Question is ⇒ Directivity gain depends on, Options are ⇒ (A) the distribution of radiated power in space, (B) solid angle of the radiated field pattern, (C) both (a) and (b), (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Directivity gain depends on, Options are ⇒ (A) the distribution of radiated power in space, (B) solid angle of the radiated field pattern, (C) both (a) and (b), (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Directivity gain depends on
A.	the distribution of radiated power in space [Correct Answer]
B.	solid angle of the radiated field pattern [Wrong Answer]
C.	both (a) and (b) [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The scale of moving iron instrument is linear.
TRUE
FALSE

⇒ An m derived low pass filter has f_c = 1000 Hz, f_∞ = 1250 Hz and m = 0.6. If m is increased, then
both f_c and f_∞ will increase
both f_c and f_∞ will decrease
f_c will remain constant but f_∞ will decrease
f_c will remain constant but f_∞ will increase

⇒ In figure the zener cur
is always 130 mA
may vary between 10 mA and 130 mA
may vary between 60 mA and 130 mA
is always equal to 65 mA

⇒ The sensitivity of a superheterodyne receiver is determined by
the gain IF amplifier
the gain of RF amplifier
the noise figure
all of the above

⇒ In the given figure, the number of individual loop
2
4
5
6

⇒ From the noise point of view, bandwidth should
be large
not be too large
should be as large as possible
should be infinite

⇒

Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a colour TV receiver SAW filter consists of
piezoelectric substrate on which are deposited two inter, digital transducers
photo conductive substrate which are deposited two inter digital transducers
photo voltaic substrate which are deposited two inter digital transducers
photo resistive substrate which are deposited two inter digital transducers

⇒ Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?
TTL
ECL
PMOS
CMOS

⇒

Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.

Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A shadow zone does not receive any space wave
TRUE
FALSE

⇒ Figure shows four D type FFs are connected as a shift register using an XOR gate. The initial state and 3 subsequent states for 3 clock pulses are also g
0
1111
1001
1000

⇒ - ve feedback in an amplifier
reduces gain
increase frequency and phase distortion
reduce bandwidth
increase noise

⇒ The snubber circuit consists of
a capacitor connected in series with thyristor
a capacitor connected in parallel with thyristor
a resistor and capacitor in series connected across thyristor
none of the above

⇒ SCR can be turned on by

applying anode voltage at a sufficient fast rate
applying sufficiently large anode voltage
increasing the temperature of SCR to a sufficiently
applying sufficiently large gate current.

1, 2, 4 only
4 only
1, 2, 3, 4
none

⇒ In 8085 microprocessor system, what will be the total delay provided by the following loop.3.154 msec
3.514 msec
2.644 msec
3.166 msec

⇒ A modem is classified as low speed if data rate handled is
upto 100 bps
upto 250 bps
upto 400 bps
upto 600 bps

⇒ If figure, I = 2A if R = 20 Ω. When R = 10 Ω current I
0.0416666666666667
0.0833333333333333
2.5 A
0.125

⇒ In RLC circuits the state variables generally selected are
voltages across capacitors
currents through resistances and voltages across capacitors
currents through resistances and capacitances
currents through inductances and voltages across capacitances

⇒ If number of information bits is 4, the parity bits in Hamming code are located at bit positions __________ from the LSB.
1, 2, 5
1, 2, 4
1, 2, 3
1, 2

⇒ The circumference of an electron orbit is equal to integer times the wavelength of electron.
TRUE
FALSE

⇒ The channel required for FM telemetry is
same as required for AM telemetry
smaller than that required by AM telemetry
100 times that required for AM telemetry
10 times that required for AM telemetry

⇒ In a rectangular waveguide Z_TE . Z_TM is
η₀²
1
1/ η₀²
η₀

⇒ When sources of different frequencies feed a network the only method of solution is superposition theorem.
TRUE
FALSE

⇒ Which one of the following materials is used for making permanent magnets?
Steel
Carbon
Carbon-Steel
Graphite

⇒ In a digital system there are three inputs ABC. Output should be high when atleast two inputs are high. Then output =
AB + BC + AC
ABC + ABC + A BC + ABC
AB + BC + AC
AB + BC + AC

⇒ Some types of traps used in video IF amplifier of colour TV are
shunt traps
series traps
absorption traps
all of the above

⇒ A memory system has a 9 chips. If MTBF of one clip is 900 000 hours, MTBF of complete memory system is
900000 hours
100000 hours
8100000 hours
1800000 hours

⇒ The PCM signal shown below uses amplitude level of +1 volt and -1 volt to represent binary symbol 0 and 1 respectively. Each code word consists of 4 bits. The sampled version of analog signal from which this PCM signal is derived
EB596
CD231
DA495
25B6A

⇒ In a bipolar transistor, emitter efficiency is about
0.99
0.9
0.8
0.7