Question is ⇒ At a temperature of about 1 K, aluminium is a, Options are ⇒ (A) conductor, (B) insulator, (C) photoconductor, (D) superconductor, (E) , Leave your comments or Download question paper.

Question is ⇒ At a temperature of about 1 K, aluminium is a, Options are ⇒ (A) conductor, (B) insulator, (C) photoconductor, (D) superconductor, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	At a temperature of about 1 K, aluminium is a
A.	conductor [Wrong Answer]
B.	insulator [Wrong Answer]
C.	photoconductor [Wrong Answer]
D.	superconductor [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Following state diagram shows clocked sequential circ
6
7
5
4

⇒ A difference amplifier using op-amp has closed loop gain = 50. If input is 2 V to each of inverting and non-inverting terminals, output is 5 mA. Then CMRR =
20000
2000
200
20

⇒ Which of the following effects is used in measurement of magnetic flux?
Hall effect
Seeback effect
Piezo electric effect
Photoelectric effect

⇒ When R and L are connected in parallel, R > |Z|.
TRUE
FALSE

⇒ Fourier transform of f(t) =
jω F(f)
2pf F(f)
F'(f)
None

⇒ The oscillator shown in figure
Clapp oscillator
R-C Phase shift oscillator
Hartley oscillator
Colpitt's oscillator

⇒ An OR gate has 4 inputs. One input is high and the other three are low. The output
is low
is high
is alternately high and low
may be high or low depending on relative magnitude of inputs

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ An electromechanical closed loop control system has the following characteristics equation :s³ + 6Ks² + (K + 2)s
K = 0.528
K = 2
K = 0
K = -2528

⇒ The standard intermediate frequency for FM ratio is
10.7 MHz
4.5 MHz
75 kHz
455 kHz

⇒ For a rectangular waveguide (a x b, a > b) to support only the TE₁₀ mode at wavelength which one of the following pairs of in equalities is to be satisfied?
b < λ < 2b; λ > 2a
b < λ < 2b; λ < 2a
a < λ < 2b; λ < 2a
a < λ < 2b; λ > 2a

⇒ Which statement is correct?
BJT and MOSFET are current controlled devices
BJT is voltage controlled and MOSFET is current controlled device
BJT and MOSFET are voltage controlled devices
BJT is current controlled and MOSFET is voltage controlled device

⇒ Which of these has lowest dielectric strength?
Dry air
Wet air
Cotton
Paper

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ It is found that in a telephone system 60 subscribers initiate calls during a 30 minute interval and the total duration of all the calls is 100 minutes. The load is
2
3 erlang
3.333 erlang
0.333 erlang

⇒ All of the following elements have three valence electrons EXCEPT
boron
indium
gallium
arsenic

⇒ Two capacitors of 20 μF each are in series. The total capacitance is
5 μF
10 μF
40 μF
400 μF

⇒ In figure, the position of voltmeter and ammeter are exchanged. It may result in damage
both the instruments
ammeter
voltmeter
neither of two

⇒ For a waveguide, which of the following statements is wrong?
It is usually made of brass or aluminium
It is usually rectangular or circular in shape
The dielectric region is usually air
The wall thickness is very small as compared to skin depth

⇒ In an unloaded transformer, the fluxes limiting the primary and secondary are 30 mWb and 20 mWb. The coefficient of coupling is
1
0.1
0.33
0.67

⇒ In a P type silicon sample, the hole concentration is 2.25 x 10¹⁵ / cm³. If the intrinsic carrier concentration is 1.5 x 10¹⁰/ cm³ the electron concentration is
zero
10¹⁰/cm³
10⁵/cm³
1.5 x 10²⁵/cm³

⇒

Match the following:

	List I		List II
A.	R_T	1.	A = D
B.	R_h	2.	h₁₂ = h₂₁
C.	S_T	3.	AD - BC = 1
D.	S_h	4.	h₂₁ = - h₂₁
		5.	B = C
		6.	Δh = 1

A-3, B-4, C-1, D-6
A-3, B-2, C-5, D-4
A-5, B-4, C-1, D-2
A-5, B-4, C-1, D-6

⇒ From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier
gain bandwidth product
slew rate
upper 3 dB frequency
lower 3 dB frequency

⇒ The hexadecimal number 64 AC is equivalent to decimal number
25727
25722
25772
25777

⇒ Laplacian of a scalar function V is
gradient of V
gradient of the gradient of V
divergence of V
divergence of the gradient of V

⇒ The conversion or collector circuit efficiency is a measure
how successfully the active device converts D.C. power to A.C. signal power
how much distortion in output is reduced with respect to input
how successfully the active device converts A.C. power to D.C. signal power
none of the above

⇒ The total lumens emitted by a source of 1 candle are
0.4 p
4 p
2 p
8 p

⇒ A 1000 kHz carrier wave modulated 40% at 4000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulation after transmission through this circuit?
0.4
0.2
0.27
0.54

⇒ A uniform plane magnetic wave incident normally on a plane surface of a dielectric material is reflected and the percentage of reflected power is 75% What is VSWR?
14
1.4
15
13

⇒ In the expression 3 * * 2 ** 4 ** 2 in FORTRAN 77 which exponentiation is performed first
4 * * 2
2 * * 4
3 * * 2
all exponentiation are performed together