(t) = A cos ω₀t
s₁(t) = A cos ω₀t and s₂(t) = A cos (ω₀t + p/2)
s₁(t) = A cos ω₀t and s₂(t) = - A (cos ω₀t + p/2)

⇒ In a N-P-N transistor the function of the emitter is
to emit or inject holes into the collector
to emit or inject electrons into the collector
to emit or inject electrons into the base
to emit or inject holes into the base