Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In nodal analysis, if there are N nodes in the circuit, then how many equations will be written to solve the network? |

A. | N - 1. [Correct Answer] |

B. | N + 1. [Wrong Answer] |

C. | N. [Wrong Answer] |

D. | N - 2. [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Kirchhoff's law is not applicable to circuits with

lumped parameters

passive elements

distributed parameters

non-linear resistances

⇒ The poles and zeroes of an all-pass network are located in which part of the s-plane?

Poles and zeroes are in the right half s-plane.

Poles and zeroes are in the left half s-plane.

Poles in right half and zeroes in left half of s-plane.

Poles in the left half and zeroes in right half of s-plane.

⇒ Which of the following is linear and bilateral parameter ?

resistors

semi-conductor diodes

electron tubes

transistor

⇒ Which of the following is not a nonlinear element?

Gas diode

Heater coil

Tunnel diode

Electric arc

⇒ For a voltage source

terminal voltage is always lower than source e.m.f.

terminal voltage cannot be higher than source e.m.f.

the source e.m.f. and terminal voltage are equal

⇒ The theorem that enables a number of voltage (or cuiTent) sources to be combined directly into a single voltage (or current) source is the____ theorem.

compensation

reciprocity

Millman's

Maxwell's

⇒ A network has 10 nodes and 17 branches. The number of d iferent node pair voltage would be

7

9

45

10

⇒ A pole of driving point admittance function implies

zero current for a finite value of driving voltage.

zero voltage for a finite value of driving current.

an open circuit condition.

none of(a), (b) and (c) mentioned in the question.

⇒ Kirchhoff's current law states that

net current flow at the junction is positive

algebraic sum of the currents meeting at the junction is zero

no current can leave the junction without some current entering it.

total sum of currents meeting at the junction is zero

⇒ Millman's theorem yields equivalent

impedance or resistance

current source

voltage source.

voltage or current source

⇒ A network has 4 nodes and 3 independent loops. What is the number of branches in the network?

5

6

7

8

⇒ A voltage source having an open-circuit voltage of 100 V and internal resistance of 50 ω is equivalent to a current source

2 A in parallel with 50 ω.

2 A with 50 ω in series

0.5 A in parallel with 50 ω

A in parallel with 100 ω

⇒ If a circuit does not contain any source of energy or e.m.f. it is known as

unilateral circuit

bilateral circuit

passive network

active network

⇒ In nodal analysis, if there are N nodes in the circuit, then how many equations will be written to solve the network?

N - 1.

N + 1.

N.

N - 2.

⇒ For maximum transfer of power, internal resistance of the source should be

equal to load resistance

less than the load resistance

greater than the load resistance

none of the above

⇒ There are b branches and n nodes the number of equations will be

n - 1

b

b - n

b - n + 1

⇒ The graph of an electrical network has N nodes and B branches. The number of links, L, with respect to the choice of a tree, is given by

B - N + l

B + N

N - B + 1

N - 2B - 1

⇒ A non-linear network does not satisfy

superposition condition

homogeneity condition

both homogeneity as well as superposition condition

homogeneity, superposition and associative condition

⇒ For a voltage source

terminal voltage is equal to the source emf.

terminal voltage cannot exceed source emf.

terminal voltage is always lower than source emf.

terminal voltage is higher than the source emf.

⇒ Millman's theorem yields

equivalent resistance

equivalent impedance

equivalent voltage source

equivalent voltage or current source

⇒ A circuit having neither any energy source nor emf source is called the____ circuit.

unilateral

bilateral

passive

active

⇒ An ideal voltage source should have

large value of emE

small value of e.m.f.

zero source resistance

infinite source resistance

⇒ Which of the following is an active element in a circuit?

Current source

Resistance.

Inductance.

Capacitance.

⇒ Which of the following is non-linear circuit parameter?

Inductance

Condenser

Wire wound resistor

Transistor

⇒ To determine the polarity ofthe voltage drop across a resistor, it is necessary to know

value of current through the resistor

direction of current through the resistor

value of resistor

e.m.fs. in the circuit

⇒ The first and the last critical frequencies (singularities) of a driving point impedance function of a passive network having two kinds of elements, are a pole and a zero respectively. The above property will be satisfied by

RL network only.

RC network only

LC network only

RC as well as RL networks

⇒ Constant voltage source is

active and bilateral.

passive and bilateral

active and unilateral.

passive and unilateral.

⇒ The number of possible ordered trees with 3 nodes A, B, C is

6

8

10

12

⇒ For a linear network containing generators and impedances, the ratio of the voltage to the current produced in other loop is the same as the ratio of voltage and current obtained if the positions of the voltage source and the ammeter measuring the cuiTent are interchanged. The network theorem is known as

Millman's theorem.

Norton's theorem.

Tellegen's theorem.

Reciprocity theorem.

⇒ A linear resistor having 0 < R < ∞ is a

current controlled resistor

voltage controlled resistor

both current controlled and voltage controlled resistor

none of the above