Question is ⇒ When analysing two port networks in cascade, it is more convenient to use, Options are ⇒ (A) z parameters, (B) h parameters, (C) T parameters, (D) y parameters, (E) , Leave your comments or Download question paper.

Question is ⇒ When analysing two port networks in cascade, it is more convenient to use, Options are ⇒ (A) z parameters, (B) h parameters, (C) T parameters, (D) y parameters, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When analysing two port networks in cascade, it is more convenient to use
A.	z parameters [Wrong Answer]
B.	h parameters [Wrong Answer]
C.	T parameters [Correct Answer]
D.	y parameters [Wrong Answer]
View Answer 7 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If the mantissa of a digital computer is 37 bit long then the accuracy of the digital computer will be of
37 decimal places
23 decimal places
11 decimal places
accuracy is independent of the length to mantissa

⇒ What will be FSV in 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ
0.99 V
0.9 V
0.1 V
0

⇒ In Quine-Mclusky method of Boolean function reduction; __________ , are treated as __________ and therefore discrepancies may occur in the final solution, therefore this method is not applicable to the functions with __________ .
zeros, don't care conditions, zeros
one's, don't care conditions, one's
don't care conditions, zeros, don't care conditions
don't care conditions, don't care conditions, don't care conditions

⇒

Match the following:

	List I		List II
A.	TTL	1.	Low propagation delay
B.	ECL	2.	Low power consumption
C.	MOS	3.	High packing density
D.	CMOS	4.	Saturated bipolar logic

A-4, B-1, C-3, D-2
A-4, B-3, C-1, D-2
A-4, B-3, C-2, D-1
A-3, B-1, C-4, D-2

⇒ In a BJT amplifier circuit the size of coupling capacitor depends on
lowest frequency
highest frequency
average of lowest and highest frequencies
none of the above

⇒ Which of the following configuration has low thermal stability?
CB
CC
CE
All have identical thermal stability

⇒ A 20 Ω resistor, a 1H inductor and 1μF capacitor are connected in parallel the combination is driven by a unit step current. Under the steady state, source current flows through
inductor
capacitor
resistor
all

⇒ The polar plot for positive frequencies is shown below. The gain margi
- 8.02 dB
6.02 dB
5 dB
none of these

⇒ Kirchoff's laws are applicable to
steady state conditions only
transient conditions only
both steady state and transient condition
both steady state and transient condition but with some constraints

⇒ Flow charts that contain decision sy
represent straight line programs
do not represent straight line programs
all of the above
none of the above

⇒

Assertion (A): Klystron amplifiers use one or more intermediate cavities in addition to buncher and catcher cavity.

Reason (R): When one or more intermediate cavities are used the bandwidth can be increased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For the K map of the given figure the simplified Boolean expressio
AC + A B
A BC + A B C + A B C + AB C
AC + A B + AC
A C + A B + AB

⇒ In spread spectrum technique
a modulated signal is modulated again
a modulated signal is modulated twice again
the power of a modulated signal is increased
the noise component of a modulated signal is decreased

⇒ Energy content of atmospheric noise
does not depend on frequency
decreases as frequency is increased
increases as frequency is increased
either (a) or (c) depending on the temperature

⇒ Which camera tube has highest sensitivity and very wide spectral response?
Vidicon
Plumbicon
New vicon
Saticon

⇒ In a degenerate n type semiconductor material, the Fermi level,
is in valence band
is in conduction band
is at the centre in between valence and conduction bands
is very near valence band

⇒ The upper and lower side frequencies for 3 kHz audio modulation with a 27 MHz carrier frequency will be
30 and 24 MHz
27.3 and 26.7 MHz
27.3 and 26.97 MHz
27.3 and 26.97 MHz

⇒

Assertion (A): Most PCs use static RAM for main memory.

Reason (R): Static RAM is faster than dynamic RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ While calculating Norton's resistance, all current sources are short circuited.
TRUE
FALSE

⇒ Which of the following figures is an ideal equivalent circuit of a n-p-n transis
figure A
figure B
figure C
none

⇒

Assertion (A): The circuit in figure produces repetitive narrow pulses when input is fed with sine or triangular waveform having peak value more than + V

Reason (R): The high gain op-amp produces voltages at two levels. If input is more than + V, the output is + 15 V otherwise the output is - 1
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ When a diode is not conducting, its bias is
forward
zero
reverse
zero or reverse

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
31 v
32 v
insufficient data
none of these

⇒ VSWR = E_max/E_min.
TRUE
FALSE

⇒ Satellite launch sites are invariably located on Eastern seaboards to ensure that
launch takes place eastward
expenditure of propulsion fuel is reduced during plane changing
the satellite achieves circular orbit quickly
spent rocket motor and other launcher debris falls into the sea

⇒ Which of the following is non-saturating?
TTL
CMOS
ECL
Both (a) and (b)

⇒ One of the major applications of JFET is in
switching
constant current-source
constant voltage-source
electron flow regulation

⇒ Which of the following binary product is incorrect?
1100 x 1010 = 1111000
1.01 x 10.1 = 11.001
1100110 x 1000 = 1100110000
None of the above

⇒ An ideal rectifier should have
100% efficiency, zero ripple factor, zero harmonic factor and unity displacement factor
100% efficiency, zero tipple factor, zero harmonic factor and zero displacement factor
100% efficiency, zero ripple factor, unity harmonic factor and unity displacement factor
100% efficiency, unity ripple factor, zero harmonic factor and unity displacement factor

⇒ For the ring oscillator shown in the figure, the propagation delay of each inverter is 100 pico sec. What is the fundamental frequency of the oscillator output _______
10 MHz
100 MHz
1 GHz
2 GHz