Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | A network has 4 nodes and 3 independent loops. What is the number of branches in the network? |

A. | 5 [Wrong Answer] |

B. | 6 [Correct Answer] |

C. | 7 [Wrong Answer] |

D. | 8 [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :Network Said on 2017-04-20 04:24:27No of independent loop= B+N-1 NO OF LOOP EQUCATION =B-N+1 !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ "In any linear bilateral network, if a source of e.m.f. E in any branch produces a current I in any other branch, then same e.m.f. acting in the second branch would produce the same current I in the first branch".

The above statement is associated with

compensation theorem

superposition theorem

reciprocity theorem

none of the above

⇒ Kirchhoff's current law is applicable to only

junction in a network

closed loops in a network

electric circuits

electronic circuits

⇒ Which of the following is an active element in a circuit?

Current source

Resistance.

Inductance.

Capacitance.

⇒ To determine the polarity ofthe voltage drop across a resistor, it is necessary to know

value of current through the resistor

direction of current through the resistor

value of resistor

e.m.fs. in the circuit

⇒ Which of the following is the passive element?

Capacitance

Ideal current source

Ideal voltage source

All of the above

⇒ If the number of branches in a network is 'B', the number of nodes is 'N' and the number of dependent loops is 'L' then the number of independent node equations will be

N + L - 1

B - 1

B - N

N - 1

⇒ The terminals across the source are____ if a current source is to be neglected.

open circuited

short circuited

replaced by a capacitor

replaced by a source resistance

⇒ A practical current source is represented by

a resistance in series with an ideal current source.

a resistance in parallel with an ideal current source.

a resistance in parallel with an ideal voltage source.

none of the above.

⇒ In a series parallel circuit, any two resistances in the same current path must be in

series with each other

parallel with each other

series with the voltage source

parallel with the voltage source

⇒ If a circuit does not contain any source of energy or e.m.f. it is known as

unilateral circuit

bilateral circuit

passive network

active network

⇒ Kirchhoff's voltage law is related to

junction currents

battery e.m.fs

IR drops

both (b) and (e)

⇒ The concept on which Superposition theorem is based is

reciprocity

duality

non-linearity

linearity

⇒ The elements which are not capable of delivering energy by its own are known as

unilateral elements.

nonlinear elements.

passive elements.

active elements

⇒ While determining R

_{TH}of a circuit

voltage and current sources should be left as they are.

all sources should be replaced by their source resistances.

all independent current and voltage sources are shortcircuited

none of the above

⇒ A non-linear network does not satisfy

superposition condition

homogeneity condition

both homogeneity as well as superposition condition

homogeneity, superposition and associative condition

⇒ A, B, C and D represent the transmission parameters of a two-port network. When is the network reciprocal?

AB - CD = 1.

AD - BC = 1.

AB - CD = 0.

AD - BC = 0.

⇒ An ideal voltage source has

zero internal resistance

open circuit voltage equal to the voltage on full load

terminal voltage in proportion to current

terminal voltage in proportion to load

⇒ Superposition theorem is applicable for:

Linear circuits only.

Non-linear circuits only.

Linear and non-linear circuits both.

None of these.

⇒ Ideal current source have

zero internal resistance.

infinite internal resistance.

low value of voltage.

large value of current.

⇒ For high efficiency of transfer of power, internal resistance of the source should be

equal to the load resistance

less than the load resistance

more than the load resistance

none of the above

⇒ A pole of driving point admittance function implies

zero current for a finite value of driving voltage.

zero voltage for a finite value of driving current.

an open circuit condition.

none of(a), (b) and (c) mentioned in the question.

⇒ A capacitor is generally a

bilateral and active component

active, passive, linear and nonlinear component

linear and bilateral component

non-linear and active component

⇒ A human nerve cell has an open-circuit voltage of 80 mV and it can deliver a current of 5 nA through a 6 M ohm load. What is the maximum power available from the cell?

0.16 nW

16 mW

1.6 W

16 pW

⇒ Application of Norton's theorm to a circuit yields

equivalent current source and impedance in series

equivalent current source and impedance in parallel

equivalent impedance

equivalent current source

⇒ A linear resistor having 0 < R < ∞ is a

current controlled resistor

voltage controlled resistor

both current controlled and voltage controlled resistor

none of the above

⇒ Which of the following theorems is applicable for both linear and nonlinear circuits ?

Superposition.

Thevenin's.

Norton's.

None of these.

⇒ The poles and zeroes of an all-pass network are located in which part of the s-plane?

Poles and zeroes are in the right half s-plane.

Poles and zeroes are in the left half s-plane.

Poles in right half and zeroes in left half of s-plane.

Poles in the left half and zeroes in right half of s-plane.

⇒ The first and last critical frequency of an RC-driving point impedance function must respectively be

a zero and a pole

a zero and a zero

a pole and a pole

a pole and a zero

⇒ A network which contains one or more than one source of e.m.f. is known as

linear network

non-linear network

passive network

active network

⇒ A delta circuit has each element of value R/2. The equivalent elements of star circuit with be

R/6

R/3

2R

3R