Question is ⇒ A sinusoidal voltage is written as v = Im (R2 + XC2)0.5 sin 314 t. Its peak value and frequency are, Options are ⇒ (A) Im and 50, (B) Im (R2 + X2C)0.5 and 50, (C) 0.707 Im (R2 + X2C)0.5 and 50, (D) 2 Im (R2 + X2C)0.5 and 50, (E) , Leave your comments or Download question paper.

Question is ⇒ A sinusoidal voltage is written as v = Im (R2 + XC2)0.5 sin 314 t. Its peak value and frequency are, Options are ⇒ (A) Im and 50, (B) Im (R2 + X2C)0.5 and 50, (C) 0.707 Im (R2 + X2C)0.5 and 50, (D) 2 Im (R2 + X2C)0.5 and 50, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A sinusoidal voltage is written as v = I_m (R² + X_C²)^0.5 sin 314 t. Its peak value and frequency are
A.	I_m and 50 [Wrong Answer]
B.	I_m (R₂ + X²_C)^0.5 and 50 [Correct Answer]
C.	0.707 I_m (R₂ + X²_C)^0.5 and 50 [Wrong Answer]
D.	2 I_m (R₂ + X²_C)^0.5 and 50 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Two 2's complement number having sign bits X and Y are added and the sign bit of the result is Z. then, the occurrence of overflow is indicated by the Boolean function.
XYZ
X Y Z
X YZ + XY Z
XY + YZ + ZX

⇒ Consider the following statements

Thermistor is more sensitive than platinum resistance thermometer
The resistance of thermistor is solely a function of its absolute temperature whether the source of heat is external or internal
Thermistor has linear temperature-resistance relationship
Thermistor has linear negative temperature coefficient

Of the Statements, the correct statements are
1 and 2
3 and 4
1, 2, 3, 4
1, 2 and 4

⇒ The state equations are in the form
X = AX + BW
X = AX + Bu
X = AX + Bx
either (a) or (b)

⇒ The pole zero diagram of an impedance Z has a pole at s = - 6 and zero at s = - 4 as shown in figure the constant multiplier k = 1. For a signal I_s = cos 6t, the steady state voltage across Z is given in magnitude as u
0.6
0.84
7.2
none

⇒ High speed logic circuits use
pulses with very small width
pulses with very large width
pulses whose width is neither small nor large
either (b) or (c)

⇒ In crystalline solids, atoms are stacked in a regular manner.
TRUE
FALSE

⇒ A constant k low pass filter has f_c = 1000 Hz. At f = 500 Hz, the phase shift is
p
zero
more than p
less than p

⇒ Directivity gain depends on
the distribution of radiated power in space
solid angle of the radiated field pattern
both (a) and (b)
none of the above

⇒ A unit step function is used to represent the closing a switch in a constant voltage system.
TRUE
FALSE

⇒ The colour of an object is decided by
the reflected colour
the wavelength transmitted through it
reflected colour for opaque object and wavelength transmitted through it for transparent objects
none of the above

⇒ DS directive in 8085
forces the assembler to reserve one byte of memory
forces the assembler to reserve a specified number of bytes in the memory
forces the assembler to reserve a specified number of consecutive bytes in the memory
none of the above

⇒ A circular polarizer converts a linearly polarized wave into a circularly polarised wave.
TRUE
FALSE

⇒ The Z inverse of the given Z transfor
Unit step
Unit ramp
Unit impulse
Unit parabola

⇒ In a backward wave oscillator the wave travelling along the line winds itself back and forth
TRUE
FALSE

⇒ When a dc chopper feeds an RLE load, the load current, during steady state operation
remains constant
varies between maximum and minimum values
may remain constant or vary
is constant if R is constant

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC
the faster the time constant of AGC, more accurate the output

⇒ In fi
Wave A is lagging wave B by ∠θ
Wave A is leading wave B by ∠θ
Wave A is lagging wave B by ∠θ and the two waves have same rms values
Wave A is lagging wave B by ∠θ and the two waves have different rms values

⇒ In which mode of circular waveguide does the attenuation continuously decrease as frequency is increased?
TE₀₁
TE₁₁
TE₀₅
TE₂₁

⇒ Which type of fading causes serious distortion of modulated signal?
Selective fading
Interference fading
Absorption fading
Polarization fading

⇒ Which of the following is equivalent to x?
x EX-OR 0
x EX-NOR 0
1 NOR x
x AND x

⇒ As the temperature of a pure silicon specimen is increased
the number of free electrons increases
the number of holes decreases
the number of holes increases
the number of free electrons and holes increases

⇒ Network transients are due to
circuit resistance
circuit voltage
changes in energy stored in L and C
circuit admittance

⇒ A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be
zero or 16 W
4 W or 8 W
zero or 8 W
8 W or 16 W

⇒ A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of load current is
40 A
20 A
0.416666666666667
0.208333333333333

⇒ In a waveguide the dielectric region is generally
air
magnetic material
brass
mica

⇒ In which of the following semiconductor are holes majority carriers
intrinsic
extrinsic
p type
n type

⇒ For the given truth table, the correct Boolean expressio
XYZ + X YZ + X Y Z
X Y Z + XYZ + X YZ
X Y Z + XYZ + XY Z
XYZ + XYZ + XY Z

⇒ Find the value of K and velocity constant K_v so that the maximum overshoot in the unit step response is 0.2 and the peak time is 1
12.37, 0.175
12.86, 2.175
11.36, 1.175
1.86, 0.175

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ If h₁[n] = 3δ[n] + δ[n - 1], h₂[n] = 2δ[n] + δ[n
{6, 18, 7, 4, 0, - 6, 9}
{9, 0, - 6, 21, 7, 6, 1}
{7, - 1, 3, 1, 7, 0, 6}
{9, - 6, 0, 1, 21, 7, 18, 6}